Inhaltszusammenfassung zur Seite Nr. 1
IMPRESSA F50/F5/F505
Instructions for use
8/06
Art. Nr. 66381
Inhaltszusammenfassung zur Seite Nr. 2
Legend: DISPLAY: serves as information. DISPLAY: please follow the instructions shown. JURA Elektroapparate AG, CH-4626 Niederbuchsiten, = Note = Important = Tip Internet http://www.jura.com
Inhaltszusammenfassung zur Seite Nr. 3
Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5 Fig. 6 Fig. 7 Fig. 8 Fig. 9 Fig. 10 Fig. 11 Fig. 12 Fig. 13 Fig. 14 Fig. 15 Fig. 16 Fig.17
Inhaltszusammenfassung zur Seite Nr. 4
Control elements 11 22 1. Rotary Switch 2. Illuminated ring 13 3. ON/OFF key 4. Programming key 5. Draw-off key 1 cup Rotary Switch 6. Draw-off key 2 cups 12 7. Maintenance key 8. Steam pre-selection key 10 13 9. Display dialog system 8 7 6 5 3 4 9 10. Water tank with carrying handle 11. Filler funnel for pre-ground coffee: 2 14 12. Bean tank cover 1 13. Aroma preservation cover 15/16 14. Steam/hot water draw-off valve 15. Easy-Auto-Cappuccino Frother with milk pipe 16. Interchangeable hot water
Inhaltszusammenfassung zur Seite Nr. 5
Contents 1. Safety information..........................................page 6 15.1 Programming the filter ...........................page 15 1.1 Warning..............................................page 6 15.2 Programming the water hardness ..............page 15 1.2 Precautions..........................................page 6 15.3 Programming the aroma ROBUST 2. Preparing the IMPRESSA................................page 6 or STANDARD .....................................page 15 E 2.1 Check supp
Inhaltszusammenfassung zur Seite Nr. 6
Introduction 1.2 Precautions Never expose the coffee machine to weather (rain, snow, frost), Thank you for purchasing the IMPRESSA. To ensure perfect func- never touch the machine when your hands are wet. tioning of your IMPRESSA, carefully read this operating manual and keep it for future reference. Place the IMPRESSA on a firm, level base that is resistant to any water that may leak. Never stand on hot or warm surfaces Should you need more information or if you encounter particular (oven h
Inhaltszusammenfassung zur Seite Nr. 7
Open the bean tank cover (12) and remove the aroma preser- 2.3 Fill water tank vation cover (13). Only use fresh, cold water. Never fill in milk, mineral water To adjust the grinding degree, turn the Rotary Switch (Fig. 2) to or other liquids. the required position. Remove the water tank and rinse it with cold tap water thoroughly (Fig. 4). 2.6 Power switch E Then fill the water tank and reinstall it. Make sure to install the Actuate the power switch (21) on your IMPRESSA before tank p
Inhaltszusammenfassung zur Seite Nr. 8
The displayed information means the following: FILLING SYSTEM LEVEL –– Water hardness function switched off CLOSE TAP LEVEL 1 German water hardness degree 1 to 7° French Water hardness degree 1.79 – 12.53° Close the steam / hot water draw-off tap (14). LEVEL 2 German water hardness degree 8 to 15° HEATING French Water hardness degree 14.32 – 26.85° PRESS LEVEL 3 German water hardness degree 16 to 23° RINSE French Water hardness degree 28.64 – 41.14° Press the maintenance key (7). L
Inhaltszusammenfassung zur Seite Nr. 9
Close the steam/hot water draw-off tap (14), now the IM- 5. Installation of CLARIS plus filter cartridges PRESSA will heat up to coffee temperature. If the CLARIS plus filter cartridge is installed properly, de- HEATING scaling of the coffee machine is no longer required. For READY more information on the CLARIS plus filter cartridge refer to brochure «CLARIS plus. Hard on limescale. Gentle on Now you have activated the filter. In Programming Mode the your coffee machine.» E water hardness
Inhaltszusammenfassung zur Seite Nr. 10
Open the steam / hot water draw-off tap (14). Turn the Rotary Switch (1) until the required water quantity is displayed. HEATING For example, 120 ML READY 8. Drawing off 1 cup of coffee 6. Rinsing the IMPRESSA You have the possibility of increasing the strength of the When the IMPRESSA is switched off and has cooled down, coffee at any time in the grinding process by pressing the a rinsing operation is started when the machine is switched 1-cup draw-off key again on again. When the m
Inhaltszusammenfassung zur Seite Nr. 11
For Example: 160 ML 10. Drawing off pre-ground coffee For Example: MILD Never use instant coffee or quick-coffee. We recommend that you always use powder from fresh coffee beans or, pre- Your product is being prepared. ground, vacuum-packed coffee. Never fill in more than 2 READY portions of powder. The pre-ground coffee tank is no storage 9. Drawing off 2 cups of coffee tank. Make sure that the pre-ground you use is not too fine. E This may cause blocking of the system. In this case th
