Manual de instrucciones de Bosch Appliances LTC9316

Resumen del contenido incluido en la página 1

LTC9316/00P
Security Systems
Installation Manual
Standard Pole
EN

Resumen del contenido incluido en la página 2

LTC9316/00P Instruction Manual Introduction EN 2 Table of Contents 1 DESCRIPTION 2 2 UNPACKING 2 3 SERVICE 2 4 4 INSTALLATION 3 4.1 Site Preparation 3 4.2. Installation 3 4.3 Mounting the AutoDome™ 4 4 INSTALLATION 1 DESCRIPTION This installation should be made by qualifi ed service personnel and The LTC 9316/00P units are 16 foot steel mounting poles for conform to the National Electrical Code and applicable local codes. use with Unity® Domes, AutoDomes®, an

Resumen del contenido incluido en la página 3

LTC9316/00P Instruction Manual Installation 3 EN 7.778 24" 6" 4X O 1.000 BASED ON A 11.00" B.C. 6" 36" 13.0007.778 4.000 32" 24" 24" O 11.000 4.000 O 3.000 13.000 24" 32" Figure 3 Anchor Bolt Dimensions 36" PV4 Anchor jig (if applicable) NOTE: Prepare the concrete per manufacturer's directions. The concrete must have a compressive ! 8" 8" strength of 3000 psi, and must be fabricated following ACI318-89 requirements. Allow the concrete foundation to cure thoroughly before proceeding with 1

Resumen del contenido incluido en la página 4

LTC9316/00P Instruction Manual Installation 4 EN Access opening plates Bolts or anchor jig Figure 7 Lifting the Pole into Position CAUTION: Pull all slack in the wiring as you lift the pole into position to keep from pinching and possible damage. Pad Figure 5 Placement of Pole on Pad 6. Ensure that the pole is vertical on all sides. Use a bubble level or plumb bob to check. 3. Insert the wiring into the 3" diameter hole in the base of the pole. Be

Resumen del contenido incluido en la página 5

Mount the LTC 9540/xx Wall Bracket Using Adapter Plate These Holes Figure 9 Aligning Adapter Plate with Mounting Plate Figure 11 Mounting the LTC 9540/xx Wall Bracket 5 SPARE PARTS 2. Attach the LTC 9540/xx Wall Bracket adapter plate, using the provided hex head nuts and bolts, flat washers, and Part No. Description lockwashers (see Figure 10). LTC9316AP LTC 9540/xx Wall Arm Adapter Plate Lockwashers Flat Washers 5/16-18 Nuts Figure 10 Attaching the Adapter Plate 3. Attach the LTC 9

Resumen del contenido incluido en la página 6

Bosch Security Systems, Inc. Robert Bosch GmbH Bosch Security Systems B.V. 850 Greenfield Road Geschäftsbereich P.O. Box 80002 Lancaster, PA 17601 EE.UU. Postfach 10 60 50 5600 JB Eindhoven Tel: 800-326-3270 70049 Stuttgart The Netherlands Fax: 1-717-735-6560 Telefax (0711) 811-12 34 Tele +31 40 27 80000 www.boschsecuritysystems.com © 2005 Bosch Security Systems GmbH 3935 890 38012 28 June Data subject to change without notice.