Manual de instrucciones de Pelco SS4722

Resumen del contenido incluido en la página 1

®
SS4718/SS4718L/SS4722/SS4722L
Sun Shroud and
TI47 Thermal Insulation
Installation/Operation Manual
C1409M-C (7/98)
1.0 WARNINGS Prior to installation and use of this product, the following WARNINGS should be
observed.
1. Installation and servicing should only be done by qualified service personnel
and conform to all local codes.
2. Only use replacement parts recommended by Pelco.
Please thoroughly familiarize yourself with the information in this manual prior to
installation and operation.
2.

Resumen del contenido incluido en la página 2

3.0 INSTALLATION 3.1 SS4718/SS4722/ The sun shroud is supplied with two (2) threaded spacers and two (2) Phillips head SS4718L/SS4722L screws. SUN SHROUDS To install the sun shroud, perform the following steps (refer to Figure 1). 1. Unlatch and raise enclosure lid. 2. Remove the two (2) screws, nylon washers, nuts and lock washers from the lid of the enclosure. 3. Attach the threaded spacers to the under side of the sun shroud with the two (2) screws and nylon washers previously removed, thr

Resumen del contenido incluido en la página 3

3.2.2 Body Insulation 1. Remove the long, 1.5-inch wide, strip of insulation for the side panel from the Installation lid insulation pad. 2. To adjust the length of the insulation pad (or the side panel), tear the insulation along the perforations from the end(s) of the pad to fit either the 18-inch ver- ® sion or the Legacy version of the enclosure. 3. Position the pad around the press nuts in the center of the body by folding the pad along its length. Position the insulation punch-out(s) to cl

Resumen del contenido incluido en la página 4

4.0 WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on FT/FR8000 Series fiber optic products. ® • Three years on Genex Series products (multiplexers, server, and keyboard). ® • Three years on Camclosure and fixed camera models, except the CC3701H-2, CC3701H-2X, CC3751H-2, CC3651H-2X, M