Manual de instrucciones de PYLE Audio PWLB006

Resumen del contenido incluido en la página 1

Step Step 4 4
Carefully position monitor so that Wall and
1
Monitor Plates are vertically aligned, with the
bottom of Monitor plate overlapping the top of
the Wall Plate by approximately 1”.
Gently lower monitor into position, sliding the
two plates together until the Monitor Plate 2
Flat Panel Fixed Mount
bottoms out. (Fig. 3)
INSTALLATION GUIDE
Caution: Caution: Make sure that the plates are engaged
3
onbothsidesofthe mountbeforereleasinggrip
on monitor.
Fig 3
Item Item No.:P No.:PWLB006 WLB00

Resumen del contenido incluido en la página 2

Parts: Step Step 2 2 Letter Qty Description 1 2 1 1 Monitor Plate W Wooden ooden Stud Stud Mounting: Mounting: Using an electronic stud finder, locate the center of the wooden stud. 2 1 Wall Plate Position the Wall Plate (2) in desired mounting location over stud. 3 2 M5x10 Safety bolt Level the Wall Plate with a bubble level, and then using the wall plate A 4 M4x8 bolt as a template, mark mounting hole locations over the center of the stud. B 4 M4x12 bolt Drill 2 mounting holes 50mm deep, into