Manual de instrucciones de Genie AR85

Resumen del contenido incluido en la página 1

Before getting started, you will need your
Thank you for purchasing the One Fo r Al l
original garage door opener transmitter.
Wireless Universal Garage Remote. Your
You will use the original transmitter during
One For All Wireless Universal Garage
the setup of the GDK. If you do not have
Remote (referred to as GDK throughout
your original transmitter, please refer to the
the rest of the
“WHAT TO DO IF YOUR ORIGINAL
operate most garage door openers as well
TRANSMITTER HAS TWO OR THREE
as most g

Resumen del contenido incluido en la página 2

5. Enter the PIN you wrote down in B STE P 1 then press ENTER. The GDK w ill emit a double-ticking sound to prompt you to confirm your new 10 BI T S/300 I password. Now reenter the PIN and AMBASSADOR P s ENTER again. If MULTI EL MAC 1. Slide open the cov er. The GDK’s w me PIN c orrectly, the green keypad will illuminate. LED will illuminate for three seconds LINEAR followed by two beeps. The GDK will 2. Press the number 9 eight times, then DELTA then power OFF. s ENTER, the G DK will beep o

Resumen del contenido incluido en la página 3

5. Press ENTER. Th e will now If you own a Genie AR85 Garage Door 2. Reach the motor head unit and Opener, do not set LED number 9 in the w be lit according to how you placed remove the plastic cover. Find the UP position (ON). e match your original garage door unit. The button should have an LED If you own a Genie AR90 Garage Door (Light Emitting Diode) next to it. Opener, do not set more than eight E N TER again to store your code. 3. After setting the manufacturer’s code, (out of 12) in th

Resumen del contenido incluido en la página 4

2. Slide the GDK onto the screw, see figure 6. Figure 6 After you have stored your garage door opener(s) security codes in the memor y e u nit n your garage door: If your original transmitter has two or three buttons and uses DIP switches, set th e 1 # f 1. PIN LED in the GDK to the opposite position w cover is already open, press on the first DIP switch of your original ey in your PIN, the n transmitter. Set the remaining GD K s ENTER. The GDK will beep. to the exact same position of your or

Resumen del contenido incluido en la página 5

The user is cautioned that changes and This equipment has been tested and found modifications made to the equipment to comply with the limits for a class B without the approval of the manufacturer digital device, pursuant to part 15 of the FCC Rules. These limits are designed to could void the user’s authority to operate provide reasonable protection against this equipment. harmful interference in a residential installation. This equipment generates, FCC Authorization Label uses and radiates rad