Resumen del contenido incluido en la página 1
aaaaaaaaaaaaaaaaaaa aaaaaaaaaaaaaaaaaaaaaaaaaa
®
Sensaphone
ISACC
Operator’s
Manual
version 3.49
aaaaaaaaaaaaaaaaaaa aaaaaaaaaaaaaaaaaaaaaaaaaa
Resumen del contenido incluido en la página 2
Every effort has been made to ensure that the information in this document is complete, accurate and up-to-date. Phonetics, Inc. assumes no responsibility for the results of errors beyond its control. Phonetics, Inc. also cannot guarantee that changes in equipment made by other manufacturers, and referred to in this manual, will not affect the applicability of the information in this manual. © 1997 by Phonetics, Inc. Version 3.49, September, 2000. Written and produced by Phonetics, Inc. Please a
Resumen del contenido incluido en la página 3
SAFETY INSTRUCTIONS aaaaaaaaaaaaaaaaaaa aaaaaaaaaaaaaaaaaaaaaaaaaa IMPORTANT SAFETY INSTRUCTIONS Your ISACC has been carefully designed to give you years of safe, reliable performance. As with all electrical equipment, however, there are a few basic precautions you should take to avoid hurting yourself or damaging the unit: • Read the installation and operating instructions in this manual carefully. Be sure to save it for future reference. • Read and follow all warning and instruction labels on
Resumen del contenido incluido en la página 4
To Reduce the Risk of Fire or Injury to Persons, Read and Follow these Instructions: 1. Use only the following type and size batteries: 6V 3.0AH sealed lead-acid rechargable 2. Do not dispose of the batteries in a fire. The cell may explode. Check with local codes for possible special disposal instructions. 3. Do not open or mutilate the batteries. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed. 4. Exercise care in handling batteries in o
Resumen del contenido incluido en la página 5
Table of Contents TABLE OF CONTENTS aaaaaaaaaaaaaaaaaaa aaaaaaaaaaaaaaaaaaaaaaaaaa ISACC MANUAL 3.4.9 SAFETY INSTRUCTIONS ........................................................................ 3 IMPORTANT SAFETY INSTRUCTIONS................................................................................3 CHAPTER 1: INTRODUCTION .............................................................. 9 PROGRAMMING ISACC .....................................................................................
Resumen del contenido incluido en la página 6
® Sensaphone ISACC Instruction Manual PHONE LINE INSTALLATION ........................................................................................... 19 FCC REQUIREMENTS ........................................................................................................ 20 CANADIAN DEPARTMENT OF COMMUNICATIONS NOTICE......................................... 21 CHAPTER 3: COMMUNICATION SETUP ............................................. 23 SETUP FOR PC ....................................
Resumen del contenido incluido en la página 7
Table of Contents CHAPTER 7: PROGRAMMING ............................................................. 53 KEYWORDS....................................................................................................................... 53 SYSTEM ............................................................................................................................. 54 CLOCK .........................................................................................................................
Resumen del contenido incluido en la página 8
® Sensaphone ISACC Instruction Manual INPUT ............................................................................................................................... 94 IS_ALARM ......................................................................................................................... 95 NETWORK.........................................................................................................................96 OUTPUT......................................................
Resumen del contenido incluido en la página 9
Chapter 1: Introduction CHAPTER 1 aaaaaaaaaaaaaaaaaaa aaaaaaaaaaaaaaaaaaaaaaaaaa INTRODUCTION ISACC is a unique device that puts monitoring, alarm, and control capabilities all in one system. It can monitor equipment and environmental conditions using 16 universal inputs. In addition, these inputs can be programmed to switch up to 8 digital outputs and four analog outputs in any combination. Along with control, ISACC offers comprehensive communication. When an alarm occurs, ISACC can dial up
Resumen del contenido incluido en la página 10
® Sensaphone ISACC Instruction Manual IMPORTANT! Phonetics now includes a software package to work with ISACC using the Windows operating system, it is called ISACC MANAGER for Windows and it will work with Windows 3.x, 95 and NT. This software makes ISACC even easier to use, and even more powerful. Some of ISACC MANAGER’s features include: AUTOMATIC POLLING - ISACCs can be polled on a programmable schedule to retrieve the data logger. INFORMATION MANAGEMENT - The PC can store and maintain all
Resumen del contenido incluido en la página 11
Chapter 2: Installation CHAPTER 2 aaaaaaaaaaaaaaaaaaa aaaaaaaaaaaaaaaaaaaaaaaaaa INSTALLATION This chapter explains the unpacking and installation of ISACC, both the complete package (FGD-5000) and the board level product (FGD-5100). The complete package system is mounted in a NEMA-4 ABS plastic enclosure with 18 VDC rechargeable battery backup. The board-level unit is provided with a mounting kit so that you can mount the system properly in another enclosure, etc. It is important that this
Resumen del contenido incluido en la página 12
® Sensaphone ISACC Instruction Manual OPERATING ENVIRONMENT ISACC should be mounted and operated in a clean, dry environment. If this is not possible, NEMA 4 conduit hubs should be installed to seal ISACC off from the hazardous environment. The temperature range that ISACC can operate in is 32°F to 120°F (0°C to 49°C). MOUNTING ISACC When you receive ISACC, there will be a PC Board (ISACC) mounted inside an ABS plastic enclosure rated at NEMA 4, 4X, 12 and 13. You will also find the ISACC Inst
Resumen del contenido incluido en la página 13
Chapter 2: Installation top plate clamp screw bottom plate clear rubber bushing wiring Strain relief clamp POWERING ISACC IMPORTANT: Before applying power to ISACC, the ON-OFF switch must be in the OFF position. The ON-OFF switch is located to the right of the acrylic panel, below the power supply terminal block. ISACC is pre-wired with a three prong cord that can be plugged into any 117VAC outlet. The power supply specification for the ISACC circuit board is 20 to 24 Volts AC, 50 or 60 Hz.
