Manual de instrucciones de Razor E100

Manual de instrucciones del aparato Razor E100

Aparato: Razor E100
Categoría: Juegos
Fabricante: Razor
Tamaño: 1.86 MB
Fecha de añadido: 6/13/2014
Número de páginas: 24
Imprimir el manual

Descargar

¿Cómo se utiliza?

Nuestro propósito es proporcionarte el acceso más rápido posible a los contenidos incluidos en los manuales de instrucciones del aparato Razor E100. Utilizando la vista previa online, puedes ver rápidamente el índice de contenidos y pasar a la página donde encontrarás la solución a tu problema con Razor E100.

Para tu comodidad

Si ver los manuales de instrucción de Razor E100 directamente en esta página no es cómodo para ti, puedes utilizar dos soluciones posibles:

  • Vista en pantalla completa – Para ver cómodamente los manuales de instrucciones (sin descargarlos en tu ordenador) puedes utilizar el modo de vista en pantalla completa. Para activar la vista del manual Razor E100 en pantalla completa, utiliza el botón Pantalla completa
  • Descargar al ordenador – también puedes descargar el manual de instrucciones de Razor E100 a tu ordenador y guardarlo en tu colección. Sin embargo, si no quieres ocupar espacio en tu dispositivo, siempre podrás descargarlo de ManualsBase.
Razor E100 Manual de instrucciones - Online PDF
Advertisement
« Page 1 of 24 »
Advertisement
Versión impresa

Muchas personas prefieren no leer el documento en la pantalla, sino en versión impresa. La opción de impresión también está prevista y puedes utilizarla haciendo clic en el enlace más arriba - Imprimir el manual. No tienes que imprimir el manual completo de Razor E100, solo las páginas que elijas. Ahorra papel.

Resúmenes

A continuación encontrarás resúmenes de los contenidos incluidos en las páginas posteriores del manual de instrucciones para Razor E100. Puedes utilizarlos si quieres ver rápidamente el contenido que se encuentra en la siguientes páginas del manual.

Resúmenes de contenidos
Resumen del contenido incluido en la página 1

O’renw s Mlauna
Read and understand this entire manual before riding!
DO NOT RETURN TO STORE!
NOTE: E100/125/150 must be traveling
Item Numbers
3mph before motor will engage. Kick start to
E100 13100E-BL
E125 13125E-BK Black
3mph then twist the throttle to start motor.
13111110 Red
E150 13111612
E200 13200E-SL
E200S 13201S-SL
E225S 13112850
E300 13300E-SL
E300S 13301S-SL
E325S 13116390

Resumen del contenido incluido en la página 2

CONTENTS Safety Warnings ............................................................ 1 Troubleshooting Guide ............................................ 11-12 Before You Begin ........................................................... 2 E100, E150, E200 and E300 Scooter Parts ............ 13-20 Assembly and Set-Up ................................................. 3-4 Safety Reminders .......................................... Back Cover Repair and Maintenance ..............................

Resumen del contenido incluido en la página 3

BEFORE YOU BEGIN Remove contents from box. Remove the foam separators that protect the components from damage during WARNING: shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have DO NOT USE NON- occurred during shipping. Because the scooter was 95 percent assembled and packed at the factory, there RAZOR PRODUCTS WITH should not be any problems, even if the box has a few scars or dents. YOUR RAZOR ELECTRIC SCOOTER. The scoot

Resumen del contenido incluido en la página 4

ASSEMBLYA ND SET-UP q Charging the Battery WARNING: Always Your electric scooter may not have a fully charged battery. Therefore it is a good idea to charge the battery disconnect your scooter from prior to use. the charger before cleaning with • Initial charge time: 12 hours • Run time: up to 40 minutes liquid. • Recharge time: up to 8 hours, • Average battery life: 250 charge/discharge cycles Battery should be recharged Note: If your charger does not a minimum

