Manual de instrucciones de Crimestopper Security Products SV-9155

Resumen del contenido incluido en la página 1

SV- 9155


4.2” Replacement


Rear View Mirror


Monitor





INSTALLATION INSTRUCTIONS:

The SV-9155 is a replacement Rear View Mirror. It replaces your factory mirror and adds the
convenience of a 4.2” LCD screen which can be used for a reverse and an external DVD
source. The Reverse Camera Input will automatically switch on when the vehicle is dropped into
reverse. The SV-9155 can be hooked up to any SecurView™ or PlateCam™ camera.

FEATURES:

• Replacement

Resumen del contenido incluido en la página 2

INSTALLATION INSTALLATION PRECAUTIONS: 1. Secure the mirror tightly to the windshield so that it can not become loose under any circumstances (Sudden braking, accidents, etc) and cause injuries to the occupants of the vehicle. 2. Do not install the mirror in an area that is in close proximity with an airbag, as this could cause injury if the airbags are deployed. 3. Make sure to connect the mirror to the correct voltage. Failure to do so may result in damage to the mirror or injur

Resumen del contenido incluido en la página 3

Remove Silver Lug Remove Screw BRACKET ADJUSTMENT Adjustable Mounting Bracket Windshield SV-9155 Mirror Mounting Screw NOTE Cable Mounting Bracket of SV-9155 should slide over the factory mounting plate on windshield SIDE VIEW MIRROR MOUNTING

Resumen del contenido incluido en la página 4

WIRING: 1. Choose a convenient place to run the cable either down the left side or right side A-Pillar of the vehicle. (The left side is usually the easier side) 2. Remove the trim panel from the A-Pillar and route the cable down the pillar to the dash board. 3. In most vehicles, there will be a wire harness for the dome light inside the A-Pillar of the vehicle. Use a wire tie or electrical tape to secure the cable to this wire harness. 4. Re-Install the trim panel. Make sure that t

Resumen del contenido incluido en la página 5

MONITOR CONTROLS Menu CAM Select / _ + MONITOR CONTROLS: 1. CAM SEL / This button combines two function. Press this button to toggle between the VI and V2 Inputs. Press and hold it for 2 seconds to turn off the power to the monitor. This will put the monitor into “Standby” mode. Press it again to turn the power back on. 2. MENU • CONTRAST CONTROL: To adjust the contrast of the screen, Press the “MENU” button and then select CONTRAST on the screen. Use the

Resumen del contenido incluido en la página 6

OPERATION & GENERAL MAINTENANCE OPERATION: • When the Ignition key is turned to the Accessory or ON position, +12V power is supplied to the mirror. The front LED light will turn on solid RED in color. No Image will be displayed on the monitor. Press the “CAM SEL / “ button to activate the video inputs. Or simply shift the vehicle into reverse to engage the reverse camera. • If your vehicle has been parked in direct sun light, this can result in a considerable rise in temperat