Resumen del contenido incluido en la página 1
®
NavTalk
GSM Phone/GPS
owner’s
manual
and
reference
guide
Resumen del contenido incluido en la página 2
© Copyright 2002 GARMIN Ltd. or its subsidiaries GARMIN International, Inc. st 1200 East 151 Street, Olathe, Kansas 66062, U.S.A. Tel. 913/397.8200 or 800/800.1020 Fax 913/397.8282 GARMIN (Europe) Ltd. Unit 5, The Quadrangle, Abbey Park Industrial Estate, Romsey, SO51 9DL, U.K. Tel. 44/0870-8501241 Fax 44/0870-8501251 GARMIN Corporation nd No. 68, Jangshu 2 Road, Shijr, Taipei County, Taiwan Tel. 886/2.2642.9199 Fax 886/2.2642.9099 All rights reserved. Except as expressly provided herein, no
Resumen del contenido incluido en la página 3
Section 1 Thank you for choosing the GARMIN NavTalk GSM Phone/GPS. This Introduction product is designed for easy operation and to provide years of reliable service. Please take the time to read this Owner’s Manual, and learn the opera- Customer Service tion of your new phone. This will help ensure that you get the most from Product Registration the unit. Help us better support you by completing our If you encounter a problem, or just have a question, contact our on-line registration today
Resumen del contenido incluido en la página 4
Section 1 IN NO EVENT SHALL GARMIN BE LIABLE FOR ANY INCI- DENTAL, SPECIAL, INDIRECT OR CONSEQUENTIAL DAMAGES, Introduction WHETHER RESULTING FROM THE USE, MISUSE, OR INABILITY TO USE THIS PRODUCT OR FROM DEFECTS IN THE PRODUCT. Some states do not allow the exclusion of incidental or consequential Limited Warranty damages, so the above limitations may not apply to you. This GARMIN product is warranted to be free GARMIN retains the exclusive right to repair or replace the u
Resumen del contenido incluido en la página 5
Section 1 Exposure to Radio Frequency Signals - Your wireless hand-held portable telephone is a low power radio transmitter and receiver. When Introduction it is ON, it receives and also sends out radio frequency (RF) signals. The NavTalk GSM Wireless Telephone/GPS Receiver meets compliance require- ments for maximum Specific Absorption Rate of radio wave emissions for Warnings and Precautions the limit given. If you have any reason to suspect that interfer- ence is taking place, turn y
Resumen del contenido incluido en la página 6
Section 1 Driving - Check the regulations on the use of wireless telephones in the areas where you drive. Always obey them. Also, if using Introduction your phone while driving, give full attention to driving. Driving safely is your first responsibility. Pull off the road and park before making or answering a call if driving conditions so require. Warnings and Precautions Potentially Explosive Atmospheres - Turn your phone Vehicles - RF signals may affect improperly installed or inad- OFF
Resumen del contenido incluido en la página 7
Section 1 Map Data Information - One of our goals is to provide cus- tomers with the most complete and accurate cartography that Introduction is available to us at a reasonable cost. We use a combination of governmental and private data sources that we identify as required in product literature and copyright messages displayed Warnings and Precautions to the consumer. Virtually all data sources contain inaccurate or incomplete data to some degree. This is particularly true European Union D
Resumen del contenido incluido en la página 8
Section 1 Using the Standby Feature....................................................... 8 How the Operating System is Structured................................. 9 Introduction Entering Data ...................................................................10-11 The Main Menu................................................................12-24 The Phone Tab ..............................................................12-16 Table of Contents The GPS Tab ...................................
Resumen del contenido incluido en la página 9
Section 1 SECTION 3: Phone Operation (cont.) Message Inbox....................................................................38 Introduction Read Messages....................................................................38 Using Numbers and Websites in Messages ..........................39 Message Drafts....................................................................40 Table of Contents Sent Messages.....................................................................40 Templates...
