Manual de instrucciones de American Standard 2037.100

Resumen del contenido incluido en la página 1

LEXINGTON 1.6 GPF ONE-PIECE TOILET
INSTALLATION
Model 2037.100 Elongated with Seat
INSTRUCTIONS
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product
is installed properly, please read these instructions carefully before you begin. (Certain installations may require
professional help.) Also be sure your installation conforms to local codes.
!
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CA

Resumen del contenido incluido en la página 2

6 MTG. CLIP COVER BOLT NUT WASHER CLOSET FLANGE INSTALL TOILET a. Position toilet squarely to wall and, with a rocking motion, press bowl down fully on wax ring and flange. Alternately tighten nuts until toilet is firmly seated on floor. ! CAUTION: DO NOT OVERTIGHTEN NUTS OR BASE MAY BE DAMAGED! b. Install caps on washers. (If necessary, cut bolt height to size before installing caps.) c. Smooth off the bead of sealant around base. Remove excess sealant. 7 INSTALL TOILET SEAT Install t

Resumen del contenido incluido en la página 3

ARM TOP 9 10 REFILL NIPPLE TUBE ADJUSTMENTS a. If bowl fails to siphon, an TANK CRITICAL LEVEL LEVER adjustment may be MARK ("C.L.") Fig. 9A MUST BE required with the lift chain. 1" ABOVE OVERFLOW PIPE "S" Simply remove the bead FLOAT CLIP CUP chain from the retainment clip (see Fig. 9A) and FILL VALVE take up slack on the chain, FLUSH and reinsert on lift rod. VALVE WATER LEVEL ADJUSTMENT Make sure the chain is not CLIP LINK too taught. VALVE ADJUSTABLE b. Adjust water le

Resumen del contenido incluido en la página 4

TROUBLESHOOTING 12 IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK SLOWLY, repeat Step 12. IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF NON-USE, it is a signal you are wasting water because: • The end of the refill tube is inserted into overflow pipe, below LIFT ARM LIFT ARM water level in tank. Attach refill tube to overflow pipe using "S" FIRST FIRST clip provided. • The flush valve is leaking because it's worn, dirty or misaligned with tank ball or flapper (replace with a new flapper)