Manual de instrucciones de Havis-Shields C-VS-1200-EXPD-1

Resumen del contenido incluido en la página 1

4
INSTALL INSTRUCTIONS C-VS-1200-EXPD-1
VEHICLE SPECIFIC CONSOLE
2007-2008 FORD EXPEDITION (w/ Console shifter)

TOOLS REQUIRED:
Ratcheting wrench Screwdriver set
Sockets Set T-20 torx bit
Panel pulling tool

HARDWARE:
QTY DESCRIPTION PART #
4 #10 x ½” Phillips machine screw GSM33118
4 #10 Keps nut GSM30028

Always!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any

Resumen del contenido incluido en la página 2

View of vehicle w/ full console Remove accessory pocket liner & console shifter as shown above Remove hex head screw from CAREFULLY remove trim Remove trim from around the accessory pocket from around gear shifter cup holders Remove trim panel from View of panel removed Remove hex head screw from console. accessory pocket/armrest C-VS-1200-EXPD-1_INST_9-07 2

Resumen del contenido incluido en la página 3

Remove (4) hex screws holding Remove the rear OEM cup Pry up on accessory pocket trim armrest pad from hinge holder panel and remove Remove hex head screws holding Remove hex head screws side of accessory pocket holding rear of accessory pocket Remove hex head screws holding Completely remove the container Parts removed from OEM lower sides accessory pocket of the accessory pocket console C-VS-1200-EXPD-1_INST_9-07 3

Resumen del contenido incluido en la página 4

Replace the trim panel Replace trim panel around Replace the trim panel around previously removed earlier factory cup holder gear shifter Replace hex head screw on Position console so holes in side Replace rear cup holders accessory pocket of console align w/ holes in factory console Install #10 x ½” machine View of specific application View of console installed screws and keps nuts as shown including C-TCB-24, C- above ARM-2, C-3090-7, control heads, etc..(Sold Seperatly) C-VS-1200