Manual de instrucciones de Lightolier 1102TM

Resumen del contenido incluido en la página 1

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
INSTRUCTION SHEET NO.
his fMIIre i5 intendedfor installationin accwdama w“hhthe NationalElsctrkal Code and local
)gulations.To assurefullmmplisnoswithIccalCC& snd regulations, checkwithyour!ccsleleclrkd
IS:1102TM
Ispector beforeinstallation. Topreventelectrkalshodr,tumoffelecbidlyatfuseboxbeforepromeding.
Page10f4
DSS2
Retainthese instructionsfor maintenancereference.
I
INSTALLATION OF PRE4WRED COMPACT
‘“
FLUORESCENT EMERGENCY LIGH

Resumen del contenido incluido en la página 2

1s:1I02TM Oaez Page20f4 A. FRAME-IN Featen MOUNTING FRAME to wood joist. Line up bottom edge of ADJUSTABLE MOUNTING BAR with bottom of wood. joist (Fig. 5). Wire to supply ME leads. (For Cable, use built-in Cable Clsmp in J-Box.) NOTf& 1. ADJUSTABLE MOUNTING BARS are pre- assembled on long aide of MOUNTING FRAME for ri idity and ease of installation, FIG. 5 =SW,TCH INDICATOR Fig. 5. The M UNTING BARS must be 8 n?rnoved and installed on narrow side of MOUNTING FRAME if installed between joist on

Resumen del contenido incluido en la página 3

lS:ll~TM oae2 Page 3 of 4 B. CLOSE-IN 1. install plasterboard or other dry tape ceiling, aa required. Hole in board can be cut either on the floor or after the board ie nailed to the ceiling, using MOUNTING FRAME opening es cutting SCREWS guide. (Make sure ROTO CLIPS are roteted out of hole area). f 2. Cut hole in ceiling for SWITCH/lNDICATOR LIGHT BOX in a convenient location to the eide or end of frame (Fig. 9). The recommended hole siza is 2%”x3%’! 3. Close-in ceiling. p UNIT 4. Pull down SWI

Resumen del contenido incluido en la página 4

IS:1102TM Oe3z Page40+4 H. EMERGENCY BAUAST REPLACEMENT Make sure AC power is off at fuse box. (For accessible and non-accessible ceiling.) 1. Remove REFLECTOR TRIM (eee Reflector Trim Instruction Sheet). 2. Remove TRIM PLATE by removing LOCKNUT disconnect UNIT CONNECTOR, Iooeen SCREW on eide of SWITCH BOX and clip SWITCH BOX onto the ceiling (Fig. 11). 3. Loosen THUMB NUT and rotate BRACKET away from EMERGENCY BALLAST ASSEMBLY (Fig. 11). 4. Oetach EMERGENCY SALLAST from the MOUNTING PLATE and p