Bedienungsanleitung NEC PX-50XM4A

Inhaltszusammenfassung zur Seite Nr. 1

PlasmaSync Plasma Monitor
Model Information
For the operation of your plasma monitor,
refer to “Operation Manual”.
NEC Solutions (America), Inc.

Inhaltszusammenfassung zur Seite Nr. 2

2

Inhaltszusammenfassung zur Seite Nr. 3

Important Information Warning NOTE: Not for use in a computer room as defined in the Standard When you connect a computer to this monitor, use an RGB for the Protection of Electronic Computer/ Data Processing cable including the ferrite core on both ends of the cable. Equipment ANSI/NFPA 75. And regarding DVI and power cable, attach the supplied ferrite cores. If you do not do this, this monitor will not This equipment has been tested and found to comply with conform to mandatory FCC standards.

Inhaltszusammenfassung zur Seite Nr. 4

Recommandations importantes Avertissement REMARQUE: Ne pas utiliser dans une salle d’ordinateurs telle que définie Pour raccorder un ordinateur à ce moniteur, procéder à dans la Norme pour la protection des ordinateurs l’aide d’un câble RGB à âme de ferrite aux deux électroniques/appareils de traitement des données ANSI/ extrémités. Sur les câbles DVI et les câbles d’alimentation NFPA75. électrique, fixer les âmes de ferrite fournies aux extrémités. Si vous ne le faîtes, le moniteur ne sera pas

Inhaltszusammenfassung zur Seite Nr. 5

Specifications Screen Size 43.5"(H)
24.5"(V) inches 1106(H)
622(V) mm 1.5" 2.3" (38) diagonal 50" 48.1" (1222) (58) Aspect Ratio 16 : 9 Resolution 1365(H)
768(V) pixels 43.5" (1106) Pixel Pitch 0.032"(H)
0.032"(V) inches 0.81(H)
0.81(V) mm Color Processing 4,096 steps, 68.7 billion colors Signals Synchronization Range Horizontal : 15.5 to 110 kHz (automatic : step scan) Vertical : 50.0 to 120 Hz (automatic : step scan) 3.8" (96) Input Signals RGB, NTSC (3.58/4.43), PAL (B,G,M,N), PAL60, SECAM, H

Inhaltszusammenfassung zur Seite Nr. 6

6

Inhaltszusammenfassung zur Seite Nr. 7

Table of Signals Supported Supported resolution 2, 3, 4 • When the screen mode is NORMAL, each signal is converted to a 1024 dots
768 lines signal. (Except for * ) • When the screen mode is TRUE, the picture is displayed in the original resolution. 3 • When the screen mode is FULL, each signal is converted to a 1365 dots
768 lines signal. (Except for * ) Computer input signals supported by this system Sync Polarity Presence Screen mode Vertical Horizontal RGB Dots
lines Model 5 DVI Memo

Inhaltszusammenfassung zur Seite Nr. 8

*1 Only when using a graphic accelerator board that is capable of displaying 852
480. *2 This signal is converted to a 1024 dots
640 lines signal. *3 The picture is displayed in the original resolution. *4 The aspect ratio is 5:4. This signal is converted to a 960 dots
768 lines signal. *5 Normally the RGB select mode suite for the input signals is set automatically. If the picture is not displayed properly, set the RGB mode prepared for the input signals listed in the table above. *6 To conne