Inhaltszusammenfassung zur Seite Nr. 1
Inhaltszusammenfassung zur Seite Nr. 2
Inhaltszusammenfassung zur Seite Nr. 3
Contents Declaration of Conformity ......................................................................................................................................................................3 Safety Considerations .............................................................................................................................................................................6 What’s Included.....................................................................................
Inhaltszusammenfassung zur Seite Nr. 4
Inhaltszusammenfassung zur Seite Nr. 5
Declaration of Conformity Manufacturer: InFocus Corporation, 13190 SW 68th Parkway, Portland, Oregon 97223-8368 USA We declare under our sole responsibility that this monitor conforms to the following directives and norms: • EMC Directive 2004/108/EC: o EN 55022 o EN 55024 o EN 61000-3-2 o EN 61000-3-3 • Low Voltage Directive 2006/95/EC • Safety: IEC 60950-1:2005 • R&TTE Directive: 1999/5/EC Trademarks Apple, Mac and Facetime are trademarks or registered trademarks of Apple, Inc. Microsoft, Win
Inhaltszusammenfassung zur Seite Nr. 6
Canada This Class A digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe A est conforme à la norme NMB- 003 du Canada. INFORMATION FOR RADIO FREQUENCY DEVICES ONLY: This device complies with part 15 of the FCC Rules / RSS-210. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. INFORMATION PO
Inhaltszusammenfassung zur Seite Nr. 7
Energy Star As an ENERGY STAR Partner, InFocus Corporation has determined that this product meets the ENERGY STAR guidelines for energy efficiency. ENERGY STAR® is a joint program of the U.S. Environmental Protection Agency and the U.S. Department of Energy aimed at saving money and protecting the environment through energy efficient products and practices. We are proud to offer our customers products with an ENERGY STAR compliant design. This product has been designed and tested to conform
Inhaltszusammenfassung zur Seite Nr. 8
Safety Considerations Please read and follow all safety instructions provided below and on the monitor before connecting the monitor to a power source. Failure to comply with safety instructions may result in fire, electrical shock, or personal injury and may damage or impair protection provided by the equipment. Please save all safety instructions. • This monitor is very heavy and should be moved and installed by at least two individuals. Do not attempt to move or install the monitor yourse
Inhaltszusammenfassung zur Seite Nr. 9
• Unplug the monitor if you are not going to use it for an extensive period of time. • Unplug the monitor if you need to clean it with the included microfiber cleaning cloth. The screen may be wiped with the clean- ing cloth when the power is off. Never use alcohol, solvents or ammonia-based liquids on this product. • Wash hands after handling the cables supplied with this product. • The monitor remote control, mouse and keyboard use batteries. Make sure the batteries’ polarity (+/-) is aligned
Inhaltszusammenfassung zur Seite Nr. 10
What’s Included 1920 x 1080 monitor Wireless Keyboard & Mouse* (Batteries not included) POWER HOME INPUT MENU RESIZE PIP ON/OFF INPUT SWAP POSITION AUDIO BRIGHTNESS CONTRAST OK BACK INFO Quick Setup i VOL UP Guide MUTE VOL DOWN Remote control Documen t a tion Cleaning cloth Security tool Thumb screws (ba tt eries not included) (set of four) VGA cable, 4M USB cable, 3M Power cords (Type A to B) (varies per country) Feet Feet spacers M6 Screws (set of two) (set of two) (set of six) *Not incl
Inhaltszusammenfassung zur Seite Nr. 11
Setup Installing the Feet 1) If you have not already done so, carefully place your monitor face-down on a clean, cushioned surface with the top edge hang- ing off of the cushioned surface by 4-5” (10-13cm). Do NOT place the monitor on its back. 2) Remove the monitor feet slot covers with a Philips screwdriver. Discard or save for future use. 3) Slide the feet into the slots provided (the longer side of the feet point toward the front of the monitor), then secure the legs to the monitor with th
Inhaltszusammenfassung zur Seite Nr. 12
Connecting to Other Devices A full range of digital and analog video inputs and audio source devices can be connected to the connection panels on the back and side of this monitor. Available jacks include: HDMI® (2), VGA, Component (RCA), S-Video, Composite, RS232, Audio in RCA (1 – R/L), Audio in 3.5mm (1), Audio Out (1 – R/L), RJ45 (2), USB-B (1) and USB-A (6). Bezel Connector Side Connector Panel Panel Bott om Connect or P anel Page 10
