Resumen del contenido incluido en la página 1
LT-Z32/26SX4B/S / LCT1732-002A / All Cover
LT-Z32&26SX4BS_Eng.book Page 1 Monday, September 6, 2004 10:30 AM
ENGLISH
LT-Z32SX4B
LT-Z26SX4B
LT-Z32SX4S
LT-Z26SX4S
INSTRUCTIONS
WIDE LCD PANEL TV
LCT1732-002A
Cover01
Resumen del contenido incluido en la página 2
ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book Page 1 Monday, September 6, 2004 10:30 AM Thank you for buying this JVC LCD flat television. To make sure you understand how to use your new TV, please read this manual thoroughly before you begin. (“LCD” stands for Liquid Crystal Display.) WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. WARNING • Fingers may be trapped under the TV causing injuries. Hold the TV at the botto
Resumen del contenido incluido en la página 3
ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book Page 2 Monday, September 6, 2004 10:30 AM Pixel defects LCDs use collections of fine points (“pixels”) to display images. While there is no problem with more than 99.99% of these pixels, please understand that a very small number of pixels may not light, or may light all the time. Distance recommendations Avoid improper installation and never position the unit where good ventilation is impossible. 200 mm 200 mm 150 mm
Resumen del contenido incluido en la página 4
ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book Page 3 Monday, September 6, 2004 10:30 AM Cleaning the screen The screen is coated with a special thin film to reduce reflection. If this film is damaged, uneven colours, discolouration, scratches, and other problems that cannot be repaired may occur. Pay attention to the following when handling the screen. • Do not use glue or adhesive tape on the screen. • Do not write on the screen. • Do not allow the screen to com
Resumen del contenido incluido en la página 5
ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book Page 4 Monday, September 6, 2004 10:30 AM CONTENTS Setting up your TV ...................................5 PICTURE menu ...................................... 25 Installation.................................................. 5 PICTURE MODE...................................... 25 Using the stand.......................................... 5 BACK LIGHT............................................ 25 Removing the terminal cov
Resumen del contenido incluido en la página 6
ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book Page 5 Monday, September 6, 2004 10:30 AM Setting up your TV • When you install the TV on the wall, only use a JVC wall mounting unit (optional) which is designed for this TV. • Make sure that the TV is installed on the wall by a skilled installer. Installation Cautions for installation • Install the TV in a corner on a wall or on the floor so as to keep cords out of the way. • The TV will generate a slight amount of he
Resumen del contenido incluido en la página 7
ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book Page 6 Monday, September 6, 2004 10:30 AM Setting up your TV Cable holder A cable holder which is used to keep the connection cables tidy is attached to the back of the stand. Gently squeeze the left and right of the cable holder and pull it to remove it from the stand. After putting the cables in the cable holder, attach it to the back of the stand again. cable holder Removing the terminal covers There are connect
Resumen del contenido incluido en la página 8
ENGLISH IN LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book Page 7 Monday, September 6, 2004 10:30 AM Setting up your TV Connecting the aerial and video cassette recorder (VCR) without terminal covers Caution • Turn off all the equipment including the TV before connecting anything. • Aerial cable is not supplied. Use a good quality 75-ohm coaxial cable. • Read the manual that came with the VCR IN before connecting. If not connecting a VCR (follow 1): Connect an aerial cabl
Resumen del contenido incluido en la página 9
ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book Page 8 Monday, September 6, 2004 10:30 AM Setting up your TV Connecting the power cord to Initial settings (Setup tour) the AC outlet When the TV is first turned on, it goes into the initial settings mode, and you will see the Insert the AC plug on the power cord from JVC logo. Follow the instructions on the the TV into AC outlet. screen display to make the initial settings. Caution • Operate only from the power sour
Resumen del contenido incluido en la página 10
ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book Page 9 Monday, September 6, 2004 10:30 AM Setting up your TV • If the JVC logo does not appear this is 5 Press the 6 buttons to choose a because your TV has already been group. Then press the a button turned on for the first time: The AUTO PROGRAM function starts. use the “LANGUAGE”, “TELETEXT The TV channels you receive are LANGUAGE” and “AUTO automatically stored in the programme PROGRAM” functions to make the
Resumen del contenido incluido en la página 11
ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book Page 10 Monday, September 6, 2004 10:30 AM TV buttons and functions Turn the TV on from standby 1 mode Press the A button or the CHANNEL p buttons to turn the TV on from standby mode. When the TV is turned on, the power lamp lights blue. To turn the TV off: Press the A button again. The power lamp goes off. 2 Caution •The A button on the TV does not fully isolate the TV from the AC supply. If you are not going to u
Resumen del contenido incluido en la página 12
ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book Page 11 Monday, September 6, 2004 10:30 AM Remote control buttons and functions 1 Muting button 2 Number buttons 31 button 4c button 1 ~ 52 button 64 button ! 77 buttons 85 button 2 96 p buttons 0 VCR/DVD/Teletext control buttons -p buttons =d (Favourite) button ~# (Standby) button 3 @ ! PIP/TV/DVD switch # @g (Text) button 4 # Colour buttons 5 $H button %a button $ 6 ^b button % &7 q buttons *f (Freeze) button 7 (X (Mul
Resumen del contenido incluido en la página 13
ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book Page 12 Monday, September 6, 2004 10:30 AM Remote control buttons and functions • Since this TV is designed to make full use Choose a TV channel and of the resolution of the original video watch images from external source, the motion may appear unnatural when the video source is input with devices progressive-scanning component signals. • If this happens, change the output setting Use the number buttons: of the c
Resumen del contenido incluido en la página 14
ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book Page 13 Monday, September 6, 2004 10:30 AM Remote control buttons and functions PR LIST: Adjust the volume The programme number (PR) and VIDEO terminal list is displayed. Press the 7 q buttons to Pressing the a button after choosing the adjust the volume. programme number (PR) or VIDEO terminal The volume level indicator appears and the with the 7 buttons will display the volume changes as you press the 7 chosen p
Resumen del contenido incluido en la página 15
ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book Page 14 Monday, September 6, 2004 10:30 AM Remote control buttons and functions 16:9 ZOOM: ZOOM function This zooms up the wide picture (16:9 aspect ratio) to the full screen. You can change the screen size according to the picture aspect ratio. Choose the optimum one from the following ZOOM modes. • The ZOOM mode is fixed at FULL when 16:9 ZOOM SUBTITLE: you are using the TV as a PC screen. This zooms up the wide p
Resumen del contenido incluido en la página 16
ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book Page 15 Monday, September 6, 2004 10:30 AM Remote control buttons and functions Adjusting the visible area of the • When you set the CINEMA SURROUND function to HIGH mode, there may be picture slight volume distortion. If that occurs, If subtitles or the top (or bottom) of the please switch to LOW mode. The effect picture are cut off, you can adjust the visible of CINEMA SURROUND functions will area of the pictur
Resumen del contenido incluido en la página 17
ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book Page 16 Monday, September 6, 2004 10:30 AM Remote control buttons and functions To cancel the “Freeze” function: 12-pictures multi: Press the f button, the 6 p buttons or the number buttons. Still pictures • The “Freeze” function does not work while a sub-picture is displayed. Moving picture • The still picture cannot be output from D0058 the TV. • When set to 2-pictures multi, you can • The “Freeze” function does
Resumen del contenido incluido en la página 18
ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book Page 17 Monday, September 6, 2004 10:30 AM Remote control buttons and functions • The BLUE BACK function does not • If you want to view the “Return Channel” work when the “Multi-picture” and another TV channel alternately, first function is being used. choose a channel other than the “Return Channel”. And then press the • The ZOOM function does not work 1 button to change the when the “Multi-picture” function is c
Resumen del contenido incluido en la página 19
ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book Page 18 Monday, September 6, 2004 10:30 AM Remote control buttons and functions Calling the favourite channel Favourite channel function 1 In the normal screen, press the d You can register your favourite TV channels (favourite) button (PR 1 – PR 99) in the number buttons 1 to 4. Then “FAVOURITE1-4?” appears. After registering, the channel can be called by pressing the d (favourite) button and a 2 Press one of the n
Resumen del contenido incluido en la página 20
ENGLISH LT-Z32/26SX4B/S / LCT1732-002A / English LT-Z32&26SX4BS_Eng.book Page 19 Monday, September 6, 2004 10:30 AM Remote control buttons and functions Operating a JVC brand DVD player These buttons will operate a JVC brand DVD player. Pressing a button that looks the same as the device’s original remote control button has the same effect as the original remote control. 1 Set the PIP/TV/DVD switch to the DVD position When you are operating the DVD player, set the switch to the DVD pos
