Inhaltszusammenfassung zur Seite Nr. 1
PCA-6175
®
Pentium II processor-
based PCI/ISA-bus CPU
card
Inhaltszusammenfassung zur Seite Nr. 2
Copyright Notice This document is copyrighted, 1998, by Advantech Co., Ltd. All rights are reserved. Advantech Co., Ltd., reserves the right to make improvements to the products described in this manual at any time without notice. No part of this manual may be reproduced, copied, translated or transmitted in any form or by any means without the prior written permission of Advantech Co., Ltd. Information provided in this manual is intended to be accurate and reliable. However, Advantech Co., Ltd.
Inhaltszusammenfassung zur Seite Nr. 3
A Message to the Customer Advantech Customer Services Each and every Advantech product is built to the most exacting specifications to ensure reliable performance in the harsh and demanding conditions typical of industrial environments. Whether your new Advantech equipment is destined for the laboratory or the factory floor, you can be assured that your product will provide the reliability and ease of operation for which the name Advantech has come to be known. Your satisfaction is our primary c
Inhaltszusammenfassung zur Seite Nr. 4
Product Warranty Advantech warrants to you, the original purchaser, that each of its products will be free from defects in materials and workmanship for one year from the date of purchase. This warranty does not apply to any products which have been repaired or altered by persons other than repair personnel authorized by Advantech, or which have been subject to misuse, abuse, accident or improper installation. Advantech assumes no liability under the terms of this warranty as a consequence of su
Inhaltszusammenfassung zur Seite Nr. 5
Initial inspection Before you begin installing your card, please make sure that the following materials have been shipped: ® • 1 PCA-6175 Pentium II single board computer • 1 Pentium II CPU and cooling fan (optional) • 1 PCA-6175 user's manual • 1 bus master & BIOS utility driver • 1 FDD cable • 2 EIDE HDD cables • 1 printer cable • 1 ivory cable for keyboard and mouse • 1 ATX-to-PS/2 power cable • 1 Pentium II CPU retention module If any of these items are missing or damaged, contact y
Inhaltszusammenfassung zur Seite Nr. 6
Contents Chapter 1 Hardware Configuration ....... 1 1.1 Introduction ............................................................ 2 1.2 Features .................................................................. 3 1.3 Specifications ........................................................ 4 System .................................................................................................. 4 Memory ............................................................................................
Inhaltszusammenfassung zur Seite Nr. 7
Chapter 2 Connecting Peripherals ..... 23 2.1 Primary (CN6) and Secondary (CN7) IDE Connectors ........................................................... 24 2.2 Floppy Drive Connector (CN13).......................... 24 2.3 Parallel Port Connector (CN8) ............................ 25 2.4 Keyboard & PS/2 Mouse Connector (CN12) ...... 25 2.5 Serial Ports (CN9: COM1; CN10: COM2) ............ 26 2.6 Front Panel Connectors (CN2, CN3, CN4, J1 and J2)................................. 27 2.6.1 Keyboa
Inhaltszusammenfassung zur Seite Nr. 8
Chapter 3 Award BIOS Setup .............. 31 3.1 Introduction .......................................................... 32 3.2 Entering Setup ..................................................... 32 3.3 Standard CMOS Setup......................................... 32 3.4 BIOS Features Setup ........................................... 33 3.4.1 Virus Warning ............................................................................ 33 3.4.2 Quick Power On Self Test .............................
