Inhaltszusammenfassung zur Seite Nr. 1
Fuzzy 945GME3
MS-9642 (V3.X) Mainboard
G52-96421X4
i
PDF created with pdfFactory Pro trial version www.pdffactory.com
Inhaltszusammenfassung zur Seite Nr. 2
Copyright Notice The material in this document is the intellectual property of MICRO-STAR INTERNATIONAL. We take every care in the preparation of this document, but no guarantee is given as to the correctness of its contents. Our products are under continual improvement and we reserve the right to make changes without notice. Trademarks All trademarks are the properties of their respective owners. ® ® Intel and Pentium are registered trademarks of Intel Corporation. AMD, Athlon™, Athlon™ XP, Th
Inhaltszusammenfassung zur Seite Nr. 3
Safety Instructions 1. Always read the safety instructions carefully. 2. Keep this User’s Manual for future reference. 3. Keep this equipment away from humidity. 4. Lay this equipment on a reliable flat surface before setting it up. 5. The openings on the enclosure are for air convection hence protects the equip- ment from overheating. DO NOT COVER THE OPENINGS. 6. Make sure the voltage of the power source and adjust properly 110/220V be- fore connecting the equipment to the power inlet. 7. Pla
Inhaltszusammenfassung zur Seite Nr. 4
FCC-B Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accor- dance with the instructions, may cause harmful interference to radio communications. Howev
Inhaltszusammenfassung zur Seite Nr. 5
WEEE (Waste Electrical and Electronic Equipment) Statement v
Inhaltszusammenfassung zur Seite Nr. 6
vi
Inhaltszusammenfassung zur Seite Nr. 7
vii
Inhaltszusammenfassung zur Seite Nr. 8
CONTENTS Copyright Notice ..................................................................................................... ii Trademarks ............................................................................................................ ii Revision History ..................................................................................................... ii Technical Support .................................................................................................. ii Safe
Inhaltszusammenfassung zur Seite Nr. 9
Getting Started Chapter 1 Getting Started Thank you for choosing the Fuzzy 945GME3 (MS-9642 v3.X) Mini ITX mainboard from MSI. ® Based on the innovative Intel 945GM/945GME & ICH7M controllers for optimal system efficiency, the ® Fuzzy 945GME3 accommodates the latest Intel Core 2 Duo/ Core Duo/ Core Solo/ Celeron M/ Celeron LV 423 BGA (with BGA Passive Cooler) processors in Socket M and supports one 240-pin 533/667MHz DDR2 DIMM slot to provide the maximum of 2GB memory capacity. In the entry-lev
Inhaltszusammenfassung zur Seite Nr. 10
MS-9642 Mainboard Mainboard Specifications Processor ® - Intel Core 2 Duo/Core Duo/Core Solo/Celeron M/Celeron LV 423 BGA (with BGA Passive Cooler) CPU in Socket M - Supports 3 pin CPU Fan Pin-Header with Fan Speed Control - Supports Intel Dual Core Technology to 533/667MHz and up Chipset ® - North Bridge: Intel 945GM/ 945GME chipset ® - South Bridge: Intel ICH7M chipset Memory - DDR2 533/667 SDRAM (2GB Max) - 1 DDR2 DIMM slot (240pin / 1.8V) LAN ® - Supports 2 PCI Express Gb Ethernet by Intel 8
Inhaltszusammenfassung zur Seite Nr. 11
