Resumen del contenido incluido en la página 1
Observation System
AOS58
AOC-75 Features
- High resolution, 1/3” CCD Camera
- Compact/Lightweight Aluminum Die
Cast Body
- Waterproof Housing
- Waterproof Microphone
- Waterproof Normal/Mirror Image
Switch
- Optional Wind deflector
AOM-58 Features
- 5” Monochrome Monitor
- Dual camera Input
- Brightness/Contrast/Day-Night Controls
- Volume Control for Internal/External
Speaker
A B
- Power/Stand By Button
- Back-lit Front Panel Controls
OCA-80 Features
- 20 Meter Cable with Waterproof
Connection
Resumen del contenido incluido en la página 2
AOS-58 IMPORTANT: The Voyager Observation system (AOS58) has been designed to provide years of trouble free operation. Please read this manual thoroughly. This manual contains instructions to ease the installation of the camera and monitor. The Voyager Observation system is a supplement to the standard rear view mirror systems, and will provide additional rear view vision when installed and maintained properly. The Voyager observation System is not intended to in any way be a substitute for
Resumen del contenido incluido en la página 3
4 Use without Wind Deflector Screws (#8-32 UNC x 7.5) 4 Use with Wind Deflector Screws (#8-32 UNC x 9.0) AOM-58 Monochrome Monitor Qty. 1 5” Monitor 1 Snap-On Sun Visor 1 Monitor Bracket 1 Power Harness with locking connector 1 Range marker 4 Thumb screws (M5 x 15) with plain washer and spring washers 4 Attachment screws with washers (M5 x 12) OCA-80 Cable Qty. 1 20 meter cable with waterproof connector. Oil, gas, and grease resistant. UV stable Documents 1 Operators manual BEFORE INSTALLATION:
Resumen del contenido incluido en la página 4
2. Attach camera to bracket using 8-32 UNC screws provided. Adjust angle as indicated in Figure 2. Use rear or end of bumper as reference point. 3. Wind deflector may be installed. This deflector is designed to reduce the build-up of dust, dirt and moisture on the camera lens. (See Figure 3). AOM-58 MONITOR 1. Attach monitor inside vehicle in a location convenient to the driver (e.g. center of dash, overhead, or in dash). 2. Use a compression plate to attach the monitor bracket to the dash or
Resumen del contenido incluido en la página 5
4. To increase protection of cable, place all excess wire and extension cable in convoluted tubing. 5. Do not twist camera cable, do not cut pigtail, or cable. WIRING CAMERA AND MONITOR 1. See wiring diagram for connections to ignition, ground, and backup circuit. (See Figure 6) 2. Wiring camera: Drill a 19mm /3/4” diameter hole into the vehicle body near the camera and bracket. Connect camera connector to extension cable in vehicle. 3 Push extra cable into vehicle, (be careful not to kink cabl
Resumen del contenido incluido en la página 6
“Day/Night” switch does not achieve the most desirable picture. 5. Brightness: Variable control of brightness. Should be adjusted if the “Day/Night” switch does not achieve the most desirable picture. 6. Volume: Variable control of internal speaker and external speaker volume. REAR OF MONITOR: See page 12.
Resumen del contenido incluido en la página 7
3. Affix the “STOP” marker on the monitor screen over the image of the rear view bumper to locate the rear bumper. 4. The monitor screen is now “calibrated” for distances behind the vehicle of 3 feet, 6 feet and 9 feet. 5 Camera Assembly Camera Assembly Location Location, High- High-Mounted, Centered Mounted Centered
Resumen del contenido incluido en la página 8
.534 1.010 Camera Mounting Hole Pattern Figure 1 6 2.601 1.401 5-0.165 Dia. Holes
Resumen del contenido incluido en la página 9
Approximately 80° Field of View Back of Vehicle, View at Monitor Screen Figure 2 7 80°
Resumen del contenido incluido en la página 10
Included Wind Deflector- Optional Installation Screw for use w/Wind deflector #8-32 x 3/8" 4mm x .7mm x 25.4mm Phillips Hex Head Screw w/Washers 4mm x .7mm Hex Nuts Screw for use Without Wind Deflector #8-32 x 5/16" 4mm x .7mm x 25.4mm Phillips Hex Head Screw w/Washers 4mm x .7mm Hex Nuts Figure 3 8
Resumen del contenido incluido en la página 11
Dashboard or Overhead Steel Plate Reinforcement (Recommended for Secure Mounting) Figure 4 9 Spring Washer Plain Washer
Resumen del contenido incluido en la página 12
2.250 2.677 Monitor Mounting Hole Pattern Figure 5 10 6.240 5.275 110.0° 5-0.236 Dia. Holes 20° 20°
Resumen del contenido incluido en la página 13
18 TEW RED (12V) (MALE BULLET DISCONNECT) 18 TEW BLK (Ground) (FEMALE BULLET DISCONNECT) 18 TEW BLU (Reverse Trigger) (STRIPPED AND TINNED) 18 TEW YEL (Battery) (STRIPED AND TINNED) EMI FERRITE CORE REAR OF MONITOR 3A 1A WIND DEFLECTOR- OPTIONAL INSTALLATION 20 METERS GROMMET TO SEAL THROUGH VEHICLE INTERIOR WATERPROOF CAMERA CONNECTION TO MONITOR TO MONITOR CAMERA "A" INPUT Figure 6 11
Resumen del contenido incluido en la página 14
MONITOR FRONT VIEW A B 1 2 3 4 5 6 MONITOR REAR VIEW 4 3 2 1 Monitor Operating Controls and Connections 12
Resumen del contenido incluido en la página 15
Camera Features 13 "NORMAL" SWITCH MIRROR/ MICROPHONE
Resumen del contenido incluido en la página 16
MARKER’S EXAMPLE Figure 8 14 9 FT. WIDTH OF VEHICLE 6 FT. 3 FT. INDICATOR
Resumen del contenido incluido en la página 17
SPECIFICATIONS: AOS58 Rated Voltage 12VDC, Negative Ground System, Operating Voltage 11 to 30 VDC 1 Current Consumption 1.5 Amperes Camera AOC75 Sensitivity 0.1Lux Camera Signal System NTSC Image sensor 1/3” B/W CCD w/electronic auto-iris 270K picture elements Viewing Angle 110° (H), 80° (V) (approx.) 2.44” (W) x 1.50” (H) x 1.96” (D) Outer Dimensions 6.20cm (W) x 3.81cm (H) x 4.98cm (D) Weight 0.8 lbs. 0.36 Kg. DISCLAIMER: The use of the VOYAGER observation does not guarantee or promise that th
Resumen del contenido incluido en la página 18
15
Resumen del contenido incluido en la página 19
Optional Product List: Televisions AVT-988 9” Color Television with Remote (12V) AVT988 AVT-1498 13” Color Television with Remote (12V) AVT1498 VCP and DVD Player’s For use with TV’s and LCD AVP-7000 Video Cassette Player (12V) AVP7000 AVP-7285 Video Cassette Player (12V) AVP7285 Single Disc DVD Player DVD2101 Headphones Headphones with Pivoting Earcups HP175 Headphones with Volume Control on Cord HP275 Studio Quality Headphones HP375 Miscellaneous Remote Controls Please Call Wallmount Family Ra
Resumen del contenido incluido en la página 20
Or visit our website at www.asaelectronics.com 16 INSTALLATION NOTES: ________________________________________________________________________ ________________________________________________________________________ ________________________________________________________________________ ________________________________________________________________________ ________________________________________________________________________ _________________________________________________________________