Inhaltszusammenfassung zur Seite Nr. 9
Appendix A Programming the Watchdog Timer ................................ 43 Programming the Watchdog Timer ............................ 44 Appendix B Pin Assignments ............. 47 B.1 COM1/COM2 RS-232 Serial Port (CN9,CN10) .... 48 B.2 Keyboard and Mouse Connnector (CN12) ......... 48 B.3 External Keyboard Connector (J10) ................... 48 B.4 ATX Feature Connector (J7) ............................... 49 B.5 IDE Hard Drive Connector (CN6, CN7) ............... 49 B.6 USB Connector (CN
Inhaltszusammenfassung zur Seite Nr. 10
x
Inhaltszusammenfassung zur Seite Nr. 11
1 Hardware Configuration This chapter gives background information on the PCA-6175. It then shows you how to configure the card to match your application and prepare it for installation into your PC. Sections include: • Card specifications • Board layout • Safety precautions • Jumper settings CHAPTER
Inhaltszusammenfassung zur Seite Nr. 12
1.1 Introduction The PCA-6175 industrial grade CPU card uses Intel's highly ® acclaimed Pentium II processor and Intel 440LX PCI chipset. The card works with standard ISA or PCI/ISA-bus passive backplanes. The CPU provides 512 KB on-chip L2 cache, eliminating the need for external SRAM chips. It has two PCI EIDE interfaces (for up to four devices), and an FDD interface (for up to two devices). Other features include two RS-232 serial ports (16C550 UARTs with 16-byte FIFO or compatible), one enha
Inhaltszusammenfassung zur Seite Nr. 13
1.2 Features • Intel slot 1architecture ® • Pentium II processor up to 333 MHz • Intel 82440LX PCIset • Three DIMM sockets for SDRAM up to 384 MB; supports ECC • Award Flash BIOS • On-board ATX power control connector to meet ACPI requirements • Two enhanced IDE ports, supporting Ultra DMA/33, PIO Mode 4 and DMA Mode 2 • Two USB ports • Two serial ports • One bidirectional parallel port, supports ECP/EPP/SPP • One floppy port and one keyboard/mouse port • PCI V2.1 compliant • PICMG 2.0 compliant
Inhaltszusammenfassung zur Seite Nr. 14
1.3 Specifications System ® • CPU: Intel Pentium II up to 333 MHz • BIOS: Award Flash BIOS • Green function: Supports power management operation via BIOS. Activated by keyboard or mouse activity • PCI enhanced IDE hard disk drive interface: Supports up to four IDE (AT bus) large hard disk drives (up to 8.4 GB), or other enhanced IDE devices. Supports PIO Mode 4 (16.67 MB/s data transfer rate) and Ultra DMA/33 (33 MB/s data transfer rate). BIOS enabled/disabled • Floppy disk drive interface: Supp
Inhaltszusammenfassung zur Seite Nr. 15
• Enhanced parallel port: Configurable to LPT1, LPT2, LPT3 or disabled. Standard DB-25 female connector provided. Supports EPP/ECP/SPP • Serial ports: Two RS-232 ports with 16C550 UARTs (or compatible) with 16-byte FIFO buffer. Supports speeds up to 115.2 Kbps. Ports can be individually configured to COM1, COM2 or disabled • Keyboard and PS/2 mouse connector: A 6-pin mini DIN connector is located on the mounting bracket for easy connection to a keyboard or PS/2 mouse. An on-board keyboard pin he
Inhaltszusammenfassung zur Seite Nr. 16
1.4 Board Layout: Main Features 6 PCA-6175 User's Manual ATX feature Intel 82440LX connector PCIset Accommodates three DIMM modules, up to EIDE Bi-directional 384 MB connectors parallel port FDD connector USB ports Metal bracket COM1 for stability COM2 Keyboard/ Mouse connector ® ® Intel Pentium II DiskOnChip 2000 processor up to 333 MHz Flash disk
Inhaltszusammenfassung zur Seite Nr. 17
1.5 Jumpers and Connectors Connectors on the PCA-6175 board link it to external devices such as hard disk drives and a keyboard. In addition, the board has a number of jumpers used to configure your system for your application. The tables below list the function of each of the board jumpers and connectors. Later sections in this chapter give instructions on setting jumpers. Chapter 2 gives instructions for connecting external devices to your card. Table 1-1: Jumpers Label Function J5 CPU core fr
Inhaltszusammenfassung zur Seite Nr. 18
Table 1-2: Connectors NumberFunction CN1 Infrared (IR) connector CN2 Keyboard lock CN3 External speaker CN4 IDE LED CN5 CPU fan connector CN6 Primary IDE connector CN7 Secondary IDE connector CN8 Parallel port CN9 Serial port: COM 1 CN10 Serial port: COM 2 CN11 USB port CN12 PS/2 keyboard and mouse CN13 Floppy drive connector CN14 (Reserved) J1 ATX soft power switch J2 Reset J3 External SMI J7 ATX feature connector J10 External keyboard connector RT1 (Reserved) 8 PCA-6175 User's Manual
Inhaltszusammenfassung zur Seite Nr. 19
1.6 Board Layout: Jumper Locations Figure 1-1: Board layout: jumper locations Chapter 1 Hardware Configuration 9
Inhaltszusammenfassung zur Seite Nr. 20
1.7 Board Layout: Connector Locations Figure 1-2: Board layout: connecter locations 10 PCA-6175 User's Manual
