Resumen del contenido incluido en la página 1
Resumen del contenido incluido en la página 2
Fujitsu NI / 5E Custom Terminal Intro & Table of Contents 1 NI / 5E Custom Terminal Overview 2 Using the Terminal 3 Terminal Set-Up AND 4 SRS-9924-ABM 5 NI / 5E Custom Terminal Installation 6 Terminal Accessories NI / 5E Custom A Appendix Terminal Testing USER GUIDE NI / 5E Custom B Appendix SRS-9924/9912-SP Error Messages C Appendix Ordering National ISDN Lines Appendix D 5E Custom Terminal ICI Displays
Resumen del contenido incluido en la página 3
Fujitsu Network Communications, Inc. 2800 Sumner Blvd., Suite 124 Raleigh, NC 27616 U.S.A. Part Number P-UG-99VO-A Revision 1.4 © Copyright 2000 Fujitsu Network Communications, Inc. All rights reserved. Printed in the United States of America. This publication may be replaced by a revised edition. To find out if a revision exists, or to order copies of publications, write to Fujitsu Network Communications, Inc., 2800 Sumner Blvd., Suite 124, Raleigh, NC 27616, or call 1-800-228-ISDN. Please
Resumen del contenido incluido en la página 4
Fujitsu NI / 5E Custom Terminal Intro & Table of Contents Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference with rad
Resumen del contenido incluido en la página 5
System Port Identification Facility Interface & Service Order Codes Mfgrs Port Facilities Service Order Network Jack Identifier Interface Code Code ISDN Line 02IS5 6.ON RJ-49 If this telephone equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But, if advance notice isn’t practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to
Resumen del contenido incluido en la página 6
Fujitsu NI / 5E Custom Terminal Intro & Table of Contents Repairs Repairs to this equipment can only be made by the manufacturer or its authorized agents. If this equipment is causing harm to the telephone network, the telephone company may request that it be unplugged from the modular outlet until the problem has been corrected. To obtain repair service or warranty information, contact: Technical Assistance Center Fujitsu Network Communications, Inc. 2800 Sumner Blvd., Suite 124 Raleigh, NC
Resumen del contenido incluido en la página 7
Conventions and Layout • In procedures, the required actions are noted, with the buttons you press in capital letters, such as HOLD or REDIAL. • Other important words, such as messages that appear on the display, also appear in CAPITAL LETTERS. • Some procedures use the following symbol to indicate which buttons to press. ENTER • Call Appearance and Directory Number are abbreviated as CA and DN. Menus or screen displays appear as text in boxes. 12:05PM FRI JAN 15 UNA L-DIR CLEAR OPTIONS Action
Resumen del contenido incluido en la página 8
Fujitsu NI / 5E Custom Terminal Intro & Table of Contents Softkeys The softkeys are the four keys located just below the display. 12:05PM FRI JAN 15 UNA L-DIR CLEAR OPTIONS Menu 1234 Standard Softkey Layout ENTER NEXT CLEAR EXIT Menu 12 34 Other Softkey Functions (For entering information as indicated in this User’s Guide.) You can display the labels at any time without affecting the tasks you are performing. The labels do not, however, have to be displayed for these keys to work. Timeouts W
Resumen del contenido incluido en la página 9
Dialing 9. When you dial for an outside line (usually by pressing 9), you do not hear a pause and a second dial tone. You can begin dialing the telephone number immediately. Onhook dialing. You can dial a number before you get a dial tone. The number you dial appears on the display and remains there for three minutes. When you lift the handset or press the SPEAKER button for handsfree mode, the phone initiates the call automatically. System Administrator ISDN is very flexible in allowing bus
Resumen del contenido incluido en la página 10
Fujitsu NI / 5E Custom Terminal Intro & Table of Contents • They allow the incoming directory number and calling name to be displayed if it is available from your service provider. Multipoint Configurations In multipoint configurations, ISDN lines are shared by two or more terminals. Usually, two terminals will share a BRI, allowing one B-channel for each terminal. Multipoint operation goes on behind the scenes. The only time you would be aware of it is if you get “blocked” from using a line.