Inhaltszusammenfassung zur Seite Nr. 13
Bezel Connector Panel P o w er butt on Keypad USB-A jacks USB-B jack Side Connector Panel RJ45 Audio Out (L/R) RS232 Power LED USB-A Antennas PC Reset Audio In (L/R) butt on Audio In (3.5mm) Bott om Connect or P anel S-video Component AC Power In Power switch HDMI® AC Power Out Composite (YPbPr) VGA Connecting AC Power 1) Connect one end of the AC power cord to the AC In jack on the back of the monitor. 2) Connect the other end of the AC power cord to an AC outlet. 3) Press the power sw
Inhaltszusammenfassung zur Seite Nr. 14
Turning the Monitor On/Off 1) Verify that the power cord is connected to a power outlet and that the power switch on the Bottom Connector Panel is ON. 2) Press the Power button located on either: a. the remote b. the right side of the monitor c. or the back of the monitor on the PC box. The front LED turns green. 3) Press the Power button again to put the monitor into Standby. The front LED turns red. You can also put your monitor to sleep using the keyboard. The front LED turns orange. Notes:
Inhaltszusammenfassung zur Seite Nr. 15
Setting up the Wireless Mouse and Keyboard Note: The wireless mouse and keyboard set is not included as a standard accessory for some countries. For initial setup and/or con- figuration, it may be easier to use a mouse and keyboard. Any standard wired or wireless mouse or keyboard connected through the monitor's USB ports can be used. Wireless Mouse 1) Turn the mouse over and remove the battery cover. 2) Remove the USB dongle from its holder in the battery compartment of the mouse. 3) Plug it i
Inhaltszusammenfassung zur Seite Nr. 16
Using the Remote The remote uses two (2) AAA batteries (not included). Install the batteries by removing the cover from the remote’s back, aligning the + and – ends of the batteries, sliding them in place and replacing the cover. To operate, point the remote at the monitor sensor at the bottom right-hand corner of the monitor. The range of optimum operation is about 26’ (8m) and within a horizontal and vertical angle of 30 degrees. 30˚ 30˚ POWER HOME INPUT MENU RESIZE PIP ON/OFF INPUT SWAP P
Inhaltszusammenfassung zur Seite Nr. 17
The remote has the following buttons: POWER Power: Switches the power on or puts the monitor into Standby. POWER Home: Changes the active source back to the embedded PC. HOME HOME INPUT MENU Input: Toggles the Source menu on and off, which allows the user INPUT RESIZE to change sources. Options include: HDMI1, HDMI2, PC, VGA, PIP Component, S-video and Video (composite). ON/OFF INPUT SWAP Menu: Turns the OSD menu on and off. MENU POSITION AUDIO Resize: Switches aspect ratios. RESIZE BRIGHTNES
Inhaltszusammenfassung zur Seite Nr. 18
Info: n/a INFO i Vol up: Increases the audio volume. VOL UP Vol down: Decreases the audio volume. OK Mute: Switches the audio on or off. MUTE Using the Keypad The keypad, located on the right-edge of the monitor, has the following buttons: Menu butt on: Turns the OSD menu on and off. Le ft/V olume Decr ease butt on: Decreases the audio volume when the OSD menu is off. Decreases the value of selected OSD items when the OSD menu is on. Righ t/V olume Incr ease butt on: Increases the audio volume
Inhaltszusammenfassung zur Seite Nr. 19
< < < < < < < OSD (On-Screen Display) Menu System The OSD provides the user the ability to control the monitor. To access the OSD, press the Menu button on the remote or the keypad located on the right-hand side of the monitor. Use the up and down arrows on the remote or keypad to scroll through the menu options and press OK to enter the highlighted menu. Use the up and down arrows and OK button to select the item you would like to adjust. Left and right arrow buttons are used to make adjustme
Inhaltszusammenfassung zur Seite Nr. 20
< Picture Menu PICTURE BRIGHTNESS 70 CONTRAST 50 SHARPNESS 50 BLACK LEVEL 50 NOISE REDUCTION OFF TINT 50 COLOR 50 10000K COLOR TEMPERATURE COLOR CONTROL OFF ADAPTIVE CONTRAST PICTURE MODE STANDARD PICTURE RESET Sel Adjust Enter Back Quit < > Brightness: changes the intensity of the image. Range: 0-100. (Default 70.) Contrast: controls the degree of difference between the lightest and darkest parts of the picture and changes the amount of black and white in the image. Range: 0-100. (Default 50.)
