Manual de instrucciones de Ives Offset Top Pivot 7245F

Resumen del contenido incluido en la página 1

Installation Instructions
7244F and 7245F
1-1/2” Intermediate Pivot
Door leaf
Right hand
installation shown;
left hand opposite
Frame
leaf
Right hand Pivot pin height Left hand
installation installation
adjuster
Pivot
cap
5/32” Allen
wrench
1. Prepare and mortise hinge stile of door and hinge side jamb to receive pivot set. Determine
pivot location using dimensions on reverse side. The pivots are handed and must match
hand of door. To determine hand of door and proper pivot position, see diagra

Resumen del contenido incluido en la página 2

NOTE ! It is very important for installer to verify that center line of intermediate pivot point lines up with center line of top and bottom pivot points before final installation. Both door and frame pivot leafs located from face of door. Intermediate pivot should be evenly spaced between top and bottom pivots. Heel edge of door must be beveled 1/8” in 2”. Frame Leaf Door Leaf 1-1/16” 9/16” Reference line 27 mm 14 mm Face of door C 3/8” L 7/16” 10 mm 11 mm C L 1-1/2” 38 mm 1-1/2” 5/16” 38 mm Fa