Manual de instrucciones de Edelbrock Yamaha 9339

Resumen del contenido incluido en la página 1

5. Install gasket and manifold onto engine
INSTRUCTION SUPPLEMENT FOR
using four (4) M6.1X1” flange head
2001-LATER YAMAHA RAPTOR
screws supplies in kit. See Fig 2.

Figure 2.
Removing stock carburetor and cables


1. Make sure fuel petcock is in “off”
position. Remove seat, front
fenders and fuel tank.
2. Remove throttle cables paying
close attention to routing, as the
new cables will need too be routed
the same.
3. Remove stock carburetors.
4. Remove stock manifolds and air

Resumen del contenido incluido en la página 2

there should be approx. 1/8” of free play in the throttle. 6. After throttle cables have been adjusted the handle bars should be rotated from full right stop to full left stop while opening and closing throttle to ensure smooth operation. Also check to make sure the cables do not catch or bind on anything, i.e., hand guards, stabilizers. 7. Connect crank vent line to the plastic elbow on upper left side of the plenum. 8. Install remote idle cable into threaded tab on top of