Manual de instrucciones de Nissan Frontier Front Leveling Kit NL221

Resumen del contenido incluido en la página 1

2265 Crosswind Drive • Prescott, AZ 86301
(928) 636-3175 • www.p-a-g.net
NISSAN FRONTIER
FRONT LEVELING KIT
INSTALLATION INSTRUCTIONS
2005-2006 KIT# NL221
WARNING
Many states and municipalities have laws restricting
bumper heights and vehicle lifts. Consult state and
WARNING
local laws to determine if the changes you intend to
make to the vehicle comply with the law.
Installation of a Performance Automotive Group sus-
pension lift kit will change the vehicle’s center of gravity
WARNING
and h

Resumen del contenido incluido en la página 2

Ride Height Before Starting Installation 1. Measure ride height with the vehicle supporting its own weight on level ground. To settle the suspen- NOTE sion, the vehicle should be driven forward at least 10 Kit parts are prefaced by the word kit and appear in feet immediately prior to taking these measure- bold print. ments. Ride height is the measurement from the center of the axle straight up (vertical) to the fender 1. Carefully read all warnings and instructions com- lip. Record this measurem

Resumen del contenido incluido en la página 3

5. Driver side coil-over assembly Engine Compartment 1. Disconnect both battery cables. Disconnect negative a. Remove nut and bolt from lower coil-over cable first, then positive cable. assembly and lower control arm. Positive Coil-Over Cable Assy. Battery Bolt & Nut Negative Lower Cable Control Arm b. Remove three nuts and coil-over assembly from upper perch. Prepare to Install Front Leveling Kit Coil-Over Assy. WARNING Compressed coil springs can expand violently causing Nuts serious personal

Resumen del contenido incluido en la página 4

a. Scribe alignment mark lengthwise along upper e. Install kit spacer (lower) and three kit bolts plate, coil spring, and shock for proper re- (10mm x 50mm) onto bottom of upper plate. assembly. Kit Spacer Upper Plate (Lower) & Coil Spring Upper Plate Alignment Mark Shock b. Using coil spring compressors, carefully com- Kit Bolts press coil spring until coil spring is loose on (10 x 50mm) shock. Spring Compressor Coil Spring f. Install isolator onto kit spacer (lower). Isolator Shock c. Remove n

Resumen del contenido incluido en la página 5

g. Align marks on coil spring, upper plate, and j. Install coil-over assembly onto upper perch with shock. Install upper plate, shock, bushing, three kit nuts (10mm stover). washer, and nut onto coil spring. Kit Nuts Washer (10mm & Bushing Stover) Coil-Over Upper Plate Assy. Upper Perch Coil Spring k. Install coil-over assembly onto lower control arm with nut and bolt. Coil-Over Assy. Nut Bolt & Nut Lower Control Arm h. Ensure marks are aligned along upper plate, coil spring, and shock. l. Repea

Resumen del contenido incluido en la página 6

After Completing Installation CAUTION Performance Automotive Group does not recommend any particular wheel and tire combinations for use with Engine Compartment its suspension lifts and cannot assume responsibility 1. Connect both battery cables. Connect positive cable for the customer’s choice of wheels and tires. Refer to your owner's manual for recommended tire sizes and first, then negative cable. warnings related to the use of oversized tires. Larger wheel and tire combinations increase st