Resumen del contenido incluido en la página 1
®
Guardian Easytrack System
Installation
Bath Base Kit Assembly
&
Model 900-0880
Instruction
Manual
Resumen del contenido incluido en la página 2
2 Introduction TABLE OF CONTENTS Introduction .......................................................................................... 2 Important Safeguards.............................................................................. 3 Requirements ......................................................................................... 4 Kit Contents & Part Numbers .................................................................... 5 Assembly of Bath Base Kit ..............................
Resumen del contenido incluido en la página 3
Important Safeguards 3 IMPORTANT SAFEGUARDS Do not operate this equipment without first reading and understanding this manual. Should you be unable to understand the warnings, cautions and instructions, contact our technical support or your local dealer before attempting to use this equipment– otherwise injury or damage may result. Important information is highlighted by these terms: WARNING– Notices as used in the manual apply to hazards or unsafe practices which could result in serious bodily
Resumen del contenido incluido en la página 4
4 Requirements REQUIREMENTS Failure to meet requirements listed below could result in serious bodily harm. Ceiling Requirements • Install to a rigid ceiling (must have a 24" max framework above it). Joists Joists • Must have a maximum of 24" (610mm) between the trusses in the ceiling. Suspended • Ceiling must be made of wood or wire or rods 1/2"(12.7mm) sheet rock or thicker. • Ensure ceiling and floor are clear of Sheet rock Sheet rock or tile any dust, grease, water or any foreign substance.
Resumen del contenido incluido en la página 5
Assembly of Bath Base Kit 5 EASYTRACK BATH BASE KIT KIT CONTENTS & PART NUMBERS (FIGURE 1) Description Part # Qty 1 Bath base rail N/A 1 2 Bath post N/A 1 3 Blue locking handle N/A 1 4 Round blue cap 900-0720 1 5 Allen key 6mm 900-3280 1 6 Top plate 900-0400 1 7Flat blue cap 900-1050 1 8 Blue plastic strips (2/post) 900-0230 2 9 Blue bath base cover N/A 1 ASSEMBLY OF BATH BASE KIT Figure 1 Tools Required: • Step ladder • Tape measure • Scissors or knife • An assistant 1. Take the bath base rail
Resumen del contenido incluido en la página 6
6 Assembly of Bath Base Kit 8. Measure the distance between the post base and the end of the bath base rail. Cut and install the blue bath base cover into the bath base rail by squeezing the sides of the sides of the strip into the edges of the rail (Figure 6). “Click” NOTE– The plastic post base only slides on one end of the bath base. It may be neces- sary to turn the bath base rail around to place the plastic post base in the proper Figure 6 Figure 7 position. 9. Take the bath post and the to
Resumen del contenido incluido en la página 7
A s s e m b l y o f Ba t h Ba s e K i t 7 Make sure clip-on level is fully attached to the post. Failure to attach level properly could give an incorrect reading. Level should “click” into place. 16. Once the bubble is in the center of the clip-on level, continue to tighten ONLY until the red zone at the top of Figure 13-A Figure 13-B the post is no longer visible (Figures 13-A & B). Red zone must not be visible for the post to be safely secure. Do not over-tighten the post. Tighten only until r
Resumen del contenido incluido en la página 8
8 Specifications / Maintenance BATH BRACKET SPECIFICATIONS Item Number ............................900-0880 Weight Capacity ..............440lbs. (200 kg) Length of Base Rail ..................53" - 65" (1350-1650mm) Length of Post.......................67" – 90.5" (1700-2300mm) Post base travel zone.................10" - 24" (250-610mm) Material ...................Anodized Aluminum/ Stainless Steel Weight........................25.5 lbs. (11.5 kg) Ceiling Plate ......................20"
Resumen del contenido incluido en la página 9
Maintenance 9 Before each time you use the Easytrack Bath Base Kit: 1. Clean the outside and inside of the rail and wipe out any water in the rail. Failure to do so for a long period of time can cause corrosion that will weaken the rail. 2. Check with the level if the posts are straight. In they are not straight, remove rail and reinstall posts (see Assembly instructions). 3. Check that the rail is secure in place. Press the rail upwards to make sure that the rail is locked onto the post. 4.
Resumen del contenido incluido en la página 10
10 Easytrack Products & Accessories EASYTRACK PRODUCTS & ACCESSORIES Description Part # Easytrack 2-Post System........................................................................... 92000 Easytrack 3-Post System........................................................................... 93000 Easytrack 4-Post System........................................................................... 94000 Easytrack 2-Post with Tub Bracket ............................................................. 9
Resumen del contenido incluido en la página 11
Warranty 11 WARRANTY This warranty is extended only to the original purchaser/user of Sunrise products. Sunrise Medical Inc. warrants its products to be free from defects in material under normal use and service and will, within the periods stated below, from the date of purchase. If within such warranty period any such product shall be proven to be defective, such product shall be repaired or replaced at Sunrise Medical's option. This warranty does not include any labor or shipping charges
Resumen del contenido incluido en la página 12
Distributed by: Sunrise Medical 7477 East Dry Creek Parkway Longmont, Colorado 80503 (800) 333-4000 In Canada (800) 263-3390 Printed in Canada © 2001 Sunrise Medical 10.01 900-0660 Rev. A
