Manual de instrucciones de Bosch Appliances MX938I

Resumen del contenido incluido en la página 1

2.0 Control Panel Programming
Installation Instructions
Refer to the multiplex programming section of your Control Panel
for the MX938i
Reference Guide for information on programming multiplex zones
Ceiling Mount Multiplex
for this device.
PIR Intrusion Detector
3.0 Mounting
1.0 Specifications
Avoid
• Input Power: Connects directly to the Multiplex Bus of the
Control Panel and optionally to an auxiliary
12 VDC source.
Moisture
Moving objects
 Current Draw:
Mounting Outdoors
2-Wire:
Direc

Resumen del contenido incluido en la página 2

Hint: Mounting to removable ceiling tiles is not recommended 5.2 Sensitivity Mode unless a sandwich is made of the base, ceiling tile and a  Standard Sensitivity: Recommended setting for Standard back plate behind the tile. Covers used for four-inch H maximum false alarm immunity. Tolerates octagonal and square boxes make a suitable back plate I environment extremes on this setting, but requires the S (when used with bolts and wing nuts, as an example). largest amount of intruder motion to ach

Resumen del contenido incluido en la página 3

= SWITCH ON = SWITCH ON = SWITCH ON = SWITCH ON (CLOSED) (CLOSED) (CLOSED) (CLOSED) ZONE ZONE ZONE ZONE (POINT) (POINT) (POINT) (POINT) SWITCH NUMBER SWITCH NUMBER SWITCH NUMBER SWITCH NUMBER ADDRESS ADDRESS ADDRESS ADDRESS 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 001 065 129 193 002 066 130 194 003 067 131 195 004 068 132 196 005 069 133 197 006 070 134 198 007 071 135 199 008 072 136 200 009 073 137 201 010 074 138 202 011 075 139 203 012 076 140 204 013 077 141 205 014

Resumen del contenido incluido en la página 4

7.0 Setup and Walk Testing 8.0 Maintenance  The range and coverage should be checked in accordance with Before walk testing, the system should be fully wired, the Walk Testing section (6.0) on a regular basis. powered, and programmed. IMPORTANT  Consult the Control Panel’s User's Guide for the procedure on performing a zone test. Performing a zone test on a regular  Configure LED Configuration Switch (S1) to LED ON. basis assures an alarm output prior to arming the system.  Replace the fron