Manual de instrucciones de Pelco HK700

Resumen del contenido incluido en la página 1

C2412M (11/99)
BK700 Series Blower Kit
HK700 Series Heater Kit
®
3500 Pelco Way IMPORTANT SAFEGUARDS AND WARNINGS
Clovis, CA 93612-5699
Prior to installation and use of this product, the following WARNINGS should be observed.
USA
1. Installation and servicing should only be done by qualified service personnel and conform
In North America & Canada:
to all local codes.
Tel (800) 289-9100
FAX (800) 289-9150
2. Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X ,6 or 6P
Internati

Resumen del contenido incluido en la página 2

Table A. Power Requirements and Recommended Cable Sizes (Continued) Model Number Imput Voltage Power Consumption Cable Size Cable Distance BK700/200 230 VAC 9 watts 20 AWG 25,609 feet (7,805 m) 18 AWG 40,495 feet (12,342 m) 16 AWG 64,328 feet (19,606 m) 14 AWG 102,239 feet (31,161 m) HK706-1 120 VAC 80 watts 20 AWG 533 feet (162 m) 18 AWG 857 feet (261 m) 16 AWG 1,355 feet (413 m) 14 AWG 2,153 feet (656 m) HK706-2 24 VAC 80 watts 20 AWG 34 feet (10 m) 18 AWG 54 feet (17 m) 16 AWG 86 feet (26 m)

Resumen del contenido incluido en la página 3

Heater Kit If you are installing the heater kit in conjunc- tion with a blower kit, skip this section and refer to Blower and Heater Kits (Dual Installation). Perform the following steps to complete the heater kit installation: 1. Attach the PC board assembly onto the brackets that are attached to the rear of the camera sled (refer to Figure 3). 2. Attach the heater assembly onto the front of the camera sled (refer to Figure 3

Resumen del contenido incluido en la página 4

Blower and Heater Kits (Dual Installation) 1. a. BK700 and BK700/24 - Remove the PC board from the heater assembly. Attach board to the top bracket of the blower assembly. b. BK700/220 - The blower and heater assemblies are both factory assembled with a PC board. Only one PC board assembly is required. Remove the PC board from the blower assembly and replace it with the PC board from the heater assembly. 2. Attach the PC board and blower assembly onto the brackets that are attached to the rear o