Manual de instrucciones de Metra Electronics GMLAN11-100

Resumen del contenido incluido en la página 1

INSTALLATION INSTRUCTIONS FOR PART GMLAN11-100
GMLAN11-100
*Read Important Warning On Page 1
Before Attempting Any Installation*
The GMLAN11-100 is designed to and MUST be used with the
GMOS-100i (SOLD SEPERATELY). Please refer to GMOS-100i
for 20 pin connector instructions.
APPLICATIONS
CHEVROLET
Cobalt 2007-10
HHR 2006-10
Malibu 2008-10
PONTIAC
G5 2007-08
G6 2009
Solstice 2006-09
SATURN
Aura 2006-09
Sky 2006-09
1-800-221-0932 axxessinterface.com
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORP

Resumen del contenido incluido en la página 2

INTERFACE COMPONENTS •A) 4 pin harness with stripped leads •B) 22 pin to 30 pin GMLAN car side harness A B 4 pin TOOLS REQUIRED FOR INSTALLATION •Cutting Tool •Tape •Crimping Tool •Connectors (I.E. butt-connectors, bell caps, ECT…) M2.6 6 2.5 1.5 IGNITION TERMINALS WIRE CUTTER ISO M3.5 M4 M3 M5

Resumen del contenido incluido en la página 3

TABLE OF CONTENTS Installing The Interface .............................................................. 1 Installing The GMLAN11-100 ................................................. 1 Programming SWC ..................................................................... 2 Testing The GMLAN11-100 ...................................................... 2 KNOWLEDGE IS POWER Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics s

Resumen del contenido incluido en la página 4

*Important: Before beginning any of the following, disconnect the negative battery terminal to prevent an accidental short circuit. INSTALLING THE INTERFACE From the 22 way harness: • Connect the Black wire with the ring terminal to the back of the aftermarket radios chasis • Connect the 3.5mm jack to your aftermarket radios steering wheel control input (if equipped) From the 30 way harness: • Connect the Black wire to the ground wire of the aftermarket radio • Connect the RCA’s on 8 pin

Resumen del contenido incluido en la página 5

• Reconnect the negative battery terminal. • Plug the 30 pin GM harness into the vehicle side harness, and plug the aftermarket radio harness into the aftermarket radio. • Cycle the key by turning the ignition on then back off, then back on again to test the radio. PROGRAMMING SWC • Turn on the ignition • The LED will begin to blink rapidly The following buttons must be pressed in the following order: Volume up, Seek up, Band, PTT/Mute, Fan up (Each button press will be acknowledged with th

Resumen del contenido incluido en la página 6

NOTES

Resumen del contenido incluido en la página 7

NOTES

Resumen del contenido incluido en la página 8

INSTALLATION INSTRUCTIONS FOR PART GMLAN11-100 1-800-221-0932 axxessinterface.com © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION REV. 4/2/2010