Manual de instrucciones de GE neral ElectricGSD5500G02

Resumen del contenido incluido en la página 1

Service Bulletin
GE Consumer & Industrial
DISHWASHERS DD 04-04
GE Appliances
SHORT DOOR ELECTRONIC DISHWASHERS
General Electric Company
SENSOR MODELS: EDW3000G02, GSD5400G02,
Louisville, Kentucky 40225
GSD5500G02, GD5800G02, GSD5900G02
AND LATER
NON-SENSOR MODELS: GSD4800J01 AND LATER
SEPTEMBER 2004
NEW ELECTRONIC CONTROL
The look of the escutcheon and insert is unchanged.
The short door electronic dishwashers feature a new elec-
tronic control that replaces the sequence switch and control
on pr

Resumen del contenido incluido en la página 2

Listed below are the control error codes the customer could see or hear and possible fixes: Sensor Models Flashing Light Explanation Possible Cause No light with Key pad not plugged in or model Check and repair or replace the following as required: continuous beeping typing resistor on keypad circuit 1. Keypad plugged in sound board not detected 2. Keypad 3. Control Normal light with Check and repair or replace the following as required: Normal light flashes and control beeping sound 1. Connecti

Resumen del contenido incluido en la página 3

TO ENTER F-1 TEST CYCLE: 165D6290G028 1. Power up unit. 2. Close detergent cup and latch door. 3. Press KEYPAD #9 and KEYPAD #8 simultaneously for MODELS WITH A TURBIDITY SENSOR one second. The control will then step through the test automatically. 10 98 76 542 3 1 TO EXIT F-1 TEST CYCLE: 1. Press START/RESET to skip each step until the end. NOTE: INDICATES KEYPAD USED ONLY ON 2. The control will then exit the test cycle, pump out any SOME MODELS. remaining water and return to normal operation.

Resumen del contenido incluido en la página 4

165D6290G029 MODELS WITHOUT A TURBIDITY SENSOR THIS DISHWASHER IS PROGRAMMED WITH A SERVICE MODE TO AID THE TECHNICIAN IN TROUBLESHOOTING THE DISHWASHER. EACH COMPONENT MAY BE CYCLED TO DETECT IF IT IS FUNCTIONING CORRECTLY. COMPONENTS ARE CYCLED BY PRESSING KEYPADS TO THE LEFT OF THE START/RESET KEYPAD. USE THE MATRIX BELOW TO DETERMINE HOW TO CYCLE EACH COMPONENT. 10 98 76 542 3 1 NOTE: INDICATES KEYPAD USED ONLY ON SOME MODELS. WHILE THIS KEYPAD MAY NOT BE VISIBLE, THE INDICATED SPACE SHOULD