Manual de instrucciones de Edelbrock 641570

Resumen del contenido incluido en la página 1

FIREWALL FORWARD FUEL LINE KITS
For 1996-2000 Honda Civic Equipped with B-Series Engine
Catalog #641570, 641573
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with common tools and
procedures. However, you should be familiar with and comfortable working on your vehicle. If you do not feel comfortable performing this installation,
it is recommended to have the installation completed by a qualified mech

Resumen del contenido incluido en la página 2

BEFORE BEGINNING INSTALLATION BEFORE BEGINNING: Someone who has a basic knowledge of automobile repair and modification and is familiar with and comfortable with working on their vehicle can accomplish the mechanical installation of this kit using common tools and procedures. However, this kit is designed to allow you to custom fit the fuel lines to your application, and will require that you cut hoses to fit and drill holes for Fuel Pressure Regulator mounting. If you do not feel comfortable wi

Resumen del contenido incluido en la página 3

Adjusting Screw. Locknut and Washer Vacuum Fitting Figure 4 - Regulator Mounted on Firewall -6 AN Block Off Plug 6. Install the factory fuel pressure regulator vacuum line onto the fitting on the fuel pressure regulator. You may need to replace or extend -6 AN Dry- this line, depending on where you are mounting the regulator. Sump Fittings FUEL LINE AND HOSE END PREPARATION: 1. Measure the -6AN hose and determine the lengths needed to reach Figure 2 - Fuel Pressure Regulator Fitting Placement f

Resumen del contenido incluido en la página 4

5. Determine the length of -4AN (Twist-Lok or Pro-Classic) hose required to reach from the fuel pressure regulator to the factory steel fuel return line. Measure and cut the hose making sure the hose will not be kinked after installation. 6. Slip the -4AN Twist-Lok hose end cover over the Twist-Lok Hose. The tapered end of the cover should face away from the end of the hose. Insert the -4AN Twist-Lok hose end into this end of the line and slide the hose end cover up to the hose end. For Proclass

Resumen del contenido incluido en la página 5

NOTES Catalog #641570, 641573 ©2007 Edelbrock Corporation Rev. 5/07 - RS/mc Page 5 Brochure #63-641570

Resumen del contenido incluido en la página 6

® Russell Performance • A Division of Edelbrock Corporation 2700 California St. � Torrance, CA 90503 Tech-Line: 1-800-416-8628 � E-Mail: Edelbrock@Edelbrock.com Catalog #641570, 641573 ©2007 Edelbrock Corporation Rev. 5/07 - RS/mc Page 6 Brochure #63-641570