Resumen del contenido incluido en la página 1
Electronic Air Cleaner
Model Number Model Number
Model Number Model Number Model Number
SST
SST1000 SST1000 SST1000
SST1000 SST1000
SST1400 SST1400 SST1400
SST1400 SST1400
SST1600 SST1600 SST1600
SST1600 SST1600
SST2000 SST2000 SST2000
SST2000 SST2000
OWNER’S MANUAL OWNER’S MANUAL
OWNER’S MANUAL OWNER’S MANUAL OWNER’S MANUAL
Installation Installation Installation Installation Installation
Operation Operation Operation
Operation Operation
Basic SST Service Guide Basic SS
Resumen del contenido incluido en la página 2
RULES FOR SAFE RULES FOR SAFE RULES FOR SAFE RULES FOR SAFE RULES FOR SAFE 1. Read the Owners Manual and the Rules for Safe INSTALLATION AND OPERATION INSTALLATION AND OPERATION INSTALLATION AND OPERATION INSTALLATION AND OPERATION INSTALLATION AND OPERATION Operation carefully. Failure to follow these rules and instructions could cause a malfunction of filter or Please read instructions before installing and using the Elec- unsatisfactory service. tronic Air Cleaner. This will help you obtain t
Resumen del contenido incluido en la página 3
AB C HOW THE AIR CLEANER WORKS HOW THE AIR CLEANER WORKS HOW THE AIR CLEANER WORKS HOW THE AIR CLEANER WORKS HOW THE AIR CLEANER WORKS Dirt particles flowing through the ducts (Figure 1) first enters Dirty Air In Clean Air Out the pre-filters (A) where large particles (hair, lint, etc.) are trapped. Smaller particles (smoke, dust, pollen, etc.) pass through these pre-filters and enter the ionizing section (B). Here each tiny particle receives a positive electrical charge. These charged particles
Resumen del contenido incluido en la página 4
PREINSTALLATION PREINSTALLATION PREINSTALLATION PREINSTALLATION PREINSTALLATION Not to Exceed 20 (Interchangeable) (Interchangeable) Air Flow Collecting Cell Collecting Cell Outlet Box Cabinet Power Pack Handle Air Flow Furnace Opening Electronic Air Cleaner Contact Opening Button Contact Furnace Electronic Pre-Filters Transition Section Button Air Cleaner (Interchangeable) See text for Cell (if Needed) Removal Clearance Figure 3 Figure 4 LOCATING THE AIR FILTER LOCATING THE AIR FILTER LOCATING
Resumen del contenido incluido en la página 5
TYPICAL MOUNTING POSITIONS TYPICAL MOUNTING POSITIONS TYPICAL MOUNTING POSITIONS TYPICAL MOUNTING POSITIONS TYPICAL MOUNTING POSITIONS Air Flow Air Flow Air Flow Rear View Rear View Figure 6 Figure 8 Figure 7 BASEMENT FURNACE BASEMENT FURNACE BASEMENT FURNACE BASEMENT FURNACE BASEMENT FURNACE HIGHBOY FURNACE HIGHBOY FURNACE HIGHBOY FURNACE HIGHBOY FURNACE HIGHBOY FURNACE (LOWBOY) (Figure 6) (LOWBOY) (Figure 6) (LOWBOY) (Figure 6) (LOWBOY) (Figure 6) (LOWBOY) (Figure 6) (Figure 8) (Figure 8) (Fig
Resumen del contenido incluido en la página 6
INSTALLATION INSTALLATION INSTALLATION INSTALLATION INSTALLATION REMOVE OLD FILTER AND DISCARD REMOVE OLD FILTER AND DISCARD REMOVE OLD FILTER AND DISCARD REMOVE OLD FILTER AND DISCARD REMOVE OLD FILTER AND DISCARD (Figure 12) (Figure 12) (Figure 12) (Figure 12) (Figure 12) NOTE: This filter may be mounted in the furnace compart- ment. CLEAN BLOWER COMPARTMENT CLEAN BLOWER COMPARTMENT CLEAN BLOWER COMPARTMENT CLEAN BLOWER COMPARTMENT CLEAN BLOWER COMPARTMENT It is suggested that the furnace blow
Resumen del contenido incluido en la página 7
WIRING INSTRUCTIONS WIRING INSTRUCTIONS WIRING INSTRUCTIONS WIRING INSTRUCTIONS WIRING INSTRUCTIONS 7. With the cabinet installed, the air cleaner can now be 10. With the cabinet Installed, reinstall pre-filter(s) and wired to electrical input source. collecting cell(s) (Figure 19). NOTE: The contact button and handles on the cell must be facing you and ionizing wires must be on the ! WARNING air intake side. Installation of this unit must comply with local Installation of this unit must comply
Resumen del contenido incluido en la página 8
OPERATION OPERATION OPERATION OPERATION OPERATION 1. With the 120 VAC power turned on at the circuit breaker for the furnace, push the air cleaner ON-OFF switch to the “ON” position (Figure 20). 2. With the furnace blower running, the air cleaner will be operating. An arcing or “snapping” sound may be heard. This will occur occasionally, however the unit is operating properly. 3. With the furnace blower running, the Operating Light should be ON. If the Operating Light is not ON this signifies th
