Manual de instrucciones de 3Com PhazerLInk Upgrade Kit Z340PL

Resumen del contenido incluido en la página 1

Instruction Sheet
®
Phaser 340
®
Phaser 340 Plus
PhaserLink™ Upgrade for the Phaser 340 —
Upgrade Kit Z340PL
This kit provides the components to give your printer PhaserLink™ capabilities. With PhaserLink
firmware installed in your printer you can monitor and administer your printer using a World Wide Web
browser. Printer’s serial-numbered BCxxxxx and above already have PhaserLink software installed.
Network card firmware version. Your printer must have Phas

Resumen del contenido incluido en la página 2

PhaserLink™ Upgrade for the Phaser 340 — Upgrade Kit Z340PL Important! About the printer’s IP address Upgrading the printer will erase the printer’s IP address from the printer’s non-volatile memory. Therefore you should print the printer’s configuration page, which lists the printer’s IP address, before upgrading the printer. 1. While the printer is idle, press the Menu button to scroll to the Help pages menu item. 2. Press the arrow button to scroll to the

Resumen del contenido incluido en la página 3

PhaserLink™ Upgrade for the Phaser 340 — Upgrade Kit Z340PL Upgrading the printer Removing the main board Caution Do not tilt the printer. If you must move the printer to access the rear of the printer to install the upgrade, be careful not to tip or tilt the printer. Hot, liquid ink in the printer could spill and damage the printer. Once the printer is turned off, it takes 30 minutes for the ink to cool to its solid state. Wait and allow the ink to cool. 1. Turn off the pr

Resumen del contenido incluido en la página 4

P71 PhaserLink™ Upgrade for the Phaser 340 — Upgrade Kit Z340PL Replacing the PostScript code ROM SIMM 3. Remove the currently installed PostScript code ROM SIMM in connector P71 by spreading apart the hook-like metal pawls securing each end of the SIMM in its connector. Remove the SIMM. To protect the SIMM from static electricity, slip it immediately inside an anti-static bag. 4. Insert the new PostScript code ROM SIMM in connector P71 (a), and tilt the SIMM down until it l

Resumen del contenido incluido en la página 5

PhaserLink™ Upgrade for the Phaser 340 — Upgrade Kit Z340PL Replacing the print engine ROM 5. Locate the print engine ROM on the main board. Note Some products may use a standard ROM IC chip while others may use an adaptor circuit board (as show in the illustration below). Either part type can be substituted for the other on this main board. Also note that there are two versions of the new print engine ROM: If you ordered the upgrade kit Z340PL Option 1, you have the ROM

Resumen del contenido incluido en la página 6

PhaserLink™ Upgrade for the Phaser 340 — Upgrade Kit Z340PL 8. Check for proper orientation and alignment of the pins; pin 1 should be oriented toward the network card end of the main board. Also ensure the bins are not bent. Gently install the new ROM in its socket. Carefully, inspect the ROM to ensure all the pins are properly inserted in the socket and are not bent or mis-installed. 9. Reinstall the main board into the printer; tighten the thumbscr