Inhaltszusammenfassung zur Seite Nr. 1
Heartlan
d
H Heeaa
rrttllaannd d
®
HEARTLAND
1260 E. VanDeinse St. Greenville MI , 48838
Toll Free Phone 1-800-223-3900 Fax 1-616-754-9690
Installation and Operating Instructions For
Models:
6210 48" Electric Convection w/smooth top Self Clean Range
8210 30" Electric Convection w/smooth top Self Clean Range
ATTENTION INSTALLER: Leave this manual with appliance
Save these instructions for future use
NOTE: Clock must be set or your main oven will not function!
WARNING: Improper installation,
Inhaltszusammenfassung zur Seite Nr. 2
If the information in this manual is not followed exactly, a fire or explosion may result caus- ing property damage, personal injury, or death. —FOR YOUR SAFETY— DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPOURS OR LIQUIDS IN THE VICINITY OF THIS APPLIANCE. • Do not use the range as a heater . • Do not heat unopened glass or metal containers in the oven. • Grease accumulation is the cause of many cooking fires. Clean the oven and broiler compartment regularly
Inhaltszusammenfassung zur Seite Nr. 3
He rt nd a la H Heeaarrttllaannd d ® HEARTLAND Electric Self Clean Models 6210/8210 CONSUMER WARRANTY ENTIRE PRODUCT – LIMITED ONE YEAR WARRANTY AGA MARVEL warrants the replacement or repair of all parts, of this appliance which prove to be defective in material or workmanship, with the exception of the painted or porcelain enamel finish or plated surfaces, for one year from the date of original purchase. Such parts will be repaired or replaced at the option of Heartland without charge, subjec
Inhaltszusammenfassung zur Seite Nr. 4
TABLE OF CONTENTS Description ....................................... .Page Description ........................................Page 29. Minute Minder.......................................................31 1. Warranty ..................................................................3 2. Assembly and Installation ....................................... 5 30. Time Bake .......................................................... 29 31. General Cooking Guidelines ........
Inhaltszusammenfassung zur Seite Nr. 5
Assembly and Installation T o fully enjoy your new range, it is important that you read this booklet thoroughly . Note: Please check for any damage that may have occurred during shipping. In the unlikely event that you find any shipping damage, inform your dealer immediately! Caution when unpacking: Lift the range by the bottom skirt, do not lift by nickel trim. Unpacking: Note: to avoid injury , please wear safety equipement, glasses and gloves, while you are unpacking your new r
Inhaltszusammenfassung zur Seite Nr. 6
6
Inhaltszusammenfassung zur Seite Nr. 7
Sheet metal screw Steel washer Machine screw Bracket Gasket - Peel of f backing and stick on. Sheet metaI Steel Washer Machine screw screw (black) Gasket -Remember when working with the cabinet, the cabinet is top heavy . Use your hand to support it during installation. -Place box on the floor close to stove. -With a helper ,lift closet assembly from box. -Rest the closet assembly on the carton,while your helper steadies the closet , peel the cabinet backing of f the
Inhaltszusammenfassung zur Seite Nr. 8
Deflector Back of cabinet Sheet metal 3 1/2" x 10" Exhaust adaptor screw If you are not venting outside, attach the deflector to the rear of cabinet with 4, sheet metal screws. If you are venting outside, attach the 3 1/2" x 10" exhaust adaptor with 4, sheet metal screws. Fasten your exhaust ducting to the adaptor. Small boxcontains: - hardware package - deflector - 3 1/2"x10 exhaust adapter Note: maximum run of ducting is 25 linear feet (subtract 5' per 90 deg elbow added to the exhaust
Inhaltszusammenfassung zur Seite Nr. 9
CONNECTING POWER TO THE CABINET After your exhaust hood has been installed the very last thing to do is to connect the multipin plug to the range. The receptacle is located at the rear of the stove under the metal cover. Remove the screw securing the cover to the back of the range and remove the cover. Remove the cable clamp from the stove which is located just above the cover. 6210 8210 Back of Back of stove stove Metal cover Screw Exhaust Hood Recptacle Locations When installing the mult
Inhaltszusammenfassung zur Seite Nr. 10
Positioning the Range 1. When the range is fully assembled, recheck all electrical connections especially between the exhaust hood and the back of the range. As well, check that all nuts and bolts have been tightened. 2. Ensure teflon gliders and flooring are clean, (as described on page 5 under "Gliders"). 3. Caution : On flooring with very rough surfaces or deep, large grooves the appliance may have to be lifted and slowly slid into position. 4
Inhaltszusammenfassung zur Seite Nr. 11
