Bedienungsanleitung Video Products USB-SUN

Inhaltszusammenfassung zur Seite Nr. 1

NETWORK
NTI NTI
USB-SUN USB TO SUN ADAPTER
INSTALLATION / USER GUIDE
MAN015 REV 11/23/01
INCORPORATED
Aurora, OH 44202
Fax:330-562-1999
TECHNOLOGIES
Tel:330-562-7070 1275 Danner Dr

Inhaltszusammenfassung zur Seite Nr. 2

Introduction The NTI USB-SUN is a USB to SUN adapter that allows users to easily connect their SUN USB enabled computer to an NTI Universal Multi Platform (ST-xU) or Universal Matrix (ST-nXm-U) KVM Switch. Parts Included 1 NTI USB-SUN Adapter 1 USB-AB-0,5M-5T USB AB male-to-male cable Cable that may be required but is not supplied: Application NTI CABLE Connect adapter to NTI Universal Switch SKTINT-xx-MM Legend: xx is the length of the cable in feet. MM indicates male-to

Inhaltszusammenfassung zur Seite Nr. 3

Setup When using the USB-SUN adapter to connect to an NTI KVM switch: 1. Connect one male 8 pin minDIN end of the SKTINT-xx-MM cable to a female 8 pin minDIN Keyboard and Mouse input port on the NTI KVM switch being used (see Fig. 3). Switch the power ON to the KVM switch if it isn't already. 2. Connect the other male 8 pin miniDIN end of the SKTINT-xx-MM cable to the 8 pin miniDIN female port on the USB-SUN adapter. Fig. 3 3. Connect the USB type B male connector of the USB-AB-0.

Inhaltszusammenfassung zur Seite Nr. 4

: It is necessary to configure the host (Sun) computer such that the Sleep Mode is not enabled. If the host computer goes into sleep mode either automatically or manually, the user must reboot the host computer in order to resume use of the host computer. To disable the Sleep Mode, perform the following steps: 1. Select "Power Manager" 2. Look for "Device Idle Time Before Power Saving Starts" 3. Select "Always ON" 4. Look for "Override Device Idle Time For:" 5. Make sure neither "Monitors