Manual de instrucciones de Harbor Freight Tools 96328

Resumen del contenido incluido en la página 1

garage door
threshold
Model 96326 - 8’
Model 96327 - 10’
Model 96328 - 16’
installation instructions
Adhesive shown is not included.
Diagrams within this manual may not be drawn proportionally.
Due to continuing improvements, actual product may differ slightly from the product described herein.
®
distributed exclusively by harbor Freight t ools .
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
read this material before using this product.
F

Resumen del contenido incluido en la página 2

sa Ve this Manual Keep this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures. Write the product’s serial number in the back of the manual near the assembly diagram (or month and year of purchase if product has no number). Keep this manual and the receipt in a safe and dry place for future reference. general and speciFic saFety rules Warning! read all instructions . Failure to follow all instructions listed below may res

Resumen del contenido incluido en la página 3

unpacking When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible. asseMbly There is no assembly required for this Garage Threshold. installation instructions read the entire iMportant saFety inForMation section at the beginning of this manual including all text under subheadings therein before set up or use of this product. Fitting and

Resumen del contenido incluido en la página 4

5. With the garage door still in the raised position remove the Threshold. Apply two 1/4” rows of adhesive (not included) between the two lines running parallel the length of the garage door opening. Apply the adhesive lines 3/4” from the front and back edge of the Threshold. 6. Using the adhesive (not included) make a zig-zag line from the front adhesive line to the back adhesive line and run this zig-zag line the entire length of the two lines. 7. Follow the adhesive (not included) labe