Resumen del contenido incluido en la página 1
Dishwasher
DW12-LBE
Instructions for Use
en
012050
Resumen del contenido incluido en la página 2
Safety Is a Good Habit to Develop - Do not touch the heating element during or after a wash cycle. NOTICE - Do not lean or sit on the door when it is open as this could over Carefully read the instructions contained in this manual, as they turn the dishwasher. provide important information which is essential to safe and proper - If the appliance malfunctions, turn off water supply to the appli- installation, use and maintenance of the appliance. ance and disconnect the plug from the wall soc
Resumen del contenido incluido en la página 3
Close-up View (Interior) Upper Rack A Washing Filter F Rack Height Adjustor B Detergent and Rinse Aid Dispenser G C Top Spray Arm Salt Container Cap H D Lower Rack Third Sprayer I Bottom Spray Arm E Specifications 60cm Width 58cm Depth 82cm Height Capacity 12 standard place settings Mains Water Pressure 0.03-0.6MPa Power Voltage 220-240V~ 50Hz Total Absorber Power 2150W .2. GB
Resumen del contenido incluido en la página 4
Salt Salt Adjusting Salt Consumption The hardness of the water varies from place to place. If hard The dishwasher is designed to allow for adjusting the amount of water is used in the dishwasher, deposits will form on the dishes salt consumed based on the hardness of the water used. This is and utensils. intended to optimise and customise the level of salt consumption The appliance is equipped with a special softener that uses a salt so that it remains at a minimum. Your local Wate
Resumen del contenido incluido en la página 5
Detergent and Rinse Aid Detergent Rinse Aid Detergent specifically intended for use with dishwashers must This product makes dishes sparkle and helps them to dry with- be used. The dispenser must be refilled before the start of each out spotting. The dispenser is located on the inside panel of the wash cycle following the instructions provided in the "Wash Cycle door and should be filled after "low rinse aid indicator light" (M) Table." The detergent dispenser is located on the in
Resumen del contenido incluido en la página 6
Loading the Dishwasher Before placing the dishes in the dishwasher, remove larger food Lower Rack Upper Rack particles to prevent the filter from becoming clogged, which re- sults in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they are soaked before washed. This will eliminate the need for extra wash cycles. Pull out the rack to load the dishwasher. How to use the lower rack We recommend that you place the most difficult to cle
Resumen del contenido incluido en la página 7
Starting the Appliance Starting a wash cycle Setting the Wash Cycle with a Delayed Start Time After having completed all of the installation steps in the preced- By pressing the "D" button (see close-up view-'Control panel"), ing paragraphs, turn on the water all the way and press the ON- select ,and the selection cursor turns on,then pressing the OFF button (A) located on the control pannel. The appliance is "C" button ,the start of wash can be delayed for between 1 to 12 on.
Resumen del contenido incluido en la página 8
Energy Saving Tips - Use the right amount of detergent: if you use too much detergent, - It is important to try and run the dishwasher when it is fully the result will not be cleaner dishes, but, rather, a greater nega- loaded in order to save on energy. To prevent odours from form- tive impact on the enviroment. ing and food from caking onto the dishes, you can run the soak - There is no utility in rinsing dishes, cookware and utensils be- cycle. fore placing them in the dishwasher. - Cho
Resumen del contenido incluido en la página 9
Wash Cycle Table Cycle Selection Information Description of Cycle Cycle Detergent Rinse Aid Extra drying Pre-wash with hot water. Very dirty dishes, pots and Extended wash at 70 °C. pans. (not to be used with deli- 30g Rinse with cold water. cate items) Rinse with hot water . Heavy Duty Drying. Pre-wash with cold water. Normal dirty dishes, pots and Extended wash at 55 °C. Rinse with cold water. 30g pans. standard daily cycle. Rinse with hot water . Normal Wash Drying. P
Resumen del contenido incluido en la página 10
Cleaning and Special Maintenance Cleaning the Spray Arms Filter Assembly It may happen that food particles become encrusted on the For best performance and results, the filter assembly must be sprayer arms and block the holes (see "Close up view interior", cleaned. letters C-E ). Check the sprayer arms periodically and clean them The filter efficiently removes food particles from the wash water, when needed. allowing it to be recirculated during the cycle. For this reason, it Cleaning the Water
Resumen del contenido incluido en la página 11
Installation Positioning the Appliance The connection must be made to the hot water line following the Position the appliance in the desired location. The back should same procedures as those for the connection to the cold water rest against the wall, and the sides along the adjacent cabinets line. or wall. The dishwasher is equipped with water supply and drain Anti-Flooding Protection hoses that can be positioned to the right or the left to facilitate The dishwasher is equipped with a system t
Resumen del contenido incluido en la página 12
Installation Diagram A C N IS 1 B 1 L 2 3 34 5 6 1 2 7 8 CnL1 D J E 4 H F G 1 M IAQS D-ED 1/2 2 ML 1 2 2 3 C S CnP3 1 1 CnP2 2 I AQS 12 3 11 4 10 1 5 6 9 8 7 8 7 6 5 4 SCHEDA DI P 3 POTENZA K e 2 CnP1 CONTROLLO 1 6 O 5 ISS 4 3 L 2 1 N M RELE' A.Wiring box B.Door switch C.Water level switch D.Drain motor E.Overflow switch F.Half wash switch G.Softer valve H.Dispenser valve I.Aquastop inlet valve J.Washing motor K.Temperature limiter L.Heater M.Relay N.Sensor temperature O.Salt missing switch P.Ri
