Resumen del contenido incluido en la página 1
St Sta ar rt t
Here!
Here!
Quick Start Guide - next page ...
DG72
Digital Spread Spectrum
provides the longest range,
the clearest sound
and the best privacy.
QUICK
START GUIDE
Resumen del contenido incluido en la página 2
INSTALLATION & SAFETY Choosing the best location for your telephone. This symbol indicates When choosing a location for your phone there are a number of appliances the important operating phone should be not be near, and area’s you should avoid. and servicing Always CHOOSE - instructions. fully a central location extend AVOID - antenna Television sets and AVOID - other electronic Microwave appliances ovens AVOID - Moisture AVOID - Computers AVOID - Moisture CHARGE - the new phone DON’T - AVO
Resumen del contenido incluido en la página 3
This page is a very condensed version of your owners manual. It is designed to allow you to get your phone installed and operating as quickly as possible - however it does not attempt to explain any of the advanced features of your phone. St Sta ar rt t Here! Here! Installation CONNECTIONS Plug the AC adaptor cord into base unit and then into a 240V AC outlet. Connect the telephone cord to the phone, then plug into the phone jack in your home. Place handset on base. Select ringer and volume opti
Resumen del contenido incluido en la página 4
Charging the Battery Using the Phone Installing the Handset Batteries Adjusting the Handset Earpiece Volume Press battery cover to release. During a conversation, you can adjust the Slide cover off. earpiece volume by pressing the vol ▼ ▼ ▼ Louder — press the vol ▼ Softer — press the vol To Make a Call talk Align the plastic connector of the Press (on the handset) and listen speaker battery with it’s socket and press for dial tone or press (on the firmly until it clicks into place. base unit)
Resumen del contenido incluido en la página 5
CONTENTS Precautions . . . . . . . . . . . . . . . . . . . . . . . Inside Front Cover Controls And Functions . . . . . . . . . . . . . . . . . . . . . . . . . .2 Introduction Introduction Welcome . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Included In Your Package . . . . . . . . . . . . . . . . . . . . . . . . 5 Installing and Installing and Adjusting your Phone Adjusting Desk/Tableto
Resumen del contenido incluido en la página 6
CONTROLS & FUNCTIONS 16 17 1. Battery Compartment A. speaker Button 2. Handset Antenna B. Base Microphone talk 3. Button C. Power LED redial 4. / pause Button D. In use/Hold/Mute LED 5. Talk LED E. Charge LED 6. Battery Low LED redial F. / pause Button ▼ 7. c.wait Button ▼ G.Volume Button 8. Numeric Keypad H. flash Button 9. flash Button I. mute Button int 10. Button J. int Button 11. mem Button K. Star Button ▼ ▼ 12.Volume Button L. hold Button 13. Handset Microphone M. mem Button 14. Hash Butt
Resumen del contenido incluido en la página 7
2 5 6 talk batt low talk c.wait 3 7 redial/p 4 abc def 12 3 ghi jkl mno 4 5 6 8 pqrs tuv wxyz 7 8 9 14 0# 15 1 * flash mem int 10 9 vol 11 12 13 P Q O abc def 12 3 ghi jkl mno 4 5 6 pqrs tuv wxyz 7 8 9 N K 0# * J M mute int mem hold I L flash redial/p vol F H G charge E in use/hold/mute speaker A mic power D C 3 B
Resumen del contenido incluido en la página 8
WELCOME Congratulations on your purchase of the Uniden DG72 cordless telephone. This phone is designed for reliability, long life, and outstanding performance utilising the latest in 900 MHz Digital Spread Spectrum Technology. FEATURES ● 15 channels (Aust), 7 channels (NZ) ● 900 Digital MHz Spread Spectrum Technology ● Speakerphone ● Dual Keypad ● 40 Enhanced Memory Dial Locations (16 digits maximum per memory) ● 32 Digit Redial ● Redial, Flash, Pause, Mute and Hold ● Tone Dialing ● Call Waiting
Resumen del contenido incluido en la página 9
INTRODUCTION talk batt low talk c.wait redial/p 12 abc 3 def 4 ghi 5 jkl 6 mno pqrs tuv wxyz 7 8 9 0# * flash mem int vol INCLUDED IN YOUR PACKAGE To get the most from your phone, please read this owner’s manual thoroughly. Handset Base Be sure to complete and mail the product registration form. AAD 900S Rechargeable Battery ! AC Adaptor If any of these items are missing or damaged, contact your place of purchase. Long Telephone Wall Mount Adaptor Cord/Plug 2 x Memory Stickers Wall Mounting Scre
Resumen del contenido incluido en la página 10
WALL INSTALLATION 1. Insert two mounting screws (with their appropriate anchoring device) into the wall Be careful not to insert the mounting screws 100mm apart. Allow about 5mm between the into possible electrical wall and screw heads for mounting the phone. hazards such as cables, wiring, or pipes. 2. Snap the desktop/wall mount adaptor into the bottom of the base as shown. 3. Plug the AC adaptor cord into the 9V DC input jack on the back of the base. 4. Put the AC adaptor cord
Resumen del contenido incluido en la página 11
