Manual de instrucciones de Havis-Shields 2006-2007 Dodge Charger and Magnum C-VS-2400-CHGR

Resumen del contenido incluido en la página 1

INSTALL INSTRUCTIONS
C-VS-2400-CHGR & C-VS-2400-CHGR-1
2006 – 2007 DODGE CHARGER and MAGNUM
2008 DODGE CHARGER and MAGNUM
TOOLS REQUIRED:
Ratcheting wrench Screwdriver set
Sockets - 7/16”, 10mm, 8mm T-20 Torx bit

HARDWARE:
ITEM QTY DESCRIPTION PART#
1 1 Console housing assembly C-VS-2400-CHGR-H
2 1 Front support bracket CM001593
3 2 Side trim panels - 2006 – 2007 Charger CM001598-D and P
3 2 Side trim panels - 2008 Charger CM002164 and CM002165
4 1 Front floor bracket CM00159

Resumen del contenido incluido en la página 2

Always! Read all instructions before installing any Havis-Shields Equipment Corp products. Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes! Use hardware provided with install kit For product support, visit the Install Instructions Section of our website at http://havis.com/Installation/Installation.html, email technicalsupport@havis.com or call 1-800- 524-9900. 2006-2007 Charger OEM Setup Remove OEM track/plate & Loosely attach, (driver side 1st

Resumen del contenido incluido en la página 3

Position sensor guard to align Place console housing assembly, Position rear-floor panel, continue to with OEM floor nut serts continuing to align with OEM align with OEM floor nut serts (Item 5) floor nut serts (Item 1) (Item 6) Attach main console housing to Using OEM rear bolts or ¼” x ¾” self Tighten all hardware threading bolts, loosely attach main previously installed floor bracket (7/16”, 8mm, 10mm socket) console housing, sensor guard, and using ¼” carriage bolts a