Manual de instrucciones de Edelbrock 352-428

Resumen del contenido incluido en la página 1

Performer RPM
Camshaft/Lifters/Lube Kit
CATALOG #7106
MODEL: 352-428 c.i.d. Ford V8
• PLEASE study these instructions carefully before installing your new camshaft. If you have any questions or problems, do not
hesitate to call our Technical Hotline at: 1-800-416-8628.
• CAMSHAFT: Edelbrock Performer RPM camshafts are ground specifically for use with the corresponding Performer RPM
manifold. The Performer manifold #7105, and Performer RPM camshaft #7106, are designed to work as a team to give y

Resumen del contenido incluido en la página 2

• VALVESPRINGS CAUTION: • INSTALLING PUSHRODS AND ROCKER ARMS WARNINGS ABOUT YOUR WARRANTY After the cam is installed and timed correctly (see Figure 1), it In order for this Performer RPM cam and lifter kit to be will be necessary to check each pushrod for correct lifter covered under ANY WARRANTY you MUST use the correct pre-load. Edelbrock Sure Seat Valve Springs. Failure to install new • VALVE ADJUSTMENT Edelbrock valve springs with your new Performer RPM cam 1. Install intake manifold using

Resumen del contenido incluido en la página 3

IMPORTANT INSTRUCTIONS all installations. The following procedure is only a guideline AFFECTING YOUR WARRANTY and in many cases, the manufacturing specifications for recommended carburetors or timing may be best. • CAM LOBE WEAR- Cam lobe wear is almost non-existent unless mismatched parts are used or installation of the cam • CARBURETION AND IGNITION TIMING and lifters is done improperly. Most cam damage is caused by Best carburetor results were with the Edelbrock Performer the timing gear comi

Resumen del contenido incluido en la página 4

CAMSHAFT: Performer RPM Hydraulic CAMSHAFT: Performer RPM Hydraulic CATALOG #7106 CATALOG #7106 ENGINE: Ford 352-428 c.i.d. V8 ENGINE: Ford 352-428 c.i.d. V8 (1963-1/2 and later) (1963-1/2 and later) RPM RANGE: 1500-6500 RPM RANGE: 1500-6500 CAUTION: Do not use dual valve springs.Use only recom- CAUTION: Do not use dual valve springs.Use only recom- mended Edelbrock Sure Seat Valve Springs #5767. Use stock mended Edelbrock Sure Seat Valve Springs #5767. Use stock ratio rocker arms only (1.76:1)