Resumen del contenido incluido en la página 5

ASSEMBLYA ND SET-UP q Adjusting the Handlebar Height (E100/E200/E300 only) WARNING: Failure to properly engage the quick- release clamp may cause the T-tube to move up or down while riding, which may cause you to lose control and fall. With the quick-release properly adjusted and engaged, the handlebars will not move up or down. Note: Be careful not to over- 1 Pull the quick-release lever 2 Slide the T-tube to the 3 The tension of the quick- tighten. You should be ab

Resumen del contenido incluido en la página 6

REPAIRA ND MAINTENANCE q Inflating the Tires Tires are inflated when shipped, but they invariably lose some pressure between the point of manufacturing and your purchase. WARNING: Failure E150 / E200 / E300 Rear Tire to remove the valve adapter after inflating will cause the inner tube and/or adapter to be severed by the rear drive sprocket. Note: If you lose the adapter, a valve stem extender can be purchased at almost any auto parts store. 1 Use the special valve 2

Resumen del contenido incluido en la página 7

REPAIRA ND MAINTENANCE q Adjusting the Chain Tools required: 10mm wrench, two (2) 8mm wrenches, and two (2) 17mm wrenches. Note: This system of adjusters is common to motorcycles and BMX bicycles. If you are not familiar with it or do not feel comfortable performing the ad- justment, consult an authorized Razor service center or a quali- fied BMX bike or motorcycle mechanic. The chain should be “just taut” 1 Using two 17mm wrenches, 2 Using two 8mm wrenches, 3 Using a 10mm wr

Resumen del contenido incluido en la página 8

REPAIRA ND MAINTENANCE q Chain and Rear Tire Replacement Tools required: Phillips screwdriver, 10mm wrench, two (2) 8mm wrenches, and two (2) 17mm wrenches. 1 With a Phillips screwdriver, 2 With a 10mm wrench, 3 With two 8mm wrenches, loosen the two screws and loosen the brake cable anchor loosen brake housing anchor remove the chain guard. and disconnect the cable. and disconnect. Keep the spacer and washers together. 4 With a 10mm wrench, loosen 5 With two 17mm wrenches,

Resumen del contenido incluido en la página 9

REPAIRA ND MAINTENANCE 10 Install the axle adjusters 11 Tighten both axle adjust- 12 Tighten the brake housing and axle nuts. Tighten until they ers the same number of turns anchor securely. Test ride and just barely hold the hardware to fine-tune the tension on the check. Readjust as needed. in place. chain and to approximately maintain the centering of the wheel. 13 Replace the chain guard. 8

Resumen del contenido incluido en la página 10

REPAIRA ND MAINTENANCE q Front Tire Replacement Tools required: 10mm wrench, two (2) 17mm wrenches and a flathead screwdriver. 1 (E100 only, other 2 Using two 17mm wrenches, 3 Remove wheel and replace models go to Step 2) loosen the front axle bolts by tire. To reinstall wheel, reverse turning the wrenches counter these steps. Helpful hint: You Loosen the brake pad bolt and remove one brake pad. clockwise. may need to use a flathead screwdriver to center the axil and the bo

Resumen del contenido incluido en la página 11

REPAIRA ND MAINTENANCE WARNING: If a q Battery Care and Disposal battery leak develops, avoid Do not store the battery in temperatures above 75° or below -10° F. contact with the leaking acid and place the damaged battery CONTAINS SEALED LEAD BATTERY. BATTERY MUST BE RECYCLED. in a plastic bag. Refer to the disposal instructions at left. If Disposal: Your Razor product uses sealed lead-acid batteries which must be recycled or disposed of in acid comes into

Resumen del contenido incluido en la página 12

TROUBLESHOOTING GUIDE Problem Possible Cause Solution Scooter does not run Undercharged battery Charge the battery. A new battery should have been charged for at least 12 hours before using the scooter for the first time and up to 8 hours after each subsequent use. Check all connectors. Make sure the charger connector is tightly plugged into the charging port, and that the charger is plugged into the wall. Charger is not working Make sure power flow to the wall outlet is on. Loose

