Bedienungsanleitung Smeg Built-in Electric Hob HBE64CAS

Inhaltszusammenfassung zur Seite Nr. 1

INSTRUCTIONS AND ADVICE FOR THE
USE, INSTALLATION AND MAINTENANCE
OF BUILT-IN ELECTRIC HOBS
Dear Customer,
Thank you for having purchased one of our products.
We are certain that this new, modern, functional and practical appliance, built with the very
highest quality materials, will meet your requirements in the best possible way. This hob is easy to
use. It is, however, important to thoroughly read the instructions in this handbook in order to
obtain the best results.
The manufacturer shall no

Inhaltszusammenfassung zur Seite Nr. 2

DESCRIPTION OF THE HOT PLATES TECHNICAL ASSISTANCE AND SPARE PARTS This appliance, before leaving the factory, has been carefully tested and regulated by expert and TYPE: PAZ04 specialized personnel in order to guarantee the best performances. Any repairs or adjustments which may be subsequently required may only be carried out by qualified personnel with the utmost care and attention. For this reason, always contact your Dealer or your nearest After Sales Centre whenever repairs or adjustments

Inhaltszusammenfassung zur Seite Nr. 3

TECHNICAL DATA USE MODEL WITH diagram indicates to which electric plate the knob in 1) SWITCHING ON THE ELECTRIC 2 RAPID PLATES + 2 THERMOSTAT PLATES question corresponds (see fig. 1 - 2). PLATES A red warning light will come on to indicate that the VOLTAGE 230 - 240 V~ The hobs may be equipped with three types of plate has been ignited. electric plates: normal, thermostat and rapid plates FREQUENCY 50/60 Hz indicated by a red mark. The normal plates and the TOT. RATING 7000 W 2) HOW TO USE THE

Inhaltszusammenfassung zur Seite Nr. 4

USE SERVICING Always disconnect the appliance from the conductor longer than “live” ones, and must WARNINGS: electricity main before proceeding with any respect the cautions in paragraph When the plate is switched on for the first time, or if it has remained unused for a long period, it servicing operation. “Electrical connection”. should be dried for 30 minutes on switch position n° 1. This will eliminate any moisture that may To reassemble the appliance repeat the inverse have been absorbed by

Inhaltszusammenfassung zur Seite Nr. 5

CONVERSIONS CLEANING Disconnect the appliance from the mains b) Shift connecting plate on terminal according to WARNINGS: IMPORTANT: supply prior to any conversions being carried the following chart. This chart is also affixed to the Always disconnect the appliance from the - Correctly preserve the plate after use by out. hob. electricity main before carrying out any treating it with special products, easily c) Insert a supply cable of adequate section (see cleaning operation. available on the m

Inhaltszusammenfassung zur Seite Nr. 6

INSTALLATION INSTALLATION Installation and maintenance must only be - Overturn the hob and correctly position seal “E” When the appliance is connected straight to 6) ELECTRICAL CONNECTIONS carried out by a qualified installer. (fig. 6) under the edge of the hob itself, so that the electricity main: Electrical connection must be carried out in Incorrect installation could cause damage to the outer part of the seal itself perfectly matches compliance with the specifications and - Install an omnipo