Manual de instrucciones de Toto TMT1HNCR

Resumen del contenido incluido en la página 1

®
INSTALLATION INSTRUCTIONS
Toilet Flushometer Valve TMT1HNCR
Toilet Flushometer Valve TMW1HNCR
Toilet Flushometer Valve TMU1HNCR
LIMITED WARRANTY
TOTO warrants its products to be made of first class materials, free from defects in material or workmanship,
under normal use, and to perform the service for which they are intended in a thoroughly reliable and
efficient manner when properly installed and serviced, for a period of three years from the date of purchase.
During this period TOTO will, a

Resumen del contenido incluido en la página 2

PRIOR TO INSTALLATION IMPORTANT:  ALL PLUMBING IS TO BE INSTALLED IN ACCORDANCE WITH Prior to installing the Piston Flushometer Valve, install the items APPLICABLE CODES AND REGULATIONS. listed below:  WATER SUPPLY LINES MUST BE SIZED TO PROVIDE AN AD- � Closet or urinal fixture EQUATE VOLUME OF WATER FOR EACH FIXTURE.  Drain line  FLUSH ALL WATERLINES PRIOR TO OPERATION.  Water supply line The Piston Valve is designed to operate with water pressure as low as 10psi (69kPa). HOWEVER THE M

Resumen del contenido incluido en la página 3

Hand tighten the spud nut and vacuum breaker tube nut to the fixture and flushometer valve. Align and plumb 5. the valve assembly. Tighten the fixture spud nut, vacuum breaker tube nut, and lock nut with a wrench. Before the water supply is turned on, be sure all 6. stop valves to the flush valves are closed off tightly. The stop valves can be opened and closed by using the adjustment screw located at the center of the stop valve cap G, behind the adjustment screw cover if already installed. Sto

Resumen del contenido incluido en la página 4

Specifications Flush volume: TMT1HNCR – 6.0LPF (1.6GPF) TMW1HNCR – 13.3LPF (3.5GPF) TMU1HNCR – 3.8LPF (1.0GPF) Protect the Chrome or Special finish of the flushometer. DO NOT USE TOOTHED TOOLS TO INSTALL OR SERVICE THE VALVE. Sweat Solder Adapter Installation Instructions Step No. 1 Step No. 2 Step No. 3 Slide threaded adapter onto supply pipe Measure from finished wall to first thread Measure distance from finished wall to center line of until shoulder stops on end of pipe. Then of adapter