Resumen del contenido incluido en la página 1
FO-1470 FACSIMILE
MODEL
FO-1470
open
LCR
www.OpenLCR.com
FACSIMILE
OPERATION MANUAL
1. Installation
2. Setting up and Using OpenLCR
3. Sending Documents
4. Receiving Documents
5. Making Copies
6. Making Telephone Calls
7. Answering Machine Hookup
8. Special Functions
9. Printing Lists
10. Maintenance
11. Troubleshooting
Resumen del contenido incluido en la página 2
all-ux510A.book Page 1 Thursday, September 14, 2000 9:05 AM WARNING - FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user’s authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a r
Resumen del contenido incluido en la página 3
all-ux510A.book Page 1 Thursday, September 14, 2000 9:05 AM Introduction Welcome, and thank you for choosing a Sharp facsimile machine! The features and specifications of your new Sharp fax are shown below. Automatic dialing Rapid Key Dialing: 36 numbers Speed Dialing: 63 numbers Imaging film Initial starter roll (included with machine): Approx. 60 letter-size pages Replacement roll: UX-15CR (One roll yields approx. 500 letter-size pages) Memory size* 476 KB (approx. 27 average pages w
Resumen del contenido incluido en la página 4
all-ux510A.book Page 2 Thursday, September 14, 2000 9:05 AM Recording system Thermal transfer recording Halftone (grayscale) 64 levels Display 7 x 5 dots, 1 line by 16-digit display Paper tray capacity Letter: 200 sheets Legal: 200 sheets (16- to 20-lb. paper) Compression scheme MR, MH, MMR Applicable telephone line Public switched telephone network Compatibility ITU-T (CCITT) G3 mode Input document size Automatic feeding: Width: 5.83 to 8.5" (148 to 216 mm) Length: 5.04 to 11" (128 to 279 m
Resumen del contenido incluido en la página 5
all-ux510A.book Page 3 Thursday, September 14, 2000 9:05 AM Dimensions Width: 14.4" (365 mm) Depth: 19.0" (482 mm) (With attachments) Height: 10.6" (270 mm) (With attachments) Weight Approx. 10.6 lbs. (4.8 kg) As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations fr
Resumen del contenido incluido en la página 6
all-ux510A.book Page 4 Thursday, September 14, 2000 9:05 AM • Never insert objects of any kind into slots or openings on the machine. This could create a risk of fire or electric shock. If an object falls into the machine that you cannot remove, unplug the machine and consult a qualified service representative. • Do not place this machine on an unstable cart, stand or table. The machine could be seriously damaged if it falls. • Never install telephone wiring during a lightning storm. • Ne
Resumen del contenido incluido en la página 7
all-ux510A.book Page 5 Thursday, September 14, 2000 9:05 AM Table of Contents Introduction 1 Important safety information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Table of Contents 5 1. Installation 7 Unpacking Checklist. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 A Look at the Operation Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Resumen del contenido incluido en la página 8
all-ux510A.book Page 6 Thursday, September 14, 2000 9:05 AM Table of Contents 7. Answering Machine Hookup 81 Connecting an Answering Machine . . . . . . . . . . . . . . . . . . . . . . . . . 81 Optional A.M. Mode Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 84 8. Special Functions 86 Caller ID (Requires Subscription to Service) . . . . . . . . . . . . . . . . . . 86 Distinctive Ring (Requires Subscription to Service) . . . . . . . . . . . . . 92 Broadcasting . . . .