Resumen del contenido incluido en la página 10
Section 1 Many of the features of the NavTalk GSM are dependent on services Introduction provided by the network used to provide wireless phone service. When- ever these features are discussed in this manual, a Network/Subscription icon (like the one shown to the left) will be located at the beginning of the Network Service Provider paragraph describing how the feature functions. Information If your network service provider offers these features, they may be provided as a standa
Resumen del contenido incluido en la página 11
Section 2 Battery Installation and Charging The unit is powered by a Lithium Ion rechargeable battery located on Getting Started the back of the unit. The battery does not require removal from the unit for recharging. Charging at “Start Up” may require up to three hours. The Battery Installation battery is already installed on the unit, but must be removed in order to Back of Unit remove the insulating strip from the contacts on the battery which prevents Press down on the release tab to
Resumen del contenido incluido en la página 12
Section 2 Subscriber Identity Module (SIM) Card Installation The SIM card (supplied by your cellular service provider) is a “Smart Getting Started Card” that includes your phone number, memory for storing phone num- bers, messages, and service information. You can use your SIM card in any SIM Card Installation GSM phone and you will be charged for the call. The SIM card should be kept secure. Do not bend, scratch, expose to static electricity, or water as Place this side face down wi
Resumen del contenido incluido en la página 13
Section 2 Remote Earpiece/Microphone Connection Getting Started Service Status Indicator (LED) Wireless Phone Antenna Volume UP/Zoom OUT key Using the Keypad Press and Hold to increase earpiece volume or to zoom out on the map Built-in GPS Antenna page to show more map area with less detail. Press and Release to move POWER key by increments. Press and Release to turn the unit ON. Press and Hold to turn the unit Off. Press and Release while the unit Volume DOWN/Zoom IN is On to display t
Resumen del contenido incluido en la página 14
Section 2 Turning the Unit On and Off 1. Press and hold the POWER key for more than two seconds. Getting Started A Welcome page will display and if no PIN security is active, then move to the Main Menu when GPS is Off. If there is no SIM card installed an “Insert SIM” message will display. Turn Off the unit and install the Turning the Unit On/Off SIM card as explained previously. A “SIM Not Ready” message may Unit Power Key also appear if you try to dial immediately
Resumen del contenido incluido en la página 15
Section 2 Activating the Backlight Feature 1. Press and release any key to turn on the Backlight. The Backlight will Getting Started remain on for the amount of time set. Default is 10 seconds. A small illuminated light bulb will appear in the Status Bar at the top of the screen. Press and release the POWER key to display the Contrast/Back Activating the Backlight light settings window (see page 4). Press and Release the 2. To select from “Always On”, “Timeout”, or “Always Off”
Resumen del contenido incluido en la página 16
Section 2 Understanding the Status Bar The Status Bar at the top of the display screen provides a constant Getting Started indicator of unit function. From left-to-right, the Status Bar displays the wireless phone signal strength, the current status of your phone call (in- call active, In Call Encrypted, In call Mute, Incoming Call and No Service), current messages In Call status (indicating SMS, Info Messages, Voice Mail, and Position Reports), whether or Messages Backlight On GPS sta
Resumen del contenido incluido en la página 17
Section 2 Using the ‘Quick Set’ Feature The Quick Set feature allows you to quickly activate some basic opera- Getting Started tional characteristics of your unit such as Keyguard, Profiles (unit ringer volume and call answer modes), GPS On/Off, and Mark Waypoint features. Using the Keyguard Feature Using the ‘Quick Set’ Feature The ‘Keyguard’ feature allows you to lock the keypad to prevent inadvertent pressing of a key while the unit is in your pocket, purse, etc. ‘Mark Waypoint’ This prev
Resumen del contenido incluido en la página 18
Section 2 Using the Profiles Feature The Profiles feature allow you to determine quickly, the mode in Getting Started which the phone portion of the unit will operate when a call is received according to the environment in which you are currently located with- Using Profi les out the need to manually adjust volume and feature settings. Use the ARROW keys to highlight your choice and press ENTER to activate. Profile options are: • Normal - settings you desire for regular use of the unit.
Resumen del contenido incluido en la página 19
Section 2 Understanding the Operating Software Structure The Main Menu is the display that you see when the Welcome Page Getting Started and PIN Entry prompt are completed. It also is displayed whenever you press and release the MENU or END key, when not on an active call. How the Operating System is It consists of four tabbed pages and is the starting point for access Structured to most of the NavTalk’s Features. Each tabbed page consists of a Main Menu with listing of featur
Resumen del contenido incluido en la página 20
Section 2 Data Fields and Data Entry Techniques Nearly every feature page contains a data field (a page item that Getting Started can be highlighted using the ARROW key and modified as desired). There are two methods for entering data in a field: Entering Data Selecting Data from a list Many data fields contain an options menu with a list of choices. To use Options Lists 1. Highlight the data fi eld and press the ENTER key to display the menu. 2. Use the ARROW key to highlight your