Resumen del contenido incluido en la página 13

TROUBLESHOOTING GUIDE Problem Possible Cause Solution Refer to adjusting the brakes instructions on page 4. Sometimes the scooter Brakes are not adjusted properly doesn’t run, but other Check all wires around the motors and all connectors to make sure times it does Loose wires or connectors they are tight. Charger gets warm Motor or electrical switch Contact your local Razor authorized service center for diagnosis and repair. during use damage No action required. This is normal for s

Resumen del contenido incluido en la página 14

E100P ARTS Keep your scooter running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifications subject to change without notice.) 10 Front caliper brake 01 Handlebar grip (right/left) 02 Single speed twist grip throttle 11 Battery tray 02-1 Sleeve 12 On/ Off switch 13 Charger port w/ wires 03 Handlebar stem/ T-bar 14 Reset button w/ wire 03-1 Black folding knob 03-2 6mm stem bolt 15 Control module 16 Battery (2- 12V/

Resumen del contenido incluido en la página 15

E100P ARTS 14

Resumen del contenido incluido en la página 16

E150P ARTS Keep your scooter running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifications subject to change without notice.) 09 Front wheel complete 01 Handlebar grip (right/left) 10 Battery tray 01-1 Valve stem extender/ inflator 11 On/ Off switch 01-2 Handlebar end cap/ Extender holder 02 Brake lever assemble complete 12 Reset button w/ wire 03 Handlebar stem/ T-bar 13 Charger port w/ wires 14 Control module

Resumen del contenido incluido en la página 17

E150P ARTS 16

Resumen del contenido incluido en la página 18

E200P ARTS Keep your scooter running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifications subject to change without notice.) 01 Handlebar Grip (right/left) 11 Front wheel complete 12 Battery tray 01-1 Valve stem extender/ inflator 13 Reset button w/ wire 01-2 Handlebar end cap, Extender holder 02 Speed controller w/ LEDs 14 On/ Off switch 02-1 Sleeve 15 Charger port w/ wires 16 Control module 03 T-bar 17 Motor

Resumen del contenido incluido en la página 19

E200P ARTS Only used on E200S 18

Resumen del contenido incluido en la página 20

E300P ARTS Keep your scooter running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifications subject to change without notice.) 01 Handlebar grips (right/left) 09 Front wheel complete 10 Battery tray 01-1 Valve stem extender/ inflator 11 Reset button 01-2 Handlebar end cap, Extender holder 02 Single speed twist grip throttle 12 On/ off switch 02-1 Sleeve 13 Charger port w/ wires 14 Control module 03 Handlebar Stem/


Manuales de instrucciones similares
# Manual de instrucciones Categoría Descargar
1 Razor E300s Manual de instrucciones Juegos 144
2 Razor E325S Manual de instrucciones Juegos 2
3 Razor E125 Manual de instrucciones Juegos 6
4 Razor E200s Manual de instrucciones Juegos 6
5 Razor E225S Manual de instrucciones Juegos 5
6 Razor E100 Manual de instrucciones Moto para minusválidos 9
7 Razor E100 Manual de instrucciones Scooter 71
8 Sony 168 Manual de instrucciones Juegos 2
9 Sony ERS-7M2 Manual de instrucciones Juegos 1
10 Aiphone MK-DVF-HD Manual de instrucciones Juegos 4
11 Canon BJ/BJ139 Manual de instrucciones Juegos 1
12 Canon BJ/BJ148 Manual de instrucciones Juegos 1
13 Canon BJ/HY014 Manual de instrucciones Juegos 1
14 Canon BJ/BJ182 Manual de instrucciones Juegos 1
15 Canon BJ/BJ194 Manual de instrucciones Juegos 0