Resumen del contenido incluido en la página 1
Resumen del contenido incluido en la página 2
** ** ** ** ** Notice ** Copyright (Copyright © 2001 HUMAX Corporation) Not to be copied, used or translated in part or whole without HUMAX's prior consent in writing except approval of ownership of copyright and copyright law. ** Warranty HUMAX does not have any responsibility for direct, indirect, accidental, necessary and other damage due to your offer or use of the information contained in this manual. ** Trademarks VIACCESS™ is a trademark of France Telecom. CryptoWorks (TM) is a trademark
Resumen del contenido incluido en la página 3
** ** ** ** ** Notice ** Read this manual carefully and make sure you understand the instructions provided. For your safety, check what the result of each action will be. ** Warnings, Cautions and Notes Throughout the whole manual, pay special attention to the following marks that indicate hazardous situations. ** Warning ** Indicates a hazardous situation which, if not avoided, could result in (serious) injury. ** Caution ** Indicates a situation which, if not avoided, could damage the equi
Resumen del contenido incluido en la página 4
** ** ** ** ** Safety and Warning ** This digital terrestrial receiver and personal video recorder has been manufactured to comply with international safety standards. Please read the following safety precautions carefully. ** Safety Instructions and Precautions ** 1. MAINS SUPPLY ** 90 - 250V AC 50/60Hz Operate this product only from the type of power supply indicated on the marking label. If you are not sure of the type of power supplied to your home, consult your local power company. Disconne
Resumen del contenido incluido en la página 5
** ** ** ** ** Safety and Warning ** 10. LOCATION ** Place the receiver indoors to avoid exposing it to lightening, rain or sun. Do not place it near a radiator or heat register. Make sure it has more than 10 cm clearance from any appliances susceptible to electromagnetic influences, such as TV and VCR. Do not block these openings with any object, and do not place the product on a bed, sofa, rug, or other similar surface. If you place the product on a rack or bookcase, ensure that there is adequ
Resumen del contenido incluido en la página 6
** ** ** ** ** Contents ** 1. Before Using the Receiver GB8 ** 1.1 Package Contents GB8 1.2 Front Panel GB9 1.3 Rear Panel GB10 1.4 Remote Control GB11 ** ** 2. Setup GB14 ** 2.1 Connecting Aerial GB14 2.2 Powering On GB17 ** ** 3. Installation Wizard GB18 ** 3.1 Language GB18 3.2 Area Setting GB18 3.3 Antenna Setting GB19 3.4 Time Setting GB19 ** ** 4. Basic Operation GB20 ** 4.1 Switching Channel GB20 ** ** 4.2 Volume Control GB20 4.3 Teletext GB20 4.4 Changing the Subtitle Language GB22 4.5 C
Resumen del contenido incluido en la página 7
** ** ** ** ** Contents ** 5. Time Shifted Recording GB27 ** 5.1 Time Bar GB27 5.2 Pause GB27 5.3 Fast Rewind to Previous Scene GB28 5.4 Fast Forward to the Next Scene GB28 5.5 Slow Motion GB28 5.6 Recording GB28 5.7 Additional Time Shift Operations using Time Bar GB29 ** ** 6. Recording and Playback GB30 ** 6.1 Instant Recording GB30 6.2 Recording Reservation GB30 6.3 Programme Playback GB32 6.4 Editing Recorded Programmes GB33 6.5 Checking Hard Disk Drive GB34 ** ** 7. Channel List GB35 ** 7.1
Resumen del contenido incluido en la página 8
** ** ** ** ** ** ** 9. Setting Preferences GB50 ** 9.1 Parental Control GB50 9.2 Language Setting GB52 9.3 Time Setting GB54 9.4 A/V Control GB55 9.5 UHF Tuning GB57 9.6 Miscellaneous Settings GB58 ** ** 10. Installation GB59 ** 10.1 Automatic Search GB59 10.2 Manual Search GB60 10.3 Default Setting GB61 10.4 Antenna Power GB62 ** ** 11. Software Update GB63 ** 11.1 OTA (Over the Air) GB63 11.2 S/W Update from PC GB67 ** ** ** ** 12. System Information GB68 ** 12.1 Status GB68 12.2 Signal Detec
Resumen del contenido incluido en la página 9
** ** ** ** ** 1.Before Using the Receiver ** This chapter describes detail instructions on the product and its accessories. 1.1 Package Contents Please check all package contents before using your product. ** ** Remote Control User's Manual ** ** ** ** Batteries RF Cable ** Note: Since faults may occur if the remote controller is being left without a battery for a long time, always keep the battery inserted in the remote controller. An active antenna is not included in a package. Warning: T
Resumen del contenido incluido en la página 10
** ** ** ** ** ** ** 1.2 Front Panel ** 1. STANDBY Button ** Switches between Operation and Standby modes. 2. Sensor, Display and LED ** IR Infrared remote control command indicator. This indicator lights up momentarily when a command from the handset is received. ** Digit LED Display This will display the current channel or certain programming functions when using the menus. ** RECORD LED Indicates that the STB is in recording mode. ** RADIO LED ** ** Indicates that the STB is in radio mode. 3.
