Inhaltszusammenfassung zur Seite Nr. 1
Inhaltszusammenfassung zur Seite Nr. 2
© March 5, 2002 Maxtor Corporation. All rights reserved. Printed in U.S.A. This publication could include technical inaccuracies or typographical errors. Changes are periodically made to the information herein – which will be incorporated in revised editions of the publication. Maxtor may make changes or improvements in the product(s) described in this publication at any time and without notice. ® ® ® Maxtor , MaxFax and No Quibble Service are registered trademarks of Maxtor Corporation, regist
Inhaltszusammenfassung zur Seite Nr. 3
Corporate Headquarters: 510 Cottonwood Drive Milpitas, California 95035 Tel: 408-432-1700 Fax: 408-432-4510 Research and Development Center: 2452 Clover Basin Drive Longmont, Colorado 80503 Tel: 303-651-6000 Fax: 303-678-2165
Inhaltszusammenfassung zur Seite Nr. 4
Revision-A 2004052 All Initial Release March 5, 2002
Inhaltszusammenfassung zur Seite Nr. 5
Thank you for your interest in Maxtor hard disk drives. This manual provides technical information for OEM engineers and systems integrators regarding the installation and use of Maxtor hard drives. Drive repair should be performed only at an authorized repair center. For repair information, contact the Maxtor Customer Service Center at 800-2MAXTOR or 1-303-678-2015. CAUTION: Maxtor hard drives are precision products. Failure to follow these precautions and guidelines outlined here may lead
Inhaltszusammenfassung zur Seite Nr. 6
1.1 Maxtor Corporation .................................................................................................. 1-1 1.2 Manual Organization................................................................................................. 1-1 1.3 Abbreviations ............................................................................................................ 1-2 1.4 Conventions.......................................................
Inhaltszusammenfassung zur Seite Nr. 7
Table of Contents 4.1 Hard Drive Handling Precautions .............................................................................. 4-1 4.2 Electro-Static Discharge (ESD) .................................................................................. 4-1 4.3 Unpacking and Inspection ......................................................................................... 4-2 4.4 Repacking ...............................................................
Inhaltszusammenfassung zur Seite Nr. 8
Figure 2-1 PCBA Jumper Location and Configuration ................................................... 2-6 Figure 3-1 Outline and Mounting Dimensions .............................................................. 3-4 Figure 4-1 Multi-pack Shipping Container .................................................................... 4-3 Figure 4-2 Single Pack Shipping Container (Option A) ................................................. 4-4 Figure 4-3 Single Pack Shipping Container
Inhaltszusammenfassung zur Seite Nr. 9
( #)! ) ) $ ) Maxtor Corporation has been providing high-quality computer storage products since 1982. Along the way, we’ve seen many changes in data storage needs. Not long ago, only a handful of specific users needed more than a couple hundred megabytes of storage. Today, downloading from the Internet and CD-ROMs, multimedia, networking and advanced office applications are driving storage needs even higher. Even home PC applications need capacities m
Inhaltszusammenfassung zur Seite Nr. 10
Introduction ( # #)!0 / .. ATA AT attachment MB megabyte bpi bits per inch Mbits/sec megabits per second CHS cylinder - head - sector MB/sec megabytes per second db decibels MHz megahertz dBA decibels, A weighted ms millisecond DMA direct memory access MSB most significant bit ECC error correction code mV millivolts fci flux changes per inch ns nanoseconds G acceleration PIO programmed input/output GB gigabyte RPM revolutions per minute
Inhaltszusammenfassung zur Seite Nr. 11
Introduction ! " Signal names are shown in all uppercase type. All signals are either high active or low active signals. A dash character (-) at the end of a signal name indicates that the signal is low active. A low active signal is true when it is below ViL and is false when it is above ViH. A signal without a dash at the end indicates that the signal is high active. A high active signal is true when it is above ViH and is false when it is below ViL. When a signal is asserted,
Inhaltszusammenfassung zur Seite Nr. 12
Introduction 1-4 Maxtor D540X-4G
Inhaltszusammenfassung zur Seite Nr. 13
( ! #)01 # *1 ) " Maxtor hard disk drives are 1-inch high, 3.5-inch diameter random access storage devices which incorporate an on-board Ultra ATA/133 interface controller. High capacity is achieved by a balanced combination of high areal recording density and the latest data encoding and servo techniques. Maxtor's latest advancements in electronic packaging and integration methods have lowered the drive's power consumption and increased it
Inhaltszusammenfassung zur Seite Nr. 14
Product Description 9 Note: Maxtor defines 1 Gigabyte (GB) as 10 or 1,000,000,000 bytes of data. Total accessible capacity varies depending on operating environment. ( 0 * *1 )" # Maxtor hard drives contain all necessary mechanical and electronic parts to interpret control signals and commands from an AT-compatible host computer. See Chapter 3 Product Specifications, for complete drive specifications. & The disk capacity is increased with bit density managemen
Inhaltszusammenfassung zur Seite Nr. 15
Product Description - ! The Logical Block Address (LBA) mode can only be utilized in systems that support this form of translation. The cylinder, head and sector geometry of the drive, as presented to the host, differs from the actual physical geometry. The host AT computer may access a drive of set parameters: number of cylinders, heads and sectors per track, plus cylinder, head and sector addresses. However, the drive can’t use these host parameters directly because of zoned rec
Inhaltszusammenfassung zur Seite Nr. 16
Product Description ( 3! , ! 1 1 The data buffer is organized into two segments: the data buffer and the micro controller scratch pad. The data buffer is dynamically allocated for read and write data depending on the commands received. A variable number of read and write buffers may exist at the same time. ) 5 Normally, this mode is active. Following a read request, disk read-ahead begins on the first sector and continues sequentially until the allocated b
Inhaltszusammenfassung zur Seite Nr. 17
Product Description $ ! An integrated circuit mounted within the sealed head disk assembly (near the read/ write heads) provides up to eight head selection depending on the model. It also provides read pre-amplification and write drive circuitry. $ / ’ Low mass, low force giant magneto-resistive read/write heads record data on 3.5- inch diameter disks. Maxtor uses a sputtered thin film medium on all disks for Maxtor hard drives. All Maxtor hard d
Inhaltszusammenfassung zur Seite Nr. 18
Product Description ( ! #* 5) ,# )!30 .02 * ! Two drives may be accessed via a common interface cable, using the same range of I/O addresses. The drives have a jumper configuration as device 0 or 1 (Master/ Slave), and are selected by the drive select bit in the Device/Head register of the task file. All Task File registers are written in parallel to both drives. The interface processor on each drive decides whether a command written to it should be executed; this depen
Inhaltszusammenfassung zur Seite Nr. 19
Product Description 689 68; 68* 68> 68? (6 ’ # 7( 6*: 68< 68= 688 68, Master/Slave Only drive in single drive system* C Master drive in dual drive system* C Slave drive in dual drive system O Cable Select Disabled* O Enabled C Cylinder Limitation Disabled* O Enabled C Factory Reserved O O Key * = Default C = Closed (jumper installed) O = Open (no jumper installed) & ( # #)! 01 6*3 #3# ! #) 2+#!" On some older BIOS', primarily those that auto-configure the
Inhaltszusammenfassung zur Seite Nr. 20
Product Description 2-8 Maxtor D540X-4G
