Manual de instrucciones de Nokia 6090 DIN/ISO

Resumen del contenido incluido en la página 1

6090 DIN/ISO Installation Kit
Installation Guide
9359286
Issue 1
Nokia is a registered trademark of Nokia Corporation, Finnland.
© 1999 Nokia Mobile Phones. All rights reserved.
Nokia Mobile Phones operates a policy of continuous development.
Therefore, we reserve the right to make changes and improvements to
any of the products described in this guide without prior notice.

Resumen del contenido incluido en la página 2

Introduction This installation guide has been prepared to provide the basic informa- tion required to install the 6090 DIN/ISO Installation Kit (see ISO 7736 Road Vehicles Car Radio Front Installation). The information contained in this guide may differ from your actual work, as different types and mod- els of vehicles will require different installation techniques. The informa- tion given is for general guidance only. Under the terms of the warranty, this car kit must be installed by a qual-

Resumen del contenido incluido en la página 3

Unpacking Carefully unpack the equipment and make sure that the following items are present: 1. Transceiver unit (not part of this kit) Remove the plastic cover of the Transceiver Kit! 2. DIN/ISO console 3. DIN/ISO bracket 4. DIN/ISO slot front cover Transceiver NME-3 DIN/ISO console DIN/ISO bracket DIN/ISO slot front cover

Resumen del contenido incluido en la página 4

Component Parts Transceiver NME-3 The transceiver unit is supplied separately and includes all those acces- sories needed to complete the installation. See the installation instruc- tions in the 6090 User‘s Guide for details of transceiver and cable installation. Note: The plastic cover of the transceiver must be removed before it is installed in the DIN/ISO slot. DIN/ISO console The DIN/ISO console is made of steel and is to be installed in the car‘s DIN/ISO slot. Note: The rectangular cut-

Resumen del contenido incluido en la página 5

Installation Installing the 6090 DIN/ISO Installation Kit 1. Remove the plastic cover from the transceiver unit. 2. Remove the cover from the ISO slot in the dashboard. 3. Route the connecting cables behind the dashboard (see the installa- tion instructions in the 6090 User‘s Guide for further details). 4. Insert the DIN/ISO console into the ISO slot, and secure by bending the locking tabs. Note that the spare slots are in the base of the frame. En- sure that the frame is firmly placed. Note: D

Resumen del contenido incluido en la página 6

5. Slide the bracket into the console until it clicks into place. 6. Attach the connecting cables to the transceiver unit through the open slot. Slide the transceiver module into the bracket until it clicks into place.

Resumen del contenido incluido en la página 7

7. Place the front panel onto the bracket. Push firmly until the four lock- ing studs click into place. 8. Insert the SIM card and optional data cable.

Resumen del contenido incluido en la página 8

Removing the transceiver The transceiver can be removed by first removing the front panel from the bracket. The transceiver can then be released from the bracket by in- serting a thin tool (e.g. credit card) between the transceiver base and the bracket to release the locking tab (see diagrams 5 and 6). Testing Once installed, the equipment should be tested to ensure that it is oper- able and that the position of the units does not impact the driver‘s abil- ity to control and operate the vehic