Resumen del contenido incluido en la página 11
** ** ** ** ** 1. Before Using the Receiver ** 1.3 Rear Panel ** 1. ANTENNA IN ** Connects an Aerial to an Antenna input jack on the receiver. 2. TV / VCR ** Connects a RF signal from your receiver to RF (ANT) input jack on your TV or VCR. 3. TV SCART ** Connects to a TV using SCART cable. 4. VCR SCART ** Connects to a VCR using SCART cable. ** ** 5. VIDEO ** Connects to your TV or VCR using RCA cable to output Video signals. 6. AUDIO L/R ** Connects to your TV or VCR using RCA cable to output A
Resumen del contenido incluido en la página 12
** ** ** ** ** ** ** 1.4 Remote Control ** ** ** ** Note: This remote control can also control your TV. To set the remote control for your TV, please refer to Chapter 12. In TV mode, the STANDBY, AUX, NUMERICAL(0~9), CH-/CH+, V-/V+, MUTE buttons are supported. ** ** GB 11 ** ** ** ** ** **
Resumen del contenido incluido en la página 13
** ** ** ** ** 1. Before Using the Receiver ** 1. DTV 12. CH- / CH+ and PAGE- / PAGE+ ** ** Controls the receiver. Changes the Channel or Page. ** ** 2. TV 13. TV/RADIO ** ** Controls the TV. Switches between TV and Radio modes. ** ** 3. NUMERICAL BUTTONS 14. STANDBY ** ** Enter a TV/Radio channel number or Switches between Operation and menu option number. Standby modes. ** ** 4. WIDE 15. AUX/SOURCE ** ** Changes the display format. Controls the input of TV in TV mode. ** Selects the output sou
Resumen del contenido incluido en la página 14
** ** ** ** ** ** ** 23. PLAYBACK CONTROL BUTTONS 24. TELETEXT ** ** (FAST REWIND) (SUB-PAGE) ** ** Rewinds a programme. Each time you Search the sub-page in teletext mode. If press this button, the scenes is rewound it’s not in the teletext mode, display the more faster divided into 3 steps. current time. ** ** (PLAY) (TELETEXT ON/OFF) ** ** Plays a programme. Switches between Teletext and TV ** modes. ** (FAST FORWARD) ** (DOUBLE) Fast forwards a programme. Each time ** you press this button,
Resumen del contenido incluido en la página 15
** ** ** ** ** 2. Setup ** This chapter describes how to set up the receiver. Select the most appropriate procedure depending on your requirements. Note: If you encounter any problem when setting up the receiver, please contact your local product distributor. 2.1 Connecting the Aerial 1. Connecting TV and VCR Connect the cable of your TV aerial to the ANTENNA IN connector on the rear of the receiver. The Aerial cable, RF cable, and Scart cable are connected as in the figure below. ** ** ** ** Wa
Resumen del contenido incluido en la página 16
** ** ** ** ** ** ** 2. Connecting Hi-Fi system 1 Connect the outputs on this receiver to corresponding inputs on your Hi-Fi Audio.(left audio out to left audio in, right audio out to right audio in) ** ** ** ** ** GB 15 ** ** ** ** ** **
Resumen del contenido incluido en la página 17
** ** ** ** ** 2. Setup ** 3. Connecting Hi-Fi system 2 If you wish to connect the optical S/PDIF terminal and Dolby digital decoder to listen digital audio, connect as following. ** ** ** ** ** GB 16 ** ** ** ** ** **
Resumen del contenido incluido en la página 18
** ** ** ** ** ** ** 2.2 Powering On 1. Connect the power cord of the receiver to a wall outlet. Turn on the power switch, located at the left on the back of the receiver. Make sure that the Standby LED indicator is turned on Red. ** ** 2. Press the DTV button to control the receiver using the remote controller. ** ** 3. Press the STANDBY button on the Remote Controller or on the receiver. ** ** ** GB 17 ** ** ** ** ** **
Resumen del contenido incluido en la página 19
** ** ** ** ** 3. Installation Wizard ** When powering on your receiver for the first time after purchasing, the Installation Wizard is automatically started. You can easily set-up using simple organisation and options, and watch the broadcasting after completing the set-up procedure. Note: If you press the BACK button or select Back and press the OK button while running the Installation Wizard, you can return to the previous screen. 3.1 Language Select the appropriate language from the list usi
Resumen del contenido incluido en la página 20
** ** ** ** ** ** ** 3.3 Antenna Setting You can set the antenna power. Press the OK or button to select On or Off. On 5V power supply from the active antenna cable. Off No power supply. Select Next using the button and press the OK button to start Automatic Search. Please wait for finishing the Automatic Search. If you want to stop the Automatic Search, press the OK button. If the Automatic Search is stopped or finished, you must press Save to save the searched result and go to the next step. 3