Resumen del contenido incluido en la página 9
all-ux510A.book Page 7 Thursday, September 14, 2000 9:05 AM 1. Installation Unpacking Checklist Before setting up, If any are missing, make sure you contact your dealer have all of the or retailer. following items. Paper tray Rapid key cover labels Operation manual Paper tray Handset 3 gears and Handset cord 1 flange Sample imaging film Telephone line cord 7 1. Installation
Resumen del contenido incluido en la página 10
all-ux510A.book Page 8 Thursday, September 14, 2000 9:05 AM A Look at the Operation Panel A Look at the Operation Panel 5 1 2 3 4 6 7 8 TEL FAX 01 02 03 ABC DEF SPEED 19 20 21 DIAL SHIFT 12 3 A.M. 04 05 06 07 22 23 24 25 GHI JKL MNO REDIAL VOLUME 08 09 10 11 DOWN UP 45 6 26 27 28 29 PQRS TUV WXYZ HOLD/ RECEPTION SEARCH MODE FUNCTION RESOLUTION MEMORY 12 13 14/POLL 15/P1 30 31 32 33 78 9 COPY/ HELP START STOP 16/P2 17/G1 18/G2 SPEAKER OpenLCR 34 35 36 0 OpenLCR PANEL RELEASE 18 17 16 15 14 13
Resumen del contenido incluido en la página 11
all-ux510A.book Page 9 Thursday, September 14, 2000 9:05 AM A Look at the Operation Panel Rapid Dial Keys 8 Press one of these keys to dial a fax number automatically. OpenLCR key 9 Press this key to register for OpenLCR service and receive carrier rate data to your fax. RESOLUTION key 10 Press this key to adjust the resolution for faxing or copying. STOP key 11 Press this key to cancel an operation before it is completed. Panel release 12 Grasp this finger hold and pull toward you to open t
Resumen del contenido incluido en la página 12
all-ux510A.book Page 10 Thursday, September 14, 2000 9:05 AM Connections Connections Points to keep in mind when setting up Do not place the machine in Do not place the machine near direct sunlight. heaters or air conditioners. Keep dust away from the Keep the area around the machine. machine clear. About condensation If the machine is moved from a cold to a warm place, it is possible that condensation may form on the scanning glass, preventing proper scanning of documents for transmis
Resumen del contenido incluido en la página 13
all-ux510A.book Page 11 Thursday, September 14, 2000 9:05 AM Connections Connecting the Handset Connect the handset as shown and place it on the handset rest. ♦ The ends of the handset cord are identical, so they will go into either jack. Make sure the handset cord goes into the unmarked jack on the side of the machine! Use the handset to make ordinary phone calls, or to transmit and receive faxes manually. 11 1. Installation
Resumen del contenido incluido en la página 14
all-ux510A.book Page 12 Thursday, September 14, 2000 9:05 AM Connections Connecting the power cord Plug the power cord into a 120 V, 60 Hz, grounded AC (3-prong) outlet. Caution! Do not plug the power cord into any other kind of outlet. This will damage the machine and is not covered under the warranty. The machine does not have a power on/off switch, so the power is turned on and off by simply plugging in or unplugging the power cord. Note: If your area experiences a high incidence of
Resumen del contenido incluido en la página 15
TEL. TEL. SET LINE all-ux510A.book Page 13 Thursday, September 14, 2000 9:05 AM Connections Connecting the telephone line cord Insert one end of the line cord into the jack on the back of the machine marked TEL. LINE. Insert the other end into a standard (RJ11C) single-line wall telephone jack. Be sure to insert the line into the TEL. LINE jack. Do not insert it into the TEL. SET jack. Note: The fax machine is set for tone dialing. If you are on a pulse dial line, you must set the fax m
Resumen del contenido incluido en la página 16
TEL. TEL. SET LINE all-ux510A.book Page 14 Thursday, September 14, 2000 9:05 AM Connections Attachments Insert the paper tray into the back of the fax as shown. Extension phone (optional) If desired, you can connect an extension phone to the TEL. SET jack on the fax. ♦ To connect an answering machine to your fax, see Chapter 7, Answering Machine Hookup (page 81). 1 Remove the seal covering the TEL. SET jack. 2 Connect the extension phone line to the TEL. SET jack. 14
Resumen del contenido incluido en la página 17
all-ux510A.book Page 15 Thursday, September 14, 2000 9:05 AM Loading the Imaging Film Loading the Imaging Film Your fax uses a roll of imaging film to create printed text and images. The print head in the fax applies heat to the imaging film to transfer ink to the paper. Follow the steps below to load or replace the film. When replacing the film, use a The initial starter roll of roll of Sharp UX-15CR imaging film included with imaging film. One roll can print your fax can print about
Resumen del contenido incluido en la página 18
all-ux510A.book Page 16 Thursday, September 14, 2000 9:05 AM Loading the Imaging Film 2 If you are replacing the imaging film, take the old film out of the printing compartment and remove the three (3) green gears and the green flange from the ends of the spools. DO NOT DISCARD THE GREEN GEARS AND THE GREEN FLANGE! 3 Take the new film out of its package, and insert two of the gears provided with the fax into the ends of the spool with film. Make sure that the two tabs on the gears
Resumen del contenido incluido en la página 19
all-ux510A.book Page 17 Thursday, September 14, 2000 9:05 AM Loading the Imaging Film 1 tab 5 Cut the band which holds the spools 2 tabs together with scissors, and remove it. Insert the remaining gear into the right end of the empty spool and the flange into the left end of the empty spool. Make sure the tabs on the gear and the flange fit into the slots in the Gear ends of the spool (the gear has two tabs and the flange has one tab). Flange 6 Pull the empty spool toward the back of
Resumen del contenido incluido en la página 20
all-ux510A.book Page 18 Thursday, September 14, 2000 9:05 AM Loading the Imaging Film 9 Close the print compartment cover, making sure it clicks into place. • Caution! Close the cover slowly to make sure it doesn't pinch your fin- gers. 10 Load paper in the paper tray and then press the following keys to initialize the film. Note: Paper must be loaded before the film can be initialized. To load paper, see Loading the Printing Paper. Display shows: START FUNCTION 6 INITIALIZE FILM When to
