Manual de instrucciones de Gianni Industries ST-630E

Resumen del contenido incluido en la página 1

ST-630E Stand-Alone Access Control
Operation Manual
Ⅰ Features
Master Card and Codes
Auto Reset Function
Security System Setting/ Release
Synchronize with Security System
Entering/Exiting Programming Mode: Only Proximity
Codes + Proximity, Codes or Proximity
Door Status Monitor Function
Anti Pass Back Function
Emergent Access Alarm, Time Delay Alarm and Forced
Door Alarm output
Dual relays programmable On/Off or pulsed or latched mode
LED Indicator to distingui

Resumen del contenido incluido en la página 2

Ⅲ Indicators Status and Default Value Beep & LED indication: Mode Signal Status Yellow(flashing Power-on, stand-by slowly) Normal Green On Valid entry, door relay active Warning, invalid card or code, tamper, alarm relay Red LED active Yellow(flashing Enter Programming Mode. Quickly) Programming Red flashing Card read, or clear the memory Quickly) Invalid card 、keypress 、entry program mode 1 Beep Normal 2 Beep Invalid cards, Mistake Codes Beep 1 Beep Vali

Resumen del contenido incluido en la página 3

Ⅳ Operation Instruction: *xxxxxx# Enter Program Mode ，Enter 6-digital Codes ，(Default 123456) * # Exit Program Mode 01*xxxxxx xxxxxx # Change Default Password, Press twice new 6-digital Codes 02*xxxx # Controller Station Setting ［001-254 ］ 05*xxx# Access only with the password, 0000-Unavaliable (Default, 0000) 10*xxxx*XXXXXXXXXX # Adding or Revised the Cards No. Slot Position =00001~01000 and enter the 10 digital Cards No. 12*XXXX*XXXXX# Adding the batch series Cards No.. XXXX=the b

Resumen del contenido incluido en la página 4

Controller and Reader can open different doors. 34*99# Reset the function of Anti Pass Back. x=1= access record to duty 35*x# (for connecting x=0= access record Not to Duty controller) (x= default is 0) 38*x# x=0 Green LED is controlled by Controller x=1 Green LED is controlled by external system (The second Relay contact to the Door Status and negatron (-) ， Green LED flash can synchronize with Security System. Reset to Default, and clean the controller memory to the factory

Resumen del contenido incluido en la página 5

Copyright All Rights Reserved. Page 5 of 5 P-MU-ST-630 Ver. A Publish: 2009.01.08