Manual de instrucciones de Chief Manufacturing FTR Series

Resumen del contenido incluido en la página 1

INSTALLATION INSTRUCTIONS
SMALL FLAT PANEL ADJUSTABLE PITCH
WALL MOUNT
Model: FTR Series
Specifications:
• Designed for installation on single wood studs or
drywall (1/2" minimum thickness); either option
provides ±1/2" lateral shift.
• Weight capacity:
• 45 lbs (20 kg) for wood stud installation
• 30 lbs (14 kg) for drywall installation
• Provides tilt range from 5° up to 15° down.
BEFORE YOU BEGIN
WARNING: It is the installer’s responsibility to make sure all components are properly assem

Resumen del contenido incluido en la página 2

Model: FTR Series Installation Instructions IMPORTANT WARNINGS AND CAUTIONS! WARNING: A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions. CAUTION: A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the corresponding instructions. WARNING: It is the installer’s responsibility to make sure the structure to which this unit is attached can support five times the combined weight of all equipmen

Resumen del contenido incluido en la página 3

Installation Instructions Model: FTR Series TOOLS REQUIRED FOR INSTALLATION PARTS • Drill After unpacking carton, inspect and verify contents (See Figure 1). If any listed parts are missing or damaged, • 1/8" drill bit (wood stud installation) contact Chief Customer Service at 1-800-582-6480. • 3/8" drill bit (drywall installation) • Hammer (drywall installation) • Phillips screwdriver, #2 NOTE: Other tools may be required depending on your Table 1: Parts method of installation. Item Descr

Resumen del contenido incluido en la página 4

Model: FTR Series Installation Instructions INSTALLATION INSTALL MOUNT TO DRYWALL The FTR may be installed on either a single wood stud, or drywall (1/2" minimum thickness). WARNING: Drywall must be 1/2" minimum thickness. Failure to provide adequate structural strength for this INSTALL MOUNT TO SINGLE WOOD STUD unit can result in serious personal injury or damage to 1. Determine approximate mounting location, keeping in equipment! mind the display size. 1. Determine approximate mounti

Resumen del contenido incluido en la página 5

Installation Instructions Model: FTR Series collapsed anchors (20). Tighten until secure (See Figure 4). Button location for 100mm x 100mm pattern (4 places) (20) (4 places) (30) (4 places) Button location for 75mm x 75mm pattern (4 places) NOTE: Display not shown for clarity. Anchor (10) Screw (4 places) Figure 6: Install Display to Plate 3. Close latching flag by rotating flag counterclockwise Figure 4: Installation to Drywall on plate (10) (See Figure 7). NOTE: An optional padlock may b

Resumen del contenido incluido en la página 6

Model: FTR Series Installation Instructions ADJUST TILT 1. Loosen adjusting screws on each side of display (See Figure 8). 2. Adjust tilt as desired. 3. Retighten adjusting screws. Adjusting Screw (other side similar) 5° Tilt Up 15° Tilt Down Figure 8: Tilt Adjustment 6

Resumen del contenido incluido en la página 7

Installation Instructions Model: FTR Series 7

Resumen del contenido incluido en la página 8

Model: FTR Series Installation Instructions 8