Resumen del contenido incluido en la página 14
® Sensaphone ISACC Instruction Manual LITHIUM BATTERY The lithium battery provides backup to the RAM and to the real-time clock, it's function is to retain the time and programming if the power fails and backup battery is exhausted. On the circuit board, the lithium battery is located under the acrylic safety panel on the right side. To activate the battery, pull the paper strip out of the battery clip. The lithium battery is a CR2430, 3 Volts, 270 mAhr. It will provide battery backup for ap
Resumen del contenido incluido en la página 15
Chapter 2: Installation BOARD LEVEL INSTALLATION (FGD-5100) This section explains the unpacking and installation of a board level ISACC. For installation instructions of a complete package ISACC (FGD-5000), turn to page 11. It is important that this chapter be read and followed very carefully before operating ISACC. UNPACKING ISACC ISACC is shipped in specially designed packaging to eliminate damage during shipment. When unpacking the unit, be careful not to damage the equipment or the box.
Resumen del contenido incluido en la página 16
® Sensaphone ISACC Instruction Manual 7.5" phone receptacle RS232 port Mounting ISACC circuit board After the holes have been drilled, mount the board with the hardware provided. Use a nylon washer between the board and the screw, and a nylon spacer between the board and mounting surface. Both wood screws and machine screws have been provided for your convenience. POWERING ISACC IMPORTANT: Before applying power to ISACC, the ON-OFF switch must be in the OFF position. The ON-OFF switch is l
Resumen del contenido incluido en la página 17
POWER POWER EG 24 24 BAT C 20V C 15V C 12V C 5V C AC AC EG 24 24 BAT C 20V C 15V C 12V C 5V C AC AC Chapter 2: Installation primary secondary 20 - 24 VAC 120 VAC 1.5 A supply transformer Wiring an AC power supply to ISACC DC supply requirements: 1. The voltage range for powering ISACC is 24 to 28VDC. If the voltage is lower than 24VDC, the batteries will not fully charge. If the voltage is over 28VDC, excess heat will be generated in the power supply and components may fail. 2. The DC
Resumen del contenido incluido en la página 18
® Sensaphone ISACC Instruction Manual GROUNDING ISACC ISACC should be earth grounded by connecting a true earth ground to the terminal labeled EG. This is not essential for ISACC to operate, but this will help protect against the possible effects of lightning strikes in or around the immediate area. BACKUP BATTERY ISACC offers the ability to wire a backup battery to the power terminal block. The backup battery can be a rechargeable or non-rechargeable 18VDC. To hook up your backup battery, wi
Resumen del contenido incluido en la página 19
Chapter 2: Installation TURNING ISACC ON Now that ISACC has power, the ON-OFF switch may be turned on. ISACC’s buzzer will sound briefly. The “power” LED will come on and be constant and the “pulse” LED will blink steadily. The “phone” LED will not be lit. When the unit is turned off, it is disabled. Programming parameters are retained by the 3V lithium battery. In the off position, the 3V lithium battery is in use, however 18V battery backup is not. RESET BUTTON Under the acrylic safety p
Resumen del contenido incluido en la página 20
® Sensaphone ISACC Instruction Manual FCC REQUIREMENTS PART 68 - This equipment complies with Part 68 of the FCC rules. On the acrylic panel there is a label that contains, among other information, the FCC Registration Number and the Ringer Equivalenzce Number (REN) for this equipment. You must, upon request, provide this informa- tion to your local telephone company. The REN is useful to determine the quantity of devices that you may connect to your telephone line and still have all of those
