Manual de instrucciones de Binatone pegasys 400

Resumen del contenido incluido en la página 1

page 8 SETTINGS page 1
Celestia 400
Turning the ringer on and off
USER GUIDE
By default, the ringer is on.
Model 3401
1 Press
CALLER ID buttons*
Display
2 Press the PLAY/PAUSE/STOP button twice
see below
skip to the next record
The Celestia says: ‘Ring on’ or ‘Ring off’.
go back to the previous Microphone
record
3 Press memo or to switch the ringer on or off ANSWER ON light
clear records
This also flashes when
call back the number the unit is ringing for an
4 Press to save the

Resumen del contenido incluido en la página 2

page 2 GETTING READY FOR USE page 3 USING THE ANSWERING MACHINE To set the time and date, and the number of rings before the Celestia 400 Installation will answer a call, refer to SETTINGS on pages 6 to 8.. SAFETY WARNING You need to have a telephone connected to your line as well as Do not install the Recording your outgoing message your Celestia 400. If you wish to connect both units to the same Celestia 400 where it might get wet telephone line socket, use a two-way adapter (‘splitter’) widel

Resumen del contenido incluido en la página 3

page 4 USING THE ANSWERING MACHINE page 5 CALLER ID FUNCTIONS Message playback Checking Caller ID records pause Press the PLAY/PAUSE/STOP button once to start message playback Up to 50 Caller ID records are stored in the Celestia 400’s memory. When the Caller ID stop memories are full, new records will overwrite the oldest ones. Caller ID records are If you have new messages and memos, the machine plays them. If you shown on the display as described on page 1. As you check each new record, it i

Resumen del contenido incluido en la página 4

page 6 SETTINGS page 7 SETTINGS To go into Settings mode, press the SET button. Then pressing the PLAY/PAUSE/STOP button Setting the security code You need a three-digit security code in order to takes you through a number of options, as shown: IN SETTINGS MODE, PRESS operate the answering machine remotely. to change the value of the The default security code is . Y 123 ou can change it to memo current setting, step by step. any other three-digit code you will easily remember. pause pause