Resumen del contenido incluido en la página 1
Installation Instructions / Warranty
Metris
31102XX1
Metris
31103XX1
Resumen del contenido incluido en la página 2
Metris Electronic Lavatory Faucet with Temperature Control 31102XX1 Metris Electronic Lavatory Faucet 31103XX1 Technical Data Max. water pressure 116 psi Recommended pressure 14.5 - 72 psi o Max. hot water temp. 158 F* o o Recommended hot water temp. 120 F - 140 F* Flow rate 1.5 gpm @ 44 psi Automatic shutoff after 35 seconds Hole size in mounting surface 1 1/4” Max. mounting surface thickness 1 1/8” Requires standard 110 V electrical outlet** This faucet cannot be used with a continuous flow wa
Resumen del contenido incluido en la página 3
Installation Flush the hot and cold supplies thoroughly before install- ing this faucet. Place the faucet in the hole on the mounting surface (1). Tighten the mounting nut (2). Install the adapters and filters on the stops (3). Install the supply lines (4). Be careful not to twist the supply lines, or they may become loose from the faucet, causing a leak. Connect the transformer to the faucet. Plug the transform- er into the outlet. Use a cable tie to bundle the excess cable. 3
Resumen del contenido incluido en la página 4
Turn the water on to the faucet (1). Peel the protective film from the sensor (2). Wait 15 seconds, the place a hand in front of the sensor (3). The water should turn on automatically. Model 31102 only: Pivot the temperature control lever forward to make the water cooler (4). Model 31103 only: Set the temperature Turn the water off at the stops. Remove the set screw on the back of the faucet. Pull the faucet housing off (1). Use a screwdriver to set the water temperature (2). Turn the scr
Resumen del contenido incluido en la página 5
Cleaning: Block the sensor for 5 seconds (1). This will turn the water off for approximately 90 seconds, so that the sink may be cleaned (2). Faucet Maintenance Reset the faucet: Remove the set screw with a 2.5 mm Allen wrench. Block the sensor for 2 seconds. Wait 10 seconds (1), then replace the set screw (2). 5
Resumen del contenido incluido en la página 6
Wait 15 seconds (3). Place a hand in front of the sensor (4). The water should turn on. Clean the filters and aerator If the flow of water is reduced, the aerator and/or the filters must be cleaned. To clean the aerator: Block the sensor for 5 seconds to temporarily shut off the water (1). Unscrew and remove the vandal resistant aerator using the enclosed key (2). Flush any debris from the aerator at another faucet. Replace the aerator. 6
Resumen del contenido incluido en la página 7
To clean the filters: Turn the water off at the stops. Disconnect the supply hoses from the adapters. Remove and clean the filters. Note: Remove and inspect the check valves yearly. 7
Resumen del contenido incluido en la página 8
Replacement Parts 1 aerator 98612000 2 solenoid valve 98854000 3 fixation set 97812000 4 connection hose 98809000 5 check valve 96456000 6 electronics 96905000 1 7 AC adapter 97690000 8 transformer 97689001 9 8 x 2 o-ring 98112000 Important note: the check valves should be removed and inspected yearly. 9 2 7 6 3 8 4 5 8
Resumen del contenido incluido en la página 9
Cleaning Recommendation for Hansgrohe Products Modern lavatory faucets, kitchen faucets, and showers consist of very different materials to comply with the needs of the market with regard to design and functionality. To avoid damage and returns, it is necessary to consider certain criteria when cleaning. Cleaning Materials for Faucets and Showers Acids are a necessary ingredient of cleaning materials for removing lime, however please pay attention to the following points when cleaning faucet
Resumen del contenido incluido en la página 10
Limited Lifetime Consumer Warranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or Canada. WHO IS COVERED BY THE WARRANTY This warranty extends to the original consumer purchaser only. This warranty is non-transferable. WHAT IS COVERED BY THE WARRANTY This warran
Resumen del contenido incluido en la página 11
give us a reasonable opportunity to correct or cure any failure to comply before you can bring any action in court against us under the Magnuson- Moss Warranty Act. PRODUCT INSTRUCTIONS AND QUESTIONS Upon purchase or prior to installation, please carefully inspect your Hansgrohe product for any damage or visible defect. Prior to installing, always carefully study the enclosed instructions on the proper installation and the care and maintenance of the product. If you have questions at any time
Resumen del contenido incluido en la página 12
Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004 Tel. 770 360-9880 • Fax 770 360 9887 www.hansgrohe-USA.com US - Installation Instructions • Part No. 90590121 • Revised 8/2007