Getting Started Connectors Back Panel - 2 RJ-45 LAN jacks - 2 USB 2.0 ports - 1 D-Sub VGA connector - 1 serial port - 1 PS/2 keyboard port and 1 PS/2 mouse port - 1 line-in, line-out and mic-in stacked audio jack Onboard Pinheaders - 1 USB 2.0 pinheader (2 ports) - 1 parallel port pinheader - 1 front audio pinheader - 1 LVDS connector - 1 Digital I/O pinheader (16 GPIO) - 4 RS232 pinheaders as COM1~COM4 (optional) - 1 front panel pinheader Slots - 1 PCI Express x16 slot (supports MS-V004 ADD2
Inhaltszusammenfassung zur Seite Nr. 12
MS-9642 Mainboard Block Diagram 1-4
Inhaltszusammenfassung zur Seite Nr. 13
SYSFAN1 Getting Started Mainboard Layout SATA1 ATX1 IDE1 SATA2 F_USB2 Top: Serial Port BATT JLPT1 CPUFAN1 Bottom: VGA Port + Intel J8 ICH7M JFP1 Top: Mouse Bottom: Keyboard USB Ports LAN Chip Intel 945GM/945GME LAN Chip LAN Jacks T: Line-In M: Line-Out B: Mic-In DIMM1 Audio Codec JCI1 BIOS SYSFAN2 J3 PCI-E1 COM4 COM3 J4 JAUD1 PCI1 JAMP1 J6 J5 J7 COM1 COM2 Fuzzy 945GME3 (MS-9642 v3.X) Mini ITX Mainboard 1-5 CLR_CMOS1 JLVDS1 J1
Inhaltszusammenfassung zur Seite Nr. 14
MS-9642 Mainboard Board Dimension 1-6
Inhaltszusammenfassung zur Seite Nr. 15
Getting Started Back Panel & I/O Shield Drawing 1-7
Inhaltszusammenfassung zur Seite Nr. 16
MS-9642 Mainboard Power Consumption Component Description Motherboard MS-9642 CPU Intel Core 2 T7200 Memory DDR2 1GB HDD HITACHI 20G 1.8" Operating system Windows XP Professional SP2 12V 5V 3.3V -12V 5Vsb Power (W) 3D Maker 2006 2.17 2.77 0.71 0.054 0.066 43.211 CPU Stress 2.35 2.32 0.68 0.035 0.066 42.794 Enter DOS 1.57 1.62 0.66 0.048 0.055 29.969 Enter BIOS 1.63 1.77 0.64 0.048 0.055 31.373 Idle Mode 0.65 1.63 0.69 0.056 0.05 19.149 S1 0.92 1.11 0.47 0.05 0.056 19.021 S3 0 0 0 0 0.33 1.65
Inhaltszusammenfassung zur Seite Nr. 17
Getting Started Safety Compliance & MTBF Standard number Certification Title of standard EN 55022:1998+A1:2000+A2:2003 Class B Product family standard Limits for harmonic current EN 6100-3-2:2000 Class D emission RFI CE Limitation of voltage EN 6100-3-3:1995+A1:2001 fluctuation and flicker in low- voltage supply system Immunity EN 55024:1998+A1:2001+A2:2003 Product family standard BSMI CNS 13438 乙類(1997年版) C-Tick AS/NZS CISPR 22:2004 FCC CFR Title 47 Part 15 Subpart B: 2005 Class B FCC CISPR 22:
Inhaltszusammenfassung zur Seite Nr. 18
MS-9642 Mainboard 1-10
Inhaltszusammenfassung zur Seite Nr. 19
Hardware Setup Chapter 2 Hardware Setup This chapter provides you with the information about hardware setup procedures. While doing the installation, be careful in holding the components and follow the installation procedures. For some components, if you install in the wrong orientation, the components will not work properly. Use a grounded wrist strap before handling computer components. Static electricity may damage the components. 2-1
Inhaltszusammenfassung zur Seite Nr. 20
MS-9642 Mainboard Quick Components Guide JLPT1, p.2-15 ATX1, p.2-7 F_USB2, p.2-14 IDE1, CPU, p.2-3 p.2-9 SATA1/2, p.2-10 CPUFAN1, p.2-12 JFP1, p.2-12 Back Panel I/O, p.2-8 J1, p.2-17 CLR_CMOS1, p.2-17 JLVDS1, p.2-16 DIMM Slot, p.2-6 JCI1,p.2-9 PCI-E Slot,p.2-18 SYSFAN1, J3, p.2-15 p.2-12 SYSFAN2, J4, p.2-17 PCI Slot, p.2-18 p.2-12 COM1~4, p.2-13 JAUD1, p.2-11 J6/J5/J7, p.2-17 JAMP1, p.2-11 2-2