INSTALLATION & ADJUSTING 5. Plug one end of the telephone cord into the TEL LINE jack on the back of the base. Plug the other end into a telephone jack. 6. Align the mounting slots on the base with the mounting screws on the wall. Push in and down until the phone is firmly seated. 7. On the base, pull the handset retainer out of the slot. Rotate clockwise 180°. 8. Flip the retainer from front to back. Slide it back into the slot so that the lip of the r
Resumen del contenido incluido en la página 12
INSTALLING & CHARGING THE BATTERY PACK ! Installing the Battery Pack The rechargeable battery pack must be fully charged before using your phone for the first time. Before plugging the phone line into your new phone, you must The battery connector charge the battery for approximately 15-20 hours without interruption. will fit together only one way. Make sure the 1. Remove the Handset connector is properly battery cover. aligned. Use only the 2. Plug the battery’s cable into t
Resumen del contenido incluido en la página 13
INSTALLATION & ADJUSTING CLEANING THE BATTERY CONTACTS To maintain a good charge, clean all charging contacts on the handset and base about once a month. Use a pencil eraser or other contact cleaner. DO NOT use liquids or solvents; you may damage your phone. ADJUSTING THE VOLUME CONTROLS ▼ Handset ringer volume ▼ ▼ Press the vol or key on the handset to set the handset ringer volume. There are two ringer volume settings; high and low. ▼ Handset earpiece volume There are four volume settings f
Resumen del contenido incluido en la página 14
INSTALLING THE BELTCLIP ▼ To attach the beltclip. Insert the beltclip into the empty slot and press down until it clicks. ▼ To remove the beltclip Pull back on the release tab and lift the beltclip up. talk batt low talk c.wait redial/p abc def 12 3 4 ghi 5 jkl 6 mno 7 pqrs 8 tuv 9 wxyz 0# * flash mem mute vol AUTOMATIC DIGITAL CODE SECURITY To prevent other parties from making unauthorised calls on your phone line, a digital code was added to the DG72. Your pho
Resumen del contenido incluido en la página 15
USING YOUR PHONE MAKING AND RECEIVING CALLS ▼ Basic phone operation Handset On Base Handset Off Base Base Only talk batt low talk c.wait redial/p 12 abc 3 def 4 ghi 5 jkl 6 mno 7 pqrs 8 tuv 9 wxyz 0# * flash mem int vol flash redial/p vol charge in use/hold/mute To answer speaker power Pick up handset. a call Press talk Press . speaker . talk speaker 1. Press . 1. Press . 1. Pick up the handset. 2. Listen for the dial 2. Listen for the dial talk 2. Press . To make tone. tone. 3. Listen for
Resumen del contenido incluido en la página 16
CALL WAITING ! ▼ For Australian Version Using the c.wait feature The c.wait procedure toggles between the incoming Please call your local telephone service provider to check the availability of this and original call (vice versa). service in your area. The c.wait procedure will 1. While talking you hear the Call Waiting signal. drop the current call and pick up the incoming call or call 2. Press c.wait button. on hold. 3. The existing call is placed on hold. c.wai
Resumen del contenido incluido en la página 17
USING YOUR PHONE MUTE To use the mute feature during a conversation, 12 abc 3 def press mute . The other party will not be able to ghi jkl mno 4 5 6 hear you although you can hear them. To disable pqrs tuv wxyz 7 8 9 the mute feature, press mute again. 0# * mute int mem hold flash redial/p vol h INTERCOM ▼ Intercom from the Base Unit int int 1. Press on the base unit. (If there is no answer press again to disconnect). 2. Press int on the handset to answer the intercom. 3. Speak into the mou
Resumen del contenido incluido en la página 18
2. At the base unit, press int to answer the page. An intercom link is now established between the handset and the base unit. Speak into the microphone. speaker 3. Press on the base unit to establish communications between the calling party. ▼ Transferring a call from the Base Unit to the Handset 1. During a call, press int on the base unit, the call is placed on hold automatically and the handset is paged. (If there is no answer press int again to return to the call on hold). int 2. At the han
Resumen del contenido incluido en la página 19
USING YOUR PHONE DIALING A NUMBER IN MEMORY ▼ Using the memory location features 1. Press talk on handset or speaker on the base Unit 2. Press mem . 3. Enter the two digit memory location 0 1 - 2 0 . The number automatically dials. ERASING A STORED NUMBER FROM MEMORY 1. Remove the handset from the base unit. mem 2.Press button twice. 3. Press the two digit memory location 0 1 - 2 0 to be erased. A tone indicates that the stored number is erased from memory. CHAIN DIALING On certain occasions a
Resumen del contenido incluido en la página 20
▼ From the Base Unit For example, if your bank’s telephone number is stored in base unit memory location 0 3 , and your account number is stored in handset memory location : 0 4 1. Press speaker on the base unit. mem 2. Press on the base unit and number 0 3 on the base unit keypad. mem 3. At the appropriate time, press and number 0 4 on the base unit keypad. 4. Your base unit dials the number and you may proceed with your transaction. TRAVELLING OUT-OF-RANGE As you begin to move too far from t
