Resumen del contenido incluido en la página 1
1450_book_1ATT 3/26 3/26/02 4:59 PM Page ii
USER’S MANUAL
Part 2
2.4 GHz Cordless Speakerphone
with Caller ID/Call Waiting 1450
DRAFT
3/26/02
Please also read
Part 1 — Important
Product Information
AT&T and the globe symbol are registered trademarks of AT&T Corp. licensed to Advanced American Telephones.
Resumen del contenido incluido en la página 2
1450_book_1ATT 3/26 3/26/02 4:59 PM Page iii © 2002 Advanced American Telephones. All rights reserved. Printed in China. Issue 1AT&T 04/02
Resumen del contenido incluido en la página 3
1450_book_1ATT 3/26 3/26/02 4:59 PM Page v CONTENTS BEFORE YOU BEGIN . . . . . . . . . . . . . . .1 TELEPHONE MEMORY AT THE BASE . . . . . . . . . . . . . . . . . . . . . . . . . . . .11 Choosing a Location Store a Number in for Your Phone........................... 1 Base Memory........................... 11 About Caller Identification Dial Number in Base Memory .... 11 (Caller ID) ................................. 1 INSTALLATION . . . . . . . . . . . . . . . . . . . . . . .2 TELEPHONE DIR
Resumen del contenido incluido en la página 4
1450_book_1ATT 3/26 3/26/02 4:59 PM Page 1 BEFORE YOU BEGIN Choosing a Location for Your Phone For best reception quality choose a location for the base unit of your new telephone: • away from microwave ovens • away from TVs,VCRs, stereo equipment and computers (Cordless telephones operate at a radio frequency that may cause interference with these types of equipment.) • away from extreme heat or cold. (For example: radiators, direct sunlight, air ducts, air conditioning and open windows)
Resumen del contenido incluido en la página 5
1450_book_1ATT 3/26 3/26/02 4:59 PM Page 2 INSTALLATION Before You Install 1 Choose a location for the base near an electrical outlet and a telephone jack. This phone requires a modular telephone jack and a standard electrical outlet (110v AC) not controlled by a wall switch. 2 Install the handset battery. Use only the following AT&T Batteries 2414/2415: SKU#23403 and 3301: SKU#91076. a) Remove battery compartment cover by pressing on the indentation and sliding downward. b) Align two hole
Resumen del contenido incluido en la página 6
1450_book_1ATT 3/26 3/26/02 4:59 PM Page 3 INSTALLATION 3 Attach belt clip to the cordless handset (optional). To attach To remove NOTE: Install the base unit and spare handset charger away from electronic equipment, such as personal computers, television sets or microwave ovens. Avoid excessive heat, cold, dust or moisture. Table/Desk Installation Standard Modular electrical outlet telephone jack 1 Connect the telephone line cord. 2 Connect the power cord. 3
Resumen del contenido incluido en la página 7
1450_book_1ATT 3/26 3/26/02 4:59 PM Page 4 INSTALLATION 3 Charge the handset battery. Place the handset in the base. Charge the battery for at least 12 hours the first time. 4 Check for dial tone. After the batteries are charged, pick up the handset and press P; you should hear a dial tone. 5 Set the dial mode. If you have touch tone service, the phone is ready to use as soon as the batteries are charged. If you have dial pulse (rotary) service, you’ll need to change the dial mode. • Press G
Resumen del contenido incluido en la página 8
1450_book_1ATT 3/26 3/26/02 4:59 PM Page 5 INSTALLATION Wall Installation 1 Connect the telephone line cord. 2 Connect the power cord. 3 Mount the base on the wall. Standard electrical outlet a) Align holes on base with mounting studs on wall jack. Modular telephone jack b) Pull base down on mounting studs until it locks into place. 4 Follow Steps 3–5 in Table/Desk Installation. 5
Resumen del contenido incluido en la página 9
1450_book_1ATT 3/26 3/26/02 4:59 PM Page 6 TELEPHONE OPERA HEADLINE LEFT TION HEADLINE L-SUB AT THE HANDSET Answer a Call Press any key exceptO. Handset Volume Make a Call While on a call, Press P, then adjust volume dial the number of what you hear. — OR — Dial the number End a Call (use < to Press O backspace and — OR — correct digits), Place handset then press P in base. to call. Exit programming. Cancel a page. Flash/ Call Waiting Access special Hold telephone company Press to put a sub
Resumen del contenido incluido en la página 10
1450_book_1ATT 3/26 3/26/02 4:59 PM Page 7 TELEPHONE OPERA HEADLINE RIGHT TION HEADLINE R-SUB AT THE HANDSET Handset Ringer Style/Battery Save You can select from four different handset ringer styles, or turn the ringer off and extend the battery life. 1 Make sure the handset is off. 2 Press G to enter programming mode. 3 Press > until the screen displays RINGER:1 (the number is the current setting). 4 Press S. The screen displays the current setting. 5 Press < or > to select 1, 2, 3, 4,or O
Resumen del contenido incluido en la página 11
1450_book_1ATT 3/26 3/26/02 4:59 PM Page 8 TELEPHONE OPERATION AT THE HANDSET Operating Range This cordless telephone operates within the maximum power allowed by the Federal Communications Commission (FCC). Even so, this handset and base can communicate over only a certain distance — which can vary with the locations of the base and handset, the weather, and the construction of your home or office. For best performance, keep the base antenna fully upright. If you receive a call while you are