Resumen del contenido incluido en la página 9
REPLACING AN IONIZING WIRE REPLACING AN IONIZING WIRE REPLACING AN IONIZING WIRE REPLACING AN IONIZING WIRE REPLACING AN IONIZING WIRE If an ionizing wire should break, it can be replaced as follows: 1. Remove all pieces of broken wire. Make sure sup- ports at each end are in good condition and not bent out of shape. 2. Hook the new wire onto the support at one end. 3. Hold your finger against the support at the other end (Figure 21) and hold the ionizing wire between thumb and forefinger as sho
Resumen del contenido incluido en la página 10
BASIC SST SERVICE GUIDE BASIC SST SERVICE GUIDE BASIC SST SERVICE GUIDE BASIC SST SERVICE GUIDE BASIC SST SERVICE GUIDE This guide will cover most homeowner complaints. If, after checking the items listed, the unit still fails to operate properly, contact the nearest Authorized Service Center. SERVICE INDICATION SERVICE INDICATION SERVICE INDICATION SERVICE CHECKS SERVICE CHECKS SERVICE CHECKS SERVICE INDICATION SERVICE INDICATION SERVICE CHECKS SERVICE CHECKS ON/OFF switch “ON” Unit functioning
Resumen del contenido incluido en la página 11
Wht Blu Blk Wht TECHNICAL REPAIR GUIDE TECHNICAL REPAIR GUIDE TECHNICAL REPAIR GUIDE TECHNICAL REPAIR GUIDE TECHNICAL REPAIR GUIDE All voltage measurements indicated can be made with a ! WARNING high voltage D.C. probe and a general purpose volt ohm Do not attempt repair of this unit unless you are Do not attempt repair of this unit unless you are Do not attempt repair of this unit unless you are Do not attempt repair of this unit unless you are Do not attempt repair of this unit unless you are
Resumen del contenido incluido en la página 12
4. Using a standard extension cord, apply 120 VAC to POWER SUPPLY POWER SUPPLY POWER SUPPLY POWER SUPPLY POWER SUPPLY power pack. Turn power switch to “ON” position. CHECKOUT PROCEDURE CHECKOUT PROCEDURE CHECKOUT PROCEDURE CHECKOUT PROCEDURE CHECKOUT PROCEDURE 5. Connect meter negative (-) lead to metal frame of 1. Turn power switch to the “OFF” position and remove collecting cell. Use high voltage probe to measure the power pack from cabinet. voltage at collecting cell ionizer or cell plates. V
Resumen del contenido incluido en la página 13
OZONE REDUCTION OZONE REDUCTION OZONE REDUCTION OZONE REDUCTION OZONE REDUCTION All electronic air cleaners typically produce a small amount of ozone that is within established limits. Some customers may notice an odor especially at high altitudes or low air flow rates. W1 This power supply has a “hairpin” shaped jumper Cut and separate wire labeled W1 (see Fig 24) that can be cut and Ozone Reduction separated in case of such complaints. This will Jumper cause the power supply to limit the maxim
Resumen del contenido incluido en la página 14
REPAIR PARTS REPAIR PARTS REPAIR PARTS REPAIR PARTS REPAIR PARTS 5 6 4 1 5 2 3 7 2 3 9 8 13 10 18 11 12 5 14 14
Resumen del contenido incluido en la página 15
REPAIR PARTS REPAIR PARTS REPAIR PARTS REPAIR PARTS REPAIR PARTS PARTS LIST FOR ELECTRONIC AIR CLEANERS When ordering repair parts, always give the following information as shown in this list. 1. The PART NUMBER 2. The PART DESCRIPTION 3. The MODEL NUMBER 4. The NAME OF ITEM - Electronic Air Cleaner. Always order by “PART NUMBER” . . . Not by “ITEM NUMBER” Always order by “PART NUMBER” . . . Not by “ITEM NUMBER” Always order by “PART NUMBER” . . . Not by “ITEM NUMBER” Always order by “PART NU
Resumen del contenido incluido en la página 16
WASH REMINDER SCHEDULE WASH REMINDER SCHEDULE WASH REMINDER SCHEDULE WASH REMINDER SCHEDULE WASH REMINDER SCHEDULE frequent washing may be necessary on some installa- A regular washing schedule is necessary to ensure tions where there is new carpeting, plaster dust or exces- proper efficiency. A thorough washing once every month sive cigarette smoke, etc. (See page 8 for maintenance will be adequate for most installations. More or Less and instructions on how to clean a cell.) Year JAN FEB MAR A