Inhaltszusammenfassung zur Seite Nr. 12
Close the steam / hot water draw-off tap (14). For Example: 210 ML READY POWDER Your product is being prepared. Before CLOSE TAP water may still escape the system. READY 11. Drawing off hot water 12. Drawing off steam If you do not change the settings using the Rotary Switch The steam function is used for the preparation of milk foam (1), the water quantity last adjusted will be drawn off auto- as well as for the Easy-Auto-Cappuccino Frother (15) clean- matically. ing programme. Inst
Inhaltszusammenfassung zur Seite Nr. 13
You can adjust the steam draw-off time individually by turning When using for the first time, remove the protective cover from the Rotary Switch (1) until the required SEC are displayed. the Easy-Auto-Cappuccino Frother (15) (Fig. 6). The protective cover is used only during transport as protection to prevent the For example, 35 SEC ingress of contaminated materials. If you do not change the steam draw-off time settings using the Remove the milk pipe from the Welcome Pack and connect i
Inhaltszusammenfassung zur Seite Nr. 14
During the steam draw-off operation, the message STEAM is Reassemble the Easy-Auto-Cappuccino Frother (15) and refit it displayed. on to your IMPRESSA. When the steam quantity is reached, the message CLOSE TAP is displayed. 13.3 Cleaning the Easy-Auto-Cappuccino Frother Close the steam / hot water draw-off tap (14). To ensure that the Easy-Auto-Cappuccino Frother(15) func- STEAM tions perfectly, you should clean it daily if you have prepared READY milk foam. At any time, you can stop d
Inhaltszusammenfassung zur Seite Nr. 15
As long as STEAM READY os on view in the display, the You can programme the following stages: machine is ready to dispense steam. Filter Water hardness Fill the container with 2.5 dl of fresh water. Aroma Dip the milk pipe into the container with the fresh water. Temperature Time E When READY appears in the display, press the steam prese- Automatic switch-on time lect key (8) again to set the machine in readiness for the Automatic switch-off time steam function. Draw-offs Lan
Inhaltszusammenfassung zur Seite Nr. 16
READY NORMAL Press programming key (4) until To confirm the new settings, press the Rotary Switch (1). FILTER appears. TEMPERATURE The illuminated ring (2) is active. Press the programming key (4) to quit the programming Turn the Rotary Switch (1) until Aroma is displayed. mode or select the next programming item using the Rotary Switch (1). AROMA READY Press the Rotary Switch (1). ROBUST 15.5 Programming the time Turn the Rotary Switch (1) until the following message
Inhaltszusammenfassung zur Seite Nr. 17
Press the programming key (4) to quit the programming Press the programming key (4) to quit the programming mode or select the next programming item using the Rotary mode or select the next programming item using the Rotary Switch (1). Switch (1). READY READY If the machine is disconnected from power supply, the time E 15.7 Programming the automatic switch-off time must be programmed again. You can programme your coffee machine such that it will switch off automatically after a certain t
Inhaltszusammenfassung zur Seite Nr. 18
15.8 Cup counter 15.9 Programming the language You can check how many cups of the following coffee products READY were drawn off: Press programming key (4) until a) 1 cup FILTER appears. b) 2 cups The illuminated ring (2) is active. c) Powder coffee Turn the Rotary Switch (1) until LANGUAGE is displayed. READY LANGUAGE Press programming key (4) until Now press the Rotary Switch (1) to start programming the item FILTER appears. LANGUAGE. The illuminated ring (2) is active. T
Inhaltszusammenfassung zur Seite Nr. 19
Press the Rotary Switch (1) 16. Maintenance e.g. 24H 16.1 Filling in water Select a setting of your choice. FILL Press the Rotary Switch (1) to save the setting. WATER DISPLAY E If this information is displayed, drawing off products is no Press the programming key (4) to quit the programming longer possible. Refill water as described in Chapter 2.3. mode or select the next programming item using the Rotary Switch (1). READY READY The water tank should be rinsed daily and refil
Inhaltszusammenfassung zur Seite Nr. 20
16.3 Drip tray missing READY CLEAN NO – TRAY 16.7 IMPRESSA decalcify If this information is displayed, the drip tray (20) is not installed properly or was not installed at all. During operation, the machine will calcify. The degree of scaling Insert the drip tray (20). depends on the hardness of the water in your region. The machine will inform you when de-scaling is required. You can still draw off READY coffee or hot water/steam. However, we recommend that you should de-scale the mac
