Resumen del contenido incluido en la página 1
Installation Instructions
24-INCH DISHWASHER
Models:
ED24, ID24, MDH24, MDV24, PD24AG, PD24BK
PD24BU, PD, 24GN, PD24SG, PD24TS
Part No. 101891 Rev. J
Resumen del contenido incluido en la página 2
® All specifications are subject to change without notice. Dacor assumes no liability for changes to specifications. © 2007 Dacor, all rights reserved.
Resumen del contenido incluido en la página 3
Table of Contents Before You Begin... ........................................................... 1 Plumbing Preparation ....................................................... 5 Important Safety Instructions ....................................... 1-3 Preparing the Drain .......................................................... 5 Important Information About Safety Instructions .............. 1 Installation Specifications ........................................... 6-12 Safety Symbols and Label
Resumen del contenido incluido en la página 4
Important Safety Instructions General Safety Precautions To reduce the risk of fire, electric shock, serious injury or death when using your appliance, follow basic safety precautions, including the following: WARNING WARNING 1. Do not install or operate this dishwasher if it has 13. Do not operate the dishwasher without the door been damaged, dropped, has damaged electrical completely closed and the toe kick panel in place. conduit or wires or is not working properly. If the 14. Store all d
Resumen del contenido incluido en la página 5
Important Safety Instructions CAUtION Keep the factory installed high loop drain hose in place to ensure proper dishwasher operation. Do not cut, tie, strap or lower it. If it is necessary to lengthen it, install an aftermarket drain extension kit, available at most home improvement stores. Design Specifications Product Specifications Water Pressure 20 to 120 psi (138 - 827 kPa) Technical Water 120°F, minimum Temperature 15 A, 120 Vac, 60 Hz dedicated, grounded, circuit. Power See the model
Resumen del contenido incluido en la página 6
Preparing for Installation IMPORt ANt : Follow all cabinet and countertop minimum WARNING dimensions shown below to insure safe operation. Observe all governing codes and ordinances during Prepare the installation location as shown below. All planning and installation. Contact your local building minimum product dimensions be must met or exceeded department for further information. (see page 3). Dimensions shown provide minimum clearances, unless otherwise noted. The floor must be level a
Resumen del contenido incluido en la página 7
Preparing for Installation Power Supply Preparation Plumbing Preparation • The water pressure must be between 20 and 120 psi (138-827 kPa). The household hot water heater should WARNING supply a minimum of 120°F water to the dishwasher The electrical power supply for the dishwasher must be location for best results. installed only by a licensed electrician as specified below. • Install a water supply valve for the hot water supply It is the owner’s responsibility to ensure that the elec
Resumen del contenido incluido en la página 8
Installation Specifications Verify the Package Contents NOtE: Model ID24 ships without a front panel. It is designed for the installation of an integrated front panel that A matches the surrounding cabinets. • With the assistance of at least one person, remove the dishwasher from the shipping carton. Place the unit to the side of the cabinet opening. • Remove all of the packing materials from inside and B C outside of the unit. DO NOt allow any of the shipping materials, loose screws or p
Resumen del contenido incluido en la página 9
Installation Specifications 4. Remove the dishwasher junction box cover screw. The WARNING junction box is mounted to the dishwasher chassis • Do not install the dishwasher unless the electrical below the door. service provided meets the dishwasher specifications (see page 5). • A qualified technician must complete the installation of this built-in appliance. The owner is responsible to make sure the dishwasher is properly installed. Improper connection of the electrical wiring may cre
Resumen del contenido incluido en la página 10
Installation Instructions Electrical Connection (Continued) 13. Feed the electric wire or cord into the utility hole in the side of the cut-out. Pull all of the slack out of the wire. If the unit is to be connected directly to the house wiring: • With power turned off at the circuit breaker or fuse box, remove the house junction box cover. • Feed the dishwasher wiring into the junction box. Utility Cut-outs Secure the wire with a UL/CSA approved strain relief. • Strip and connect the wir
Resumen del contenido incluido en la página 11
Installation Instructions Plumbing Connections Installing the Unit in the Cabinet 1. Connect one end of the 3/8” flexible braided fill hose to • Make sure the water valve is off before sliding the unit the water supply valve. into the cabinet. 2. Route the hose through the utility access hole in the • Care should be exercised when the appliance is side of the appliance cut-out. Put the unconnected end installed or removed to reduce the likelihood of damage of the hose over a bucket. Turn on
Resumen del contenido incluido en la página 12
Installation Instructions 2. To attach the anti-tip bracket anchors, insert the Installing the Unit in the Cabinet anchoring screws through the 1/2” diameter access (continued) holes inside the dishwashing compartment on the ceiling and the sides, near the front. Make sure that the NOtE: The leg nuts can be removed to make the anchoring screws pass through the anti-tip brackets dishwasher lower. To do so: located on the outside of the dishwasher. • Turn the leg until it comes out of the c
Resumen del contenido incluido en la página 13
Installation Instructions Drain Line Installation 1. Connect the flexible drain line to the air gap or connect it directly to the waste tee or disposal (see below). 2. For installations without an air gap, put a loop in the drain line as shown. 3. Tighten the holding clamp. For installations with an air gap check to make sure the drain line from the air gap to the disposal/drain trap is complete and that the clamps are tight. Create loop and fasten to under side of cabinet 20" Min. Floor I
Resumen del contenido incluido en la página 14
Installation Instructions □ Close and latch the door. Verifying Proper Operation □ You should hear the dishwasher drain and then begin WARNING to fill with water. Wait approximately two (2) minutes, then carefully open the door to verify water is filling the • To ensure a safe and proper installation, the following dishwasher tank. If there is water present, close the checklist should be completed by the installer to door and continue the process. Should the water not ensure that no par
Resumen del contenido incluido en la página 15
Notes
Resumen del contenido incluido en la página 16
Dacor ● 1440 Bridge Gate Drive, Diamond Bar, CA 91765 ● Tel: (800) 793-0093 ● FAX: (626) 403-3130 ● www.Dacor.com
