Resumen del contenido incluido en la página 1
INSTALLATION INSTRUCTIONS
DRAWER DISHWASHER
INSTRUCCIONES DE INSTALACIÓN
DE LA LAVAVAJILLAS DE CAJÓN
INSTRUCTIONS D’INSTALLATION
LAVE-VAISSELLE À TIROIR(S)
Table of Contents/Índice/Table des matières..................................................................2
IMPORTANT:
Save for local electrical inspector's use.
Installer: Leave installation instructions with the homeowner.
Homeowner: Keep installation instructions for future reference.
IMPORTANTE:
Guarde para tenerlas a disposición del
Resumen del contenido incluido en la página 2
TABLE OF CONTENTS DISHWASHER SAFETY.............................................................................3 Route Water Supply Line and Drain Hose ...........................................10 Connect Water Supply Line and Drain Hoses .....................................11 INSTALLATION REQUIREMENTS ...........................................................4 Tools and Parts.......................................................................................4 Make Electrical Connection..
Resumen del contenido incluido en la página 3
DISHWASHER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.” These words mean: You can be killed or seriously injured if you don't immediately
Resumen del contenido incluido en la página 4
INSTALLATION REQUIREMENTS Parts Supplied Check that all parts are included. Tools and Parts Gather the required tools and parts before starting installation. C Read and follow the instructions provided with any tools listed D B here. A Tools Needed ■ Pliers ■ 10" adjustable wrench ■ Phillips screwdriver ■ Utility knife ■ Flat-blade screwdriver ■ Level E F ■ ³⁄₁₆" and ¼" nut drivers or ■ Cordless drill hex sockets ■ ¹⁄₈" drill bit ■ Measuring tape or ruler ®† ■ Security T-20 TORX ■ 1½" hole sa
Resumen del contenido incluido en la página 5
Preferred Utililty Area Product Dimensions 24" 23³⁄₈" A (61 cm) (59.5 cm) ¹⁄₂" (1.3 cm) 25" (63.5 cm) B 33³⁄₄" (85.7 cm) 8" (20.3 cm) A. Left-hand or right-hand drain and water connection route B. Left-hand or right-hand electric connection route NOTES: ■ All holes should be drilled at 1½" (3.8 cm) diameter. ■ If the cabinet is wood, sand the hole until smooth. If the cabinet is metal, cover the hole with a grommet (Part Number 19¹⁄₄" 1¹⁄₂" 302797) (provided with power supply co
Resumen del contenido incluido en la página 6
Direct Wire Connection ■ Use flexible, armored or nonmetalic sheathed, copper wire Electrical Requirements with grounding wire that meets the wiring requirements for your home and local codes and ordinances. ■ Use strain relief method provided with house wiring junction WARNING box or install a UL-listed/CSA-approved clamp connector to the house wiring junction box. If using conduit, use a UL-listed/CSA-approved conduit connector. Power Supply Cord Connection Use Power Supply Cord Kit (Part
Resumen del contenido incluido en la página 7
INSTALLATION INSTRUCTIONS 2. Drill 1½" (3.8 cm) diameter holes for drain and water hoses and electrical wiring as shown. Holes should be placed WARNING ½" (1.3 cm) from back wall. A Electrical Shock Hazard ¹⁄₂" Disconnect electrical power at the fuse box or circuit (1.3 cm) breaker box before installing dishwasher. 25" Failure to do so can result in death or electrical shock. (63.5 cm) B 1. Disconnect power. 2. Turn off water supply. 8" (20.3 cm) Unpack Dish Drawer WARNING A. Choos
Resumen del contenido incluido en la página 8
S ST TA ART T ELAY 4 8 HOURS Option 1: Solid surface countertop installation ■ Install second set of mounting brackets 33½" (85 cm) from Prepare Dishwasher floor. If needed, drill ¹⁄₈" pilot holes in cabinet. WARNING 33¹⁄₂" Tip Over Hazard (85 cm) Do not open dishwasher drawer until inside cabinet opening. Doing so can result in death or serious injury. WARNING Excessive Weight Hazard Option 2: Wood countertop installation Use two or more people to move and install ■ Prepare dishwasher by f
Resumen del contenido incluido en la página 9
3. Adjust leveling legs based on the cabinet opening Option 1: Right-hand side utility route measurement and the chart below. H : X H : X 33⁷⁄₈" (86 cm) : 0" 34¹⁄₂" (87.6 cm) :⁵⁄₈" (1.6 cm) 34" (86.3 cm) :¹⁄₈" (0.3 cm) 34⁵⁄₈" (87.9 cm) :³⁄₄" (1.9 cm) Route wire through 1½" (3.81 cm) hole located 8" (20.32 cm) above the floor. 34¹⁄₈" (86.7 cm) :¼" (0.6 cm) 34³⁄₄" (88.3 cm) :⁷⁄₈" (2.2 cm) 34¹⁄₄" (87 cm) :³⁄₈" (1 cm) 34⁷⁄₈" (88.6 cm) :1" (2.5 cm) After routing the electrical wire through the righ
Resumen del contenido incluido en la página 10
Route Water Supply Line and Drain Hose 1. Connect water supply line to water valve on dishwasher. Option 1: Right-hand side utility access ■ For right-hand routing, place the water supply line in the clips. 2. Slide clamp onto drain hose, and then push hose into “Y” connector until fully seated. Several clicks will be heard. ■ Route drain hose on clips on bottom/back of unit. 3. Slide clamp into position over the “Y” connector. Option 2: Left-hand side utility access ■ For left-hand routing,
Resumen del contenido incluido en la página 11