Exhaust Hood Y our range is equipped with a variable speed range hood that may be either vented directly to the outside, or may be installe d ventless. An exhaust filter is included with your hood. The filters should be cleaned periodically in soapy water . Extras are available from your dealer or directly from Heartland. Please order 4 or more filters at one time to save freight and handling charges. Ventless Installa
Inhaltszusammenfassung zur Seite Nr. 12
Vented Installation, Tools, Material, and Dimensions Tools required to install vented hood: - Hammer - Slot screwdriver - Pliers - Electric drill - Measuring tape - 3/32” (3 mm) Drill bit - 1/2” (13 mm) Drill bit - Sabre saw OR Keyhole saw Materials Required: - 3 1/4" x 10" (82.55 mm x 254 mm) metal duct—enough to go through wall or attic to outside. Elbows as required. - Roof cap or wall venthood - Caulking to seal around duct - #6 x 1/2” (82.55
Inhaltszusammenfassung zur Seite Nr. 13
Important Safety Instructions 1. PROPER INST ALLA TION- BE SURE YOUR APPLIANCE IS PROPERL Y INST ALLED AND GROUNDED BY A QUALIFIED TECHNICIAN. H ave the installer show you the location of the circuit breaker or fuse. Mark it for future reference. 2. Never use your appliance for warming or heating the room. Use only for its intended use as described in this manual. 3. Do not leave children alone. Children should not be left alone or unattended in a
Inhaltszusammenfassung zur Seite Nr. 14
- Always turn the surface units of f before removing cookware. - When preparing flaming foods under the hood, turn the fan on. - Use care when touching the cooktop. The smooth surface of the cooktop will retain heat and may be hot enough to burn even though it may appear dark in color after the controls have been turned of f. - Use little fat for ef fective shallow or deep fat frying. Fillin g the pan too full of fat can cause spillover
Inhaltszusammenfassung zur Seite Nr. 15
Oven Safety Do not touch heating elements or interior surfaces of oven—heating elements may be hot even though they are dark in colour. Interior surfaces of an oven become hot enough to cause burns. During and after use, do not touch, or let clothing or other materials to contact heating elements or interior surfaces of oven until they have had time to cool. Other surfaces of the appliance may become hot enough to cause burns—among these surfaces are, for example, oven vent openings and s
Inhaltszusammenfassung zur Seite Nr. 16
FEATURES - USING THE SURFACE ELEMENTS Cooking Controls (Surface Units) 30" Model 48" Model G G A A D B C B F C E A - 1200 watt radiant 5 1/2" dia. A - 1200 watt radiant 5 1/2" dia. B - 2000 watt radiant 7 1/2" dia. B - 2000 watt radiant 7 1/2" dia. C - 2500 watt dual radiant 9" dia.- 1000 watt C - 2500 watt dual radiant 9" dia. - 1000 watt inner ring inner ring D - 1800 +800 watt radiant 7" dia (48" model only
Inhaltszusammenfassung zur Seite Nr. 17
How to Set Smooth Cooktop Burners Burners A,B, E & F: - Push the knobs in and turn in either direction to the setting desired. - The higher number selected represents the higher temperature . - At both the low (1) and high(7) settings, the control will "click" into position. Control will also "click" and pop back up, in the of f (0) position. - Please be sure control knob is turned of f (0) when your finished cooking. Dual Surface Unit Control Knob - Burner C: Dual element has
Inhaltszusammenfassung zur Seite Nr. 18
About the smooth cooktop surface units… The cooktop features heating units beneath a smooth Eurokera Ceramic surface. Note: A slight odor is normal when a new cooktop is used for the first time. It is caused by the heating of new parts and insulating materials and will disappear in a short time. The surface unit will cycle on and of f to maintain your selected control setting. It is safe to place hot cookware on the smooth surface even when the cooktop is cool. Even after the sur
Inhaltszusammenfassung zur Seite Nr. 19
Selecting types of Cookware: The following information will help you choose cookware, which will give good performance on glass cooktops. Stainless Steel: Recommended. Aluminum: Heavy Weight recommended. Good conductivity . Aluminum residues sometimes appear as scratches on the cooktop, but can be removed if cleaned immediately . Because of its low melting point, thin weight aluminum should not be used. Copper Bottom: Recommended. Copper may leave residues, which can appear
Inhaltszusammenfassung zur Seite Nr. 20
Cleaning the Glass Cooktop: (for ordering information of any of the following cleaning products please see page 21). Clean your cooktop after each spill Make sure all control knobs are in the “0” (off) position Normal Daily Use Cleaning: Only use the recommended cleaning cream, Cerama Bryte™, on the glass cooktop. Other creams may not be as ef fec- tive. T o maintain and protect the surface of your glass cooktop, follow these steps: 1. Before using the cooktop for the first time