Resumen del contenido incluido en la página 11
TABLE OF CONTENTS Section Page Chapter 1 GETTING ACQUAINTED WITH YOUR DIGITAL SET ............................. 1-1 Unique Components .................................................................... 1-6 Switches and Connectors ............................................................. 1-6 LED Indicators .............................................................................. 1-6 MIC-OFF Button ........................................................................... 1-7 Function K
Resumen del contenido incluido en la página 12
Fujitsu NI / 5E Custom Terminal Intro & Table of Contents ENABLING/DISABLING THE SPEAKER FUNCTION ............................ 3-13 HANDSFREE, HANDSET, AND HEADSET MODES ............................. 3-13 CHANGING RINGER MODE ............................................................ 3-14 ASSIGNING A LEASED NETWORK ACCESS CODE DELIMITER (5E CUSTOM) .. 3-17 CALL ANNOUNCE INTERCOM ........................................................ 3-18 Call Announce Intercom on Selected Buttons ...........
Resumen del contenido incluido en la página 13
1 CHAPTER 1 GETTING ACQUAINTED WITH YOUR DIGITAL SET This introductory chapter describes the set’s parts, connectors, switches, and screen displays. It also explains how the functions and features operate. The SRS-9924-ABM is described in Chapter 4. Multifunction Buttons Softkeys SRS-9924-ABM 48 49 50 MSG MENU 45 46 47 13 14 15 16 17 MIC-OFF 42 43 44 789 10 11 12 39 40 41 123456 36 37 38 SRS-9924 33 34
Resumen del contenido incluido en la página 14
NI / 5E Custom Terminal Overview 1 Multifunction Buttons Softkeys SRS-9924-ABM MSG 45 46 47 MENU 42 43 44 13 14 15 16 17 MIC-OFF 39 40 41 789 10 11 12 36 37 38 123456 33 34 35 SRS-9924 30 31 32 ABC DEF 1 2 3 27 28 29 DROP CONF JKL GHI MNO 4 5 6 24 25 26 TRAN REDIAL PQ RS TUV WXYZ 21 22 23 7 8 9 HOLD SPKR 18 19 20 * 0 # Function
Resumen del contenido incluido en la página 15
1 Display 63 MENU MSG Softkeys MI C - OFF Multifunction Buttons A B C F 1 2 3 JK L G H I M N O 6 Numeric Keypad P Q R S T U V WXY Z 7 8 9 SPKR * 0 # Microphone Volume/Contrast Function Keys Buttons Figure 1-3: SRS-9912-SP National ISDN Front View 1-3 NI / 5E Custom Terminal Overview
Resumen del contenido incluido en la página 16
NI / 5E Custom Terminal Overview 1 Display 63 MENU MSG Softkeys MI C - OFF Multifunction Buttons A B C F 1 2 3 DROP CONF JK L G H I M N O 6 4 5 Numeric TRAN REDIAL Keypad PQ RS TUV WXY Z 7 8 9 HOLD SPKR 0 # * Microphone Volume/Contrast Function Keys Buttons Figure 1-4: SRS-9912-SP 5E Custom National ISDN Front View 1-4
Resumen del contenido incluido en la página 17
1 LINE 48V DC TR PS OFF ON OFF ON C Terminating DC power connector resistor ISDN Line Connector Handset/Headset Power Source selection connector located beneath terminal Figure 1-5: Digital Set Rear View Rear stand Handset /Headset plug Figure 1-6: Digital Set Bottom View 1-5 NI / 5E Custom Terminal Overview
Resumen del contenido incluido en la página 18
NI / 5E Custom Terminal Overview 1 Unique Components Softkeys/MENU. Four buttons below the display with changeable functions. The MENU key displays the current functions on line 2 of the display. Multifunction buttons. These buttons are assigned to CAs, DNs, one-touch numbers, or network features. Dual assignments are not supported. (For example: One-Touch and Call Appearance) Function keys. Single-touch keys for features, consisting of DROP, CONF, TRAN, REDIAL, HOLD, and SPKR. Volume/Contr
Resumen del contenido incluido en la página 19
1 For Multifunction Keys: An LED associated with each button slowly flashes green for incoming calls, flashes red if a call is on hold at your phone, and is steady red when a call is active on your phone. MIC-OFF Button The upper right button on the array is used as a MIC-OFF function key. When pressed, the MIC-OFF key turns red and mutes the microphone, allowing you to hold a private conversation. MIC-OFF is de-activated by default when your digital set is delivered. Set-up for the MIC-OFF bu
Resumen del contenido incluido en la página 20
NI / 5E Custom Terminal Overview 1 MULTIFUNCTION Multifunction buttons have three uses: BUTTONS One-touch: Dial a stored number. Network Feature: Activate or deactivate a special network feature, such as call forwarding. Call Appearance (CA) or Directory Number (DN): Handles incoming or outgoing calls. Use and set-up of the multi-function buttons is covered in Chapters 2 and 3 respectively. Special features such as call forwarding are provided by the ISDN network. These features are selected b