■ Route water supply line and drain hoses into the cabinet. 2. Slide clamps onto drain hoses (Figure A). Do not cut drain hoses. 3. Push hose into drain connector until fully seated (Figure B). Several “clicks” will be heard. 4. Slide clamp into position (figures C and D). A B C D ■ Slide dishwasher partway into the cabinet opening. Allow for access to the electrical terminal box. 5. Connect the drain hose using one of the following options: Option 1: Waste disposer no drain air gap A C Conne
Resumen del contenido incluido en la página 12
Option 2: No waste disposer and drain air gap Make Electrical Connection A WARNING C B Electrical Shock Hazard Disconnect electrical power at the fuse box or circuit breaker box before installing dishwasher. A. Drain air gap B. Drain hose connector Failure to do so can result in death or electrical shock. C. Waste 1. Remove screw securing the electrical box cover. Remove Option 3: Waste disposer and drain air gap cover. A B C A. Drain air gap B. Drain hose connector C. Waste Option 4: No waste
Resumen del contenido incluido en la página 13
2 2 3. Tighten the conduit connector and strain relief screws. 6. Reinstall electric box cover with all wires contained inside the terminal box. WARNING Electrical Shock Hazard Electrically ground dishwasher. Connect ground wire to green ground connector in terminal box. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 4. Connect wires as follows using twist-on connectors sized to connect direct wire to 16 gauge dishwasher wir
Resumen del contenido incluido en la página 14
1 1 5. Check left to right level by placing the level on the top of the 8. Attach the toe kick bracket to the frame. drawer. Check front to back level by placing level on the slide rails. 9. Place the trim strip into the toe kick bracket. 6. Adjust legs with a ³⁄₁₆" socket wrench to level the dishwasher. A 10. Attach the toe kick bracket on the opposite side. A. Adjust legs. 7. Rest the trim strip on the floor and mark the trim at the top of the frame flange height. Pick the closest groove to
Resumen del contenido incluido en la página 15
1 2 1 2 2 11. Place the flexible side trim strips on both sides as shown. Option 1: Solid surface countertop Attach dishwasher to the side cabinet mounting brackets (installed earlier). A A. Attach dishwasher to side cabinet mounting brackets. Option 2: Wood countertop Secure Dishwasher Attach the dishwasher to the countertop using the folded over 1. Remove top drawer (same procedure as followed to remove mounting tabs located on the top of the dishwasher. bottom drawer) and set drawer on bot
Resumen del contenido incluido en la página 16
2. Pull slide rails forward until they snap into position. ON ON OFF OFF OFF 3. Push top drawer in and repeat above steps for bottom drawer. 6. Select the Rinse Only cycle and press START/RESUME. Allow 4. In the cabinet under the sink, coil excess drain hose and wrap the dishwasher to fill, rinse and drain. Check for leaks. If leaks with a zip tie. are found, secure the connection and repeat this step. If you need Assistance or Service: WARNING Please reference the “Assistance or Service” sec
Resumen del contenido incluido en la página 17
CUSTOM PANEL INSTALLATION INSTRUCTIONS 2. Using a pencil, mark the centerpoints for the 2 panel fastener pilot holes and 6 pilot holes needed for the panel. Custom Drawer Panel If you plan to install a custom wood panel, you will need to create A 1¹⁄₂" 11¹⁄₄" 11¹⁄₄" the panel yourself or consult a qualified cabinetmaker or (3.8 cm) (28.5 cm) (28.5 cm) carpenter. See dimension drawings for panel specifications. 2¹⁄₂" 8¹⁄₈ " 8¹⁄₈" IMPORTANT: (6.3 cm) (20.7 cm) (20.7 cm) 8" ■ The thi
Resumen del contenido incluido en la página 18
Custom Wood Panel Mount the Custom Panel Custom Decorative Panel Only 1. Remove the tape from the green ground wire on the custom decorative panel. The end of the green ground wire is factory- attached to the custom decorative panel. 2. Attach the ring connector end of the green ground wire on the custom decorative panel to the ring connector and ground screw on the dishwasher drawer intermediate panel. 2. To secure the custom panel onto the drawer, push the custom panel down until the top o
Resumen del contenido incluido en la página 19
SEGURIDAD DE LA LAVAVAJILLAS Su seguridad y la seguridad de los demás es muy importante. Hemos incluido muchos mensajes importantes de seguridad en este manual y en su electrodoméstico. Lea y obedezca siempre todos los mensajes de seguridad. Este es el símbolo de advertencia de seguridad. Este símbolo le llama la atención sobre peligros potenciales que pueden ocasionar la muerte o una lesión a usted y a los demás. Todos los mensajes de seguridad irán a continuación del símbolo de advertencia d
Resumen del contenido incluido en la página 20
REQUISITOS DE INSTALACIÓN Piezas suministradas Verifique que estén todas las piezas. Piezas y herramientas Reúna las herramientas y piezas necesarias antes de comenzar la C D instalación. Lea y siga las instrucciones provistas con cualquiera B A de las herramientas enlistadas aquí. Herramientas necesarias ■ Pinzas ■ Llave de tuercas ajustable de 10" ■ Destornillador Phillips E F ■ Cuchillo para uso general ■ Destornillador de hoja plana ■ Nivel ■ Llave de tuercas o llave ■ Taladro inalámbric