Resumen del contenido incluido en la página 12
1450_book_1ATT 3/26 3/26/02 4:59 PM Page 9 TELEPHONE OPERATION AT THE BASE On steadily: handset is charging in base Flashing slowly: handset or base speaker is in use or a call is on hold Flashing quickly: Flashes when there is an incoming call you have unreviewed call information. Flash Access subscriber services while on a call. Speaker Volume While on a call, use to adjust the volume of what you hear. Make, Answer, or End a Call Press K. When calling, use the base keypad to dial or
Resumen del contenido incluido en la página 13
1450_book_1ATT 3/26 3/26/02 4:59 PM Page 10 TELEPHONE OPERATION AT THE BASE Intercom/Page 1 Press and release to signal someone at the handset. A paging tone sounds. 2 When the person at the handset presses I, the handset and base can communicate without tying up the phone line. 3 Press again or press o on handset to disconnect. Indicates a new call has been received Base Ringer Volume Switch If you subscribe to telephone company voice mail with a visual Use to adjust how loudly the messag
Resumen del contenido incluido en la página 14
1450_book_1ATT 3/26 3/26/02 4:59 PM Page 11 TELEPHONE MEMORY AT THE BASE You can store 10 telephone numbers (up to 16 digits each) in the base memory locations (0-9). Store a Number in Base Memory 1 Press g on the base to enter programming mode. The SPEAKER light flashes. 2 Press the dial pad key (0-9) for the location where you want to store the number. 3 Enter the telephone number. 4 Press g to store the number. You will hear a confirmation tone. Dial a Number in Base Memory 1 Press K. 2
Resumen del contenido incluido en la página 15
1450_book_1ATT 3/26 3/26/02 4:59 PM Page 12 TELEPHONE DIRECTORY The cordless handset can store 50 telephone numbers with names, each up to 24 digits long. Entries are stored alphabetically. For consistency with Caller ID entries, you may wish to enter last names first. Note: Press O at any time to exit directory. Store a Number/Name in the Directory 1 Press G. The screen displays DIRECTORY. 2 Press S. The screen displays ENTER NAME. 3 Using the chart below, enter up to 15 characters for the
Resumen del contenido incluido en la página 16
1450_book_1ATT 3/26 3/26/02 4:59 PM Page 13 TELEPHONE DIRECTORY 4 When you finish entering the name, press S or G. The screen displays ENTER NUMBER. 5 Enter the telephone number. Use < to backspace and make a correction. Press P to store a pause in the dialing sequence. —OR— Press P to display the last number dialed from this phone. 6 Press S or G. The screen displays DISTINCT RING? and the current setting. 7 Press < or > to change the setting. Choose Y (for Yes) if you wish the phone to al
Resumen del contenido incluido en la página 17
1450_book_1ATT 3/26 3/26/02 4:59 PM Page 14 TELEPHONE DIRECTORY Delete a Number/Name Stored in the Directory 1 Press > (DIR). The screen displays DIRECTORY. 2 Press < or > to scroll alphabetically through entries stored in memory —OR— Press the dial pad key for the first letter of the entry you want to delete. 3 When the screen displays the number you want to delete, press S. Then press < or > until ERASE flashes. EDIT DIAL EERRAASSEE 973-555-0123 4 Press S. The screen displays ERASE NO YES
Resumen del contenido incluido en la página 18
1450_book_1ATT 3/26 3/26/02 4:59 PM Page 15 CALLER ID OPERATION Caller’s name Caller’s telephone number Position of call Date of call Time of call in call history About Call History This phone assigns each incoming call a number from 1 to 90. The most recent call will have the highest number. When the memory is full, the oldest call information is deleted to make room for new incoming call information. For each call that comes in, the screen displays the following information between the fir
Resumen del contenido incluido en la página 19
1450_book_1ATT 3/26 3/26/02 4:59 PM Page 16 CALLER ID OPERATION Delete Records from Call History Delete a Specific Call 1 Locate the record you want to delete from call history. 2 Press S, then press < or > until ERASE flashes. DIAL EERRAASSEE PGM 973-555-0123 5/01 5:40PM OLD28 3 Press S. The screen displays ERASE NO YES ALL and the phone number. The current choice flashes. 4 Press < or > until YES flashes. 5 Press S. You’ll hear a series of beeps confirming the deletion. Delete All Calls
Resumen del contenido incluido en la página 20
1450_book_1ATT 3/26 3/26/02 4:59 PM Page 17 CALLER ID OPERATION Store a Call History Record in the Directory 1 Locate the record in call history you want to store in memory. 2 If you wish to change how the number is stored, press #. The screen displays any alternate dialing sequences available for this call (area code + number; 1 + area code + number; 1+ number; number only). 3 Press S, then press < or > until PGM flashes. DIAL ERASE PPGGMM 973-555-0123 5/01 5:40PM OLD28 4 Press S three